1999 Mercedes-Benz c280 starter lockout relay

SOURCE: c280 radio code

I Need Radio Code 4 My 98 C280 PLZ HELP!! mail [email protected]
radio code wdbha28e9sf241114

SOURCE: My air conditioner won't blow cold air. It just blows air.

Hello I'm a M.B. tech. 1st you need to know why the freon is low. Hopefully it just needs to be serviced. There is a component located in the lf of the engine compartment called a receiver drier. It soaks up the moisture in the freon so the gases can work the way they are supposed to. On this unit there should be 2 switches(I believe they were combined into one switch in 98. 1 switch is a temp switch that operates your electric fans, the other is a compressor cutoff switch. Assuming the compressor is not coming on-take a fused wire and bridge the 2 contacts- If the compressor does not come on at all there is another problem(it is not low on freon. On the condenser there is a high side port(it is the bigger of the 2)By the brake master Cyl.(lf of the engine compartment thereshould be a smaller low side valve in line with the fuel cooler hose. Usually you can hook up a machine to the low port and **** freon in through that port. Assuming you do not have a refrigerant machine. It is very self explanatory on the bottle of r 134a refrigerant which can be purchased at your local auto supply store. I would start with 1 lbs. and add dye with the freon in case there is a big leak. If the system is overcharged it will not cool properly. I believe the system capacity is approx. 2 lbs. Add a few ounces after the first pound until a/c system is cooling properly and the electric fans are also coming on when the system gets to high. If you get a can with a good Gage set on it you should see the high side between 150 and 2000 psi(fan coming on at max. press.) also the low side should read about 35. It is about the temp of the evaporator which is i=located in the dash and the blower blows through this component out through the vents. Hopefully I have been helpful.

mx5turbo92

• 545 Answers
• Posted on Dec 17, 2009

SOURCE: i need the mercedes benz 1999 clk 430 radio code

AR82.60-P-7502-01A Coding Radio
(MODEL all with CODE (750) Radio Becker Europa 2000 with CODE (751) Radio Becker Grand Prix 2000 with RDS)

1. If the radio is disconnected from the power supply, it is not operational when re-connected. After switching on the ignition and the radio, the readout CODE appears in the display.
2. The code number for the radio is advised to you on the enclosed CODE CARD.
3. To enter the first digit of the code number, you have to continue pressing station button 1 until the correct digit appears in the display. Adopt the same procedure for the second, third and fourth digits.
4. Once you have entered the correct code number with the station buttons 1, 2, 3, 4 and confirmed the entry with the SEEK button (press down), the readout CODE disappears. The radio can now be operated.
5. If you enter a wrong code three times, you must wait 15 minutes before making a new entry. In addition, if 9 incorrect entries are made, the radio will then not operate for 24 hours. During this time the radio and the ignition (terminal 15) must remain switched on.

1. If the radio is disconnected from the power supply, it cannot be operated by simply reconnecting. After switching on the ignition and the radio the word "CODE" appears in the display on the radio.
2. The code number for the radio is given on the enclosed CODE CARD.
3. Enter the code number with the station button, e.g. number 1, station button 1. After entering the first number the word "CODE" disappears and the number entered appears followed by 4 dashes. The next character to be entered flashes. After entering all five numbers, the first character starts flashing again. In this state the code number can be written over as frequently as desired. A correction can be made only by entering the complete code number again.
4. Confirm code number: Press TUNE, AUTO/SEEK or SC button. The radio automatically switches on and indicates the radio station or frequency stored with station button 1.
5. If an incorrect code number is entered and confirmed, the word "CODE" appears again on the display. If an incorrect code is entered three times the word "WAIT" appears on the display and the radio locks up for approx. 10 min. If the code is entered incorrectly three times again the radio locks up again for 10 min. Three more incorrect entries (a total of 9 incorrect attempts) increase the lock-up time to 60 min. Another three incorrect entries lock up the radio for another 60 min. The waiting time runs only when the radio is switched on.

SOURCE: i have a 1995 c280 mercedes benz i need a diagram

Here you go. Please let me know if it helps.

http://0.tqn.com/d/autorepair/1/0/4/P/mb_air_pump-1_256b.gif

Colin Stickland

• 22516 Answers
• Posted on Sep 15, 2011

SOURCE: Hi Where is located the fuse

end of the dash when you open the door its visable behind a panel i have uploaded some pics for you but they will have to be censored first

Testimonial: "Thank you for your answer !!! Waiting for the pictures "