Question about 1996 Hyundai Accent

1 Answer

Where is the throttle cable located on a1996 hyundai accent?

How do you adjust it.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 776 Answers

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyundai accent 2004 idle problem


Throttle position sensor could be the problem
Emmission control parts
You mentioned idler cable
Well there may be a second idler control cable
Some vehicles come with a double cable adjustment
The second adjustment is right above the gas pedal
Turning screw
Alternator giving out not producing charge needed
But overall if your cars idle bogs down the likely culprit is your ac bout to go out
The bearings in compressor wear out so it pulls more on the engine
In turn bringing rpm's down
Your car needs routine maintenance
Ac is an expensive repair so i suggest bypass belt till you can pay to have it fixed

Jan 07, 2015 | Hyundai Motor 2004 Accent

1 Answer

Hyundai accent low rpm on take off and littile back fire low speed


Hi,
I believe your accent is the world cup edition.
please check the following suggested areas;
engine valve timing, ignition plugs,coils and cables, air flow throttle, actuators and hoses, etc.
I believe you will find a solution

Ngosa

Dec 08, 2013 | Cars & Trucks

1 Answer

How to install throttle position sensor in 2000 hyundai accent


Removal & Installation
  1. Disconnect the negative battery cable.
  2. Disconnect the sensor connector.
  3. Remove the sensor retaining screws. Remove the sensor from its mounting.

To install:

  1. Installation is the reverse of the removal procedure.
tps is located on throttle body across from accelerator cable make sure to mark the angle with a punch or mark so when install new one it will be in the same position
'
hope this helps
plz vote comment or reply if need more help

Jan 18, 2011 | 2000 Hyundai Accent

1 Answer

How does one adjust the handbrake cable on a 2002 Hyundai Accent?


Usualy done under the car on the cable . Get a flashlight and follow the cable and you will come across a place to tighten the cable. Pretty easy!

Sep 17, 2010 | 2000 Hyundai Accent

1 Answer

To change gears, I need to fully press down on my clutch pedal to stop a grinding noise on my hyundai accent 2001Can I adjust the clutch cable,


Hi and welcome to FixYa,

In a manual 2001 Hyundai Accent, the clutch cable could be adjusted. The adjustment point is on the cable 'pad' where it enters the firewall in the engine compartment.
86c2d7d.jpg
To adjust, the slack or free play must be decreased. This is done by turning the adjusting nut clockwise. Check back by pressing on the clutch pedal to your preference.
73309c3.jpg
Good luck and thank you for using FixYa.

Feb 18, 2009 | Hyundai Motor 1995 Accent

2 Answers

99 hyundai accent starts sometimes. not battery


ok when the check engine light comes on that usually indicates a engine malfunction...what you can do is go to your local autozone and they can do an OBDII test for free..my bet says it is the cam or crank sensor.. DO NOT SHUT THE CAR OFF AT AUTOZONE..LOL

Jan 01, 2009 | 1999 Hyundai Accent

1 Answer

Hyundai accent high revving during gear change


you may have a problem with the idle sensor located near the fuel injection system.

Oct 29, 2008 | 2000 Hyundai Accent

1 Answer

Vehicle **** while accerate


throttle position sensor is most likely the problem

Aug 27, 2008 | 2005 Hyundai Accent

Not finding what you are looking for?
1996 Hyundai Accent Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...