Question about 1992 Nissan 240SX Fastback

1 Answer

My car engin dose not start,it is 1993 nissan bluebird ARX?

MYcar is Nissan bluebird 1993.engin number SR18(DE) 1838cc.Stater is fine, engin turnig,spark in the plug wire,and starts with a start liquid spray in air cleaner,when sprayed.has fuel as well, and how to test the fuel pump? dose it have one? where is it located?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

This def sounds like a fule pump issue should be located in the gas tank its self although i would check the fuses first before getting into the tank.
If this is in a 240sx the way into the tank is through the trunk.Lift the carpet and you will see on the mid right side a small 6-8" lid with some wires going into it. Unscrew that and your on your way in.
If you do pull out the pump just be careful handling it as to not break the sensor unit attached to the pump.

Posted on Aug 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What's your question? wat type of transmission oil does a nissan bluebird sr18 automatic use

I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure.
Best Manuals

May 30, 2016 | Nissan Cars & Trucks

1 Answer

Nissan Avenir Problem need Help

the is not likely to be a fuel pump problem, spark problem or any thing like that
Run the fault codes
I suspect that there is a problem either in the wire and harness connection to the injectors or the ECM control of the injectors
after you read the codes , try exchanging the ECM with a known good one to see if it starts as ECM is listed in many codes as a possible cause of the faults
as to the noise around the air injector pump , if it is not mechanical , there may be a code there for that as well

Nov 14, 2015 | Nissan Cars & Trucks

1 Answer

Where do I find the fuel filter in a 1994 Nissan Bluebird ARX

if you followed the line, and see no filter then........????
its in the tank.
not saying it is like newer car are here, by EPA dictates. log in, and read?
no one asks this, see why? the filter can not be in the cab.
so.. from engine to pump it is on all cars. a fast look and ahhhhhhhhh

Dec 24, 2014 | Nissan Cars & Trucks

1 Answer

Where is the starter motor for a 1994 nissan bluebird arx and is the solinoid attached to it

I don't know where it is but the solenoid will be on it for sure. It is there to pre engage the pinion before the electric motor starts spinning.

May 04, 2014 | Nissan Bluebird Cars & Trucks

1 Answer

Nissan bluebird arx

It should be under the hood near the fuse box it should have a snap on cover on it as well to keep debris out.

Dec 10, 2013 | Cars & Trucks

1 Answer

Why is my nissan bluebird arx 1991 jerking while driving

Have you ever done a really through tune up? This would be replacing the plugs, the distributor cap and rotor and the spark plug wires. you may have a misfire in the engine ignition system, misfiring plugs and wires tend to show up more after the engine gets hot.and resistance drops in the secondary ignition systems components.

Apr 06, 2012 | Cars & Trucks

1 Answer

Have a 1991 nissan bluebird with eu12 trans sr18 engine the trans out pulled starter motor off can not get to the flex plate bolts proply through the startermotor hole is there other way to get to them or...

you usually remove a semi circular plate attached to the bell housing near the sump then get to the torque converter bolts there. you need to have the transmission removed to get at the actual flex plate to crank bolts

May 27, 2011 | Nissan Maxima Cars & Trucks

1 Answer

My engine stalls (not all the time) when coming to a stop after driving in my 1993 nissan bluebird sr18 5 speed

It could be one of the following, clogged fuel injector,
Defective Mass airflow sensor.. .this would be the first thing i would check..
Is your check engine light on, this would help me better to diagnose your problem.

Dec 22, 2010 | 1993 Nissan Altima

Not finding what you are looking for?
1992 Nissan 240SX Fastback Logo

1,080 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

81342 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides