Question about 1986 Oldsmobile Cutlass Supreme

Open Question

Trying to replace the speedometer cable..

Where is the oldsmobile cutlas supreme speedometer cable. trying to replace it and see too many cable hanging under the car to know which one it is

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
blueextc3221
  • 15935 Answers

SOURCE: replacing water pump on a 94 cutlas supreme instructions


REMOVAL & INSTALLATION


CAUTION When draining the coolant, keep in mind that cats and dogs are attracted by ethylene glycol antifreeze, and are quite likely to drink any that is left in an uncovered container or inPuddles on the ground. This will prove fatal in sufficient quantity. Always drain the coolant into a sealable container. Coolant should be reused unless it is contaminated or several years old.
2.2L Engine

  1. Disconnect the negative battery cable.
  2. Properly drain the engine coolant into a suitable container.
  3. Remove the serpentine drive belt, as outlined in of this repair guide.
  4. Unfasten the water pump pulley bolts, then remove the pulley.
  5. Remove the alternator and side bracket.
  6. Disconnect the water pump hoses.
  7. Unfasten the water pump retaining bolts, then remove the water pump from the vehicle. Remove and discard the gasket. Thoroughly clean all gasket mating surfaces.

To install:
  1. Position a new water pump gasket, then install the water pump. Tighten the attaching bolts to 18 ft. lbs. (25 Nm).
  2. Install the water pump pulley and secure with the retaining bolts. Tighten the bolts to 22 ft. lbs. (30 Nm).
  3. Attach the water pump hoses.
  4. Install the alternator bracket and the alternator.
  5. Install the serpentine drive belt.
  6. Properly refill the engine cooling system using the correct type and amount of coolant.
  7. Connect the negative battery cable.
6b49937.jpg

Posted on Apr 05, 2009

Ad
  • 1 Answer

SOURCE: can't get piston to push back into caliper on 1995

You have to turn (rotate) the piston to get it to go back. A c-clamp will not work and it may damage the piston. I have a 1995 and I just replaced the pads on the rear this past summer. I did what you did and tried the c-clamp and it didn't work. I then read up on it and you have to turn the piston. I did this with some needle-nosed pliers and put them into the valleys on the piston to turn it. I can't remember which direction I turned the piston. I think it was clockwise, but I am not sure.

Posted on Nov 11, 2009

Molson02536
  • 3854 Answers

SOURCE: coolant in the oil. Head gasket replacement 3.1 l

Check to see if it may be the intake gasket first, if it is that's good and replace it with the brass gaskets. They last a lift time, and you can buy them at any GM parts department. Good luck

Posted on Nov 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1987 oldsmobile cutlas supreme fuses,car want start


Car no start problem is sometimes very difficult to confirm. You try all the possible things, but still you get no fault and problem is still the same.--------
In that case, you need to check few things individually.
Check the spark,the battery,the crank, the fuel and other most possible parts. Click this link below for more details:-- http://howtobyme.blogspot.com/2011/10/car-troubleshooting-tips.html

Oct 20, 2011 | 1986 Oldsmobile Cutlass Supreme

1 Answer

The speedometer on my 89 cutlass supreme is off by 10 to 20 mph. Going 30 speedometer states 45. 60 states 80 and so on. The cruise control will not work either. Already tried the vehicle speed sensor on...


If one exists, check the cable going from the tranny to the back of your dashboard. The gauge cluster might be going bad, or if you don't have stock rims/tires, that will definitely cause it.

Sep 25, 2010 | 1989 Oldsmobile Cutlass Supreme

2 Answers

1991 cutlass supreme, 3.1 motor. all guages work except speedo.no reading.


check your speed sensor. may be faulty, is locate it on transmission.

Sep 15, 2010 | 1991 Oldsmobile Cutlass Supreme

1 Answer

How do you remove the dash to get to the speedometer cable in a 1984 oldsmobile cutlass supreme brougham


you just need to remove the panel under the drivers side of the dash, a few screws, then reach up behind the dash and uncilp the cable.

Aug 30, 2009 | 1983 Oldsmobile Cutlass Supreme

1 Answer

How much will it cost to fix my door handle on my 1996 cutlas sup


Sir,
25 to 35$.
click this link for more info

Thanks Good Luck
Appreciate to rate as "Fixya"

Mar 12, 2009 | 1996 Oldsmobile Cutlass Supreme Coupe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...