Question about 2000 Mazda Protege

1 Answer

Locating the blower motor moter resister, and replacing it.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 15 Answers

Notes

  1. Disconnect the negative battery cable.
  2. Remove the glove compartment.
locating the blower motor moter resister - e02a56e.gif


  1. Remove in the order indicated in the table.
  2. Install in the reverse order of removal.

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 kia spectra blower only blows 1 & 4 speeds


Could be the blower motor resister,it's located by blower motor,2 screws hold it on,easy to remove,click here to see part.

Dec 30, 2012 | 2005 Kia Spectra

1 Answer

Heater fan moter good put new switch in and fan doesn,t work


Could be the blower motor resister,it's located by blower motor,2 screw hold it on.Here's what it looks like.

Dec 03, 2012 | 1990 Toyota Pickup

1 Answer

I posted a Question and forgot to say what kind of car I had so I am trying it again here it's a Hyundai Santa Fe 2004 I Had Smoke from the Right side just under the glove box with some noise I...


it sounds like a blower motor resister burnt out an not the blower motor...the job does require some skills since the resister is located under the dash board on the passenger side inside the blower motor housing

Jul 16, 2011 | 2004 Hyundai Santa Fe

2 Answers

How do you fix a fan speed control that only works on speeds 3, 4, and 5?


replace blower motor resister this can be found not far from blower moter usally

Dec 14, 2010 | Pontiac Grand Am Cars & Trucks

1 Answer

Ac and heater wouldn't operate on #5 setting for a while then now blower stopped all together


Most likely cause is a blower motor resister, you will need to know if it is a 2 or 4 hole blower moter resister. If that don't fix the problem then change out the blower motor.

Nov 02, 2010 | GMC Sierra Cars & Trucks

1 Answer

Wher is the blower moter resister located on a 1998 lincoln navigato


it is usually right next to the blower motor, a thick wire runs to it , then to the blower

Oct 27, 2010 | 1998 Lincoln Navigator

2 Answers

My dodge dakota blower moter only runs on high all other setting don't work. whar could it be? And if it is the resister where is it located?


the high blower relay controls the high blower only
you need a new blower motor switch you control on the dash

Feb 27, 2010 | 2004 Dodge Dakota

1 Answer

Blower moter on heater does not work


Aside from the obvious fuse or relay in power supply, it could be the blower switch, resistor pack usually located in heater box that contols speed, or the blower motor itself. Unplug wires to blower and measure batt. voltage with switch on. If voltage present, use ohmmeter to test blower resistance. No resistance, motor burned out. Check wiring for a cut/brake in circuit.

Oct 07, 2009 | 1986 Chevrolet K1500

1 Answer

AC drained into blower motor...replaced moter and now wont work


Did you check the blower motor before installation?Check for a blown fuse,and a bad relay,also check the blower motor resister.I hope this was some help.

Oct 05, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Blower motor 94 dodge intrepid inop


1.disconect battery
2. remove lower right undre panel silencer duct
3. remove the blower moter connector from the resistor block
4. squeeze the blower moter wiring gromment and push the gromment throw the blower moter housing cover
5. remove blower moter housing
6.romove the screws holding the blower moter down
to put back on do the steps back werds

Jan 03, 2009 | 1994 Dodge Intrepid

Not finding what you are looking for?
2000 Mazda Protege Logo

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...