Question about 1998 Isuzu Trooper

2 Answers

I am having problems replacing starter on my isuzu trooper....can't remove it, unscrewed but stuck

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

  • Contributor
  • 5 Answers

After you get all the bolts loose and removed from the starter,disconnect batt cable and wires from solenoid. After all wires and cables are removed, turn the starter 180 degrees and remove it backwards. When you re-install the starter, do it in reverse order the way it came out. Once the starter is in position then turn 180 degrees around to line up the bolt holes. Connect cable and wires accordingly.

Posted on May 05, 2012

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

May be stuck on dial pins.

Posted on Jun 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2000 Isuzu trooper won't start. Turn the key and get a click but no engine start. Could it be that the celenoid is stuck?

Are the battery an cables good ? Check the starter electrical circuit , voltage drop testing ! Why pull the starter , until you have to ! Starter Voltage Drop test the circuit before you pull the starter !

May 08, 2014 | 2000 Isuzu Trooper

1 Answer

How do I change a starter?

Removing the front exhaust pipe from the engine will give you the necessary space to replace the starter motor on your Isuzu Trooper.
Click this link to get more details:---- --------------------- This should help.Thanks.Helpmech.

Feb 26, 2011 | 1998 Isuzu Trooper

1 Answer

Need to replace starter

I recommend you get the Haynes repair manual on your vehicle. Start by removing the negative battery terminal, then removing the retaining bolts from the starter followed by removing the wires from the starter. Reverse the process to put the new starter on.

Jul 12, 2010 | 1988 Isuzu Trooper 2 Door

2 Answers

Isuzu Trooper Starter Replacement

most techs can replace it within 30 minutes or less

Feb 06, 2010 | 2001 Isuzu Trooper

1 Answer

Replacement of starter on 1994 isuzu trooper

Remove the positive battery cable first.
The starter is on the passenger side of the engine. Might be easier to get to from below. Remove the bolts holding the wiring to it than the bolts that mount the starter in place.
Be careful if it has shims that you make sure you put them back in the same way. (These are little thin spacers that go between the mounting surface and the starter).
Installation is reverse. Probably would take you no more than 30 minutes to do it all.

Oct 17, 2009 | 1994 Isuzu Trooper

1 Answer

How do you remove the starter from a 1994 Isuzu Trooper?

Unscrew and disconect the wires. Unscrew and remove the 2-17mm bolt's. Their is a small stud which holds the starter in place leave it to last unscrew it and thats it.

Aug 13, 2009 | 1994 Isuzu Trooper

1 Answer

How to replace a starter for the Issuz 1998

first you have to disconnect the battery, then disconnect the wiring in starter after that yu unscrew the mounting bolt turning counter clockwise. Remove the stater pulling it slowly, then fix the new one screw all nuts back. then reconnect all connection including battery . its done.

Jun 07, 2009 | 1998 Isuzu Trooper

1 Answer

Starter problems?

I just had to replace the starter on mine and you have to cut the exhaust pipe off to remove the starter. Take the 3 nuts off where the exhaust is attached to the manifold then using a sawzall I cut it in the straight section after the bend so it could sleeved and welded back with ease, once the pipe is out of the way the starter will just about fall out. Bad design by Isuzu. Perhaps some sort of pay back if you know what I mean.

Jun 07, 2009 | 1998 Isuzu Trooper

2 Answers

Starter removal - 1994 Isuzu Trooper

pull the starter away from the bellhousing and turn the drive end upwards then it will come out from the engine compartment tight i know but i have just done mine so i know it will come

Mar 18, 2009 | 1994 Isuzu Trooper

2 Answers

2000 Isuzu Trooper


Aug 28, 2008 | 2000 Isuzu Trooper

Not finding what you are looking for?
1998 Isuzu Trooper Logo

229 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14423 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides