Question about 2000 Hyundai Sonata

1 Answer

Hyundai sonata 01 jerking slow take off high idling

Problem codes po715 and po765

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 776 Answers

P0715 = Input Shaft Speed Sensor Malfunction
P0765 = P0765 Overdrive solenoid valve problem
The Input shaft speed sensor is located on top of the trans (center) under the shifter cable (the shifter cable is connected to the transaxel range switch). The Overdrive Solenoid valve is located INSIDE the trans (oil pan must be removed to access it).Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jun 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Throttle body


Did you change the Idle air motor as well? It is sometimes possible to clean these.

Mar 12, 2016 | 2006 Hyundai Sonata

1 Answer

Still no answer...


go to napa and ask them

Jan 03, 2014 | Hyundai Sonata Cars & Trucks

1 Answer

I have a 2000 Hyundai Sonata that runs rough when you start it up. I hooked a code reader to it and it said that system was lean on bank 1 and multi misfire and not reading 02 sensor on bank one. I have...


time to get the engine properly scanned, real time not code scanner, then you will have the readings from sensore and actuators, diagnose from there

Dec 14, 2010 | Hyundai Motor 2004 Sonata

1 Answer

I've been having problems with my Hyundai Sonata 1999 with a 2.4L 4 cyl. Running rough when started. Have to push gas pedal to start or stalls after running for a few seconds.. Sluggish/jerky starts when...


could be a few things the start up could be the idle air control sensor (my first thought), the coolant temp sensor for the computer might be a secondary thought for the engine being cold if the computer thinks its warm. that would be the first 2 places i would start without a check engine light or code to reference

Jul 31, 2010 | Hyundai Sonata Cars & Trucks

1 Answer

2006 Hyundai Sonata: Wet road causes power steering failure


Ok, the high pitch sound is your idle pulley bearings going bad. The splash of water is exactly that, the belt gets wet and slips. Definitely a pully, more than likely the idler pully.

Sep 27, 2009 | 2006 Hyundai Sonata

1 Answer

2000 hyundai sonata.. P0300, P0110 and P0102 codes..


Higher octane gas 93 with some good octane boost in the black can at autozone cost about 7 dollars or a bottle of 104 octane boost. Change the fuel filter. Probably only one coil pack is bad. The OBDII reader should tell you which one was a misfire.

Jul 15, 2009 | Hyundai Motor 2004 Sonata

2 Answers

Hyundai Sonata 2002 idle at high RPM and accelerate 40-45 MPH


Look for a vacuum leak somewhere. This is the most common problem for a high idle.

Jun 23, 2009 | 2001 Hyundai Accent

2 Answers

2000 Hyundai Sonata jerking and causing poor performance


The turbine shaft speed sensor can cause this problem, It is also know as the transmission input shaft speed sensor. It will cause the transmission to **** and also stick in 3rd gear, which wound cause slow acceleration.

May 17, 2009 | 2000 Hyundai Sonata

1 Answer

Code p0335, and jerkinging problem with pending codes p02300 and p0711


THE INTERMITTENT SIGNAL FROM THE DEFECTIVE CRANK SENSOR IS CAUSING THE CAR TO STARVE OF SPARK AND FUEL. IF YOU REPLACE THE CRANK SENSOR, THIS WILL FIX THE JERKING PROBLEM BY HAVING A CONTINUOUS FLOW OF FUEL AND SPARK. THE TRANSMISSIONS ON THESE CARS ARE NOTORIOUS FOR SHIFTING PROBLEMS. THE TRANSMISSION MAY NEED A NEW FILTER AND FLUID. HOPE THIS HELPS. KEEP ME POSTED PLEASE. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

May 14, 2009 | 2000 Hyundai Sonata

Not finding what you are looking for?
2000 Hyundai Sonata Logo

1,072 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...