Question about 1993 Mazda 626

Open Question

Ford Telstar TX 5, 2.2L. Overheating

Where can i find the thermostat heating sensor. What can the problem be if electric fan is not working

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bigg t
  • 640 Answers

SOURCE: thermostat and heatung sensor

Follow the upper radiator hose and where it connects on the motor that housing is where the t-stat is and sensor.

Posted on May 28, 2008

Ad
dr_layinlow
  • 60 Answers

SOURCE: overheating problem

sounds like your heater core has gone bad!! Do you smell antifreeze when you run the heater??

Posted on Dec 10, 2008

chuck943
  • 783 Answers

SOURCE: My 2002 Ford Thunderbird is

You most likely have air in the system. These things can be a royal pain to get the air bleed out of the system.
Look back next to the brake booster and you will see a rubber tube with a screw cap in the end of it(this is the heater bleed), also on the front of the intake area you will see a black tube with an allen sloted cap.
Remove the slotted cap and screw the screw cc on the rubber tube. Add coolant to the coolant jug allowing the system to equalize until no more coolant can be added. Add as much coolant as possible to the engine fill( the sloted cap near intake). The heater air bleed will remain open.Replace the engine fill cap.Start the engine and turn the heater to MAX position.Close the heater air bleed when a steady stream of coolant comes from it, during engine idle. Allow the engine to idle for five minutes, add coolant to the degas bottle as needed to maintain the cold fill MAX mark.Reopen the heater air bleed to release any entrapped air and close again. Maintain engine speed of 2,000 rpm for 3-5 minutes or until hot air comes from the heater.Return to idle and verify hot air is still coming from the heater. Set the heater temperature setting to 75° F and allow the vehicle to idle for two minutes.Shut the engine off and allow to cool.After the engine has cooled, add coolant to the degas bottle to bring the level to the cold fill MAX mark. This should have the air out of the system.

Posted on Mar 02, 2009

  • 103 Answers

SOURCE: Overheating problem

With the sensor unplugged and the fan works,, replace the new sensor,,,,, it is probably defective. I have seeh this before.

Posted on Jul 28, 2009

  • 4875 Answers

SOURCE: Ford Mondeo Mk3 Estate 2L. Air bag / seat belt Warning Light

Common fault on FORD
Usually due to a poor connection in the YELLOW PLASTIC CONNECTOR underneath the passenger seat.


Just push it together properly and it should clear the AirBag fault


Posted on Sep 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 ford contour gauge shows running hot. Change both sensors near thermostat and the thermostat. Flushed system and burped it. Ac or heat makes no difference. Fans seems to be working. Any ideas?


Is it ACTUALLY overheating? Check for heat at the top and bottom radiator hoses, and at both heater core hoses. If one is cold then your radiator or your heater core may be plugged and in need of a individual flush.

Oct 29, 2013 | 1997 Ford Contour

1 Answer

2000 Ford Ranger. I have been having problems with my truck overheating. I changed the Thermostat but the truck still overheated when driving home yesterday.


If it has an electric fan a would replace the coolant temperature sensor.If it a mechanical fan i would replace the clutch on the fan.

Oct 26, 2012 | Ford Ranger Cars & Trucks

1 Answer

My 2003 dodge durango keeps overheating , i just had new radiator put in and it started overheating again but now it is overheating with a very loud screeching noise like a belt sound what could be ca


as for noise will have to inspect under hood,could be fan or belt or pulley ,water pump .these are some things it could...My suggestion for overheating is replace thermostat. If your car has electric cooling fan then it may not be working..turn defrost on and if fan kicks on then fan motor is good..Now this does not mean that fan is working properly because fan is controlled by heat sensor switch that kicks fan on when motor reaches heat range......Things i would have checked....hope this information helps and good luck and Please rate my post...

Aug 17, 2012 | 2003 Dodge Durango

1 Answer

1997 ford escort 2.0L engine is overheating. it has a radiator that is 3 yrs. old, a new head gasket, re-machine heads, water pump and timing belt that are 2 yrs. old, new thermostat and several radiator...


try this,wearing rubber gloves(cos its hot)undo the topmost hot hose clip and expell any air trapped.also use a hotwire to check
electric fan(s) if fitted.if they run it aint them.do they operate when idling and hot,if not then its the sensor.or if you have a viscous fan is that working.....when hot you will feel a resistance to turning by hand when the engine is stopped..another telltail that the thermostat is gone is,does the guage go down when you turn the fan on full heat for the interior??...cant think of anything else.....

Sep 15, 2010 | 1996 Ford Escort 4 Door

1 Answer

Car constantly overheating


if it has a viscous fan hub --replace it
if it has electric fans , check/ replace the coolant temperature sensor , fan relays or fan motors
have a compression test done to check for gasket or cracked head/s
over heating once a week is not constant so have the fault codes read to check for heated oxygen sensor problems altering the air / fuel mixture

Oct 04, 2017 | 2003 Mercury Mountaineer

2 Answers

I have the same problem too.


Hi I am Vortash it sounds like you have the same problem as i had over complicated heating controller on your car I have a Rover 75 and had the same problems .. The ecu controlled the fan and it failed causing my head gasket to blow .. check out this device on ebay I fitted it on my car and have had no further problems .. get your head checked for compression also as the overheating couuld have caused gasket problems causing the excessive overheating this is the item number on ebay 130314211224 hope this helps regards Vortash

Jun 25, 2009 | 1995 Ford Escort

2 Answers

Car overheats occasionally


When you drive, the cars foward movement forces air through the radiator keeping the engine temperature in check. When you are idling at a stop you need a fan to do this.There is a heat sensing unit either on the engine block or the inlet on the radiator that activates the electric fan.Sounds like it may be the electric fan or the control circuit/sensor.Ask a parts clerk at any of the parts outlets to show you a picture of the sensor and the location on the car. You may be able to short out the connector with a paper clip or wire.If the fan comes on the sensor is the problem. If it does't it will be the fan or the wiring.

Nov 28, 2008 | 1997 Ford Probe

2 Answers

2005 Nissan Sentra, AC blowing hot & engine overheating


most likely a thermostat because the pressure on the a\c will be high if engine is over heating or the fans are not kicking on (check fan relay)

Aug 25, 2008 | 2005 Nissan Sentra

2 Answers

Overheating


Electrical cooling fans not coming on due to bad sensor, fan relay, or bad fans. Check thermostat and coolant temperature, too....accordianman

Jun 02, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
1993 Mazda 626 Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...