Question about 1984 Chevrolet S-10

1 Answer

Need a photo on where the emission lines run.

Tried to fix something and rushed i dont know where all these emission lines go to and my 1984 2.8l s10 wont stay running. My fault but lesson learned so can someone please help. thanx

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 353 Answers

Check the hood if not find one and take a picture

Posted on Jun 20, 2009

  • gerald darling
    gerald darling Jun 20, 2009

    check the hood if not find one and take a picture



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to fix the timing on the distributor in a 1984 bronco 2?

I doubt its the timing.
What you describe sounds more like a lack of fuel problem.
Fuel pressure, throttle position sensor, or something else.
To actually check the timing you put the ignition in test mode and use a timing light on #1 cylinder.

Jul 24, 2012 | 1984 Ford Bronco II

1 Answer

I have a 87 ford f150 with a 351 an it will start if you pump the gas a lil but wont stay runing on its own i try to replace the vac lines but i wanting to know what is the main that i need to hook up i...

the only vacume lines you will really want to keep are the ones for the power brake booster, the vacume line to the distributer the vacume line or lines going into the firewall cause they may go to your heater controls and other then that you can take the rest off and plug any leaks there are then if she still wont stay running you need to do a major tune up with all the fixings.

Feb 14, 2011 | 1987 Ford F 150

3 Answers

Need vaccum hose diagram for 1984 nissan pick up, hoses are bad and need to be replaced

Check this diagrams....


Fig. 9: Emission control system vacuum diagram-1984 Z20 (49 States & Canada)


Fig. 10: Emission control system vacuum diagram-1984 Z24 (49 States & Canada except High Altitude)


Fig. 11: Emission control system vacuum diagram-1984 Z24 (49 States High Altitude)


Fig. 12: Emission control system vacuum diagram-1984 (Calif. w/MT)


Fig. 13: Emission control system vacuum diagram-1984 (Calif. w/MT)

Hope helps (remember rated this).

Jul 22, 2010 | 1984 Nissan Pickup

2 Answers

Car wont idle and when it does it jumps pretty bad ie(1000-2500)

Well mazda rotory engines run alot hotter exhaust if it has the wrong exhaust on it it might not be breathing correctly and then it will not run properly.

Apr 23, 2010 | 1984 Mazda RX-7

1 Answer

Puting vac hoses back on and carberater on a 1984

The engine and emission control system covered by this information operate on a combination of vacuum and electrical signals; they are extremely prone to malfunctions due to improper vacuum connections. If a component does not receive vacuum at the correct time, it cannot function when needed. When working under the hood, pay close attention to the routing and placement of every hose.


Fig. 1: The vacuum hoses are usually numbered for easy identification


Fig. 2: Vacuum hose routing-1984-85 carbureted Prelude


Fig. 47: Emission component schematic-1984-85 carbureted Prelude

Hope this helped; TY for using Fixya (remember comment and rated this).

Apr 01, 2010 | 1984 Honda Prelude

1 Answer

1984 dodge w-150 a/t starts and runs good go down the road and it hardly wants to run sputtering do 3 mph replaced everything cap,rotor,plugs,wires,pcv valve,air cleaner,fuel filter,ballest risistor dont...

it sounds like the its not getting enough gas to stay running. try looking for vacum leaks with a propane torch going over all the vacum lines with the FLAME OUT but the troch on when it is idling. if the idle goes up at any time when the torch passes over a line than you have found your leak and replace the line. even if you have one line bad keep going over all of them. and if there is no vacum leaks than start the engine and let it idle for about ten minutes, shut the engine off and take all the plugs out. if any of them are wet with gas than you have a spark problem and then begin going over your cap, rotor, wires, and points.

Nov 29, 2009 | 1984 Dodge Ramcharger

2 Answers

Wont pass emissions, repaced cap and rotor, full

Try looking into HHO generators. Sounds crazy ,I know, but just check them out on YOUTUBE and you'll be amazed at what they'll do for emissions, and if you're handy enough you could build one yourself.

Aug 27, 2009 | 1984 Ford F 250

1 Answer

1984 S10 carb 2.8L

No on something that old... as long as your Carb is tuned right... your emissions will stay down and you will likely see some better performance!

Apr 18, 2009 | 1984 Chevrolet S-10

1 Answer

1984 Toyota Corolla Timing Problem

Do to federal regulations,emissions have to be keep at minimum.Modern cars have a computer that's sets the firing timing to control this. If your rpms are ok, then don't pay attention to it.

Feb 16, 2009 | 1984 Toyota Corolla

3 Answers

Emission control hose routing

On line. Google 'emissions vacuum routing', you should be able to get an accurate diagram

Mar 18, 2017 | 1984 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides