Question about 2008 Pontiac G5

2 Answers

TAIL BRAKE LIGHTS NOT WORKING 3RD CENTER LIGHT WORKS - CANT FIND FUSE TO CHECK

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

When the car is not running, only the third brake light works. (had the same issue)

Posted on Jun 17, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 299 Answers

Check under hood jucktion block.Some gm models now using cicuit board logic and seperate the circuitd this way.can ussually bump jucktion block with hand or fist and they will work temporarily.

Posted on Jun 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brakes lights stopped working


Check stop lamp fuse 1st, possible failed stop lamp/brake switch.

Jan 10, 2014 | Ford Ranger Cars & Trucks

1 Answer

Brake lights don't work but 3rd stopping light does


it should be easy, first check all the fuses, if that dont work remove the tail lights and check the wiring it may have broken wires or blown bulbs

Jul 18, 2012 | 2003 Chevrolet Impala

2 Answers

Center brake light working but neither tail light brakes working both bulbs good


the center and brake light are not on the same circuit, check voltage coming from the switch

Mar 28, 2011 | 2001 Dodge Durango

1 Answer

I recently replaced the front rotors, brake pads and master cylinder in my 2003 Durango. I've since discovered that the brake lights are not working, including the 3rd brake light in the tailgate. I...


Hello, Well there is not much more it could be unless you have a shorted wire or a burned fuse. I would normally think that the turn signal canceler was bad but the 3rd brake light will still work if that is bad so I would check all fuses and for bare or shorted wires.

Jan 18, 2011 | 2003 Dodge Durango

1 Answer

Brake light dont work. 2006 chevy truck, 4.8L 2wd


Some of these had two fuses for brake lights. One for the top/center stop lamp and another for the rear left and right brake lights. Usually one said "stop" and the other said "brake" and one was in the underhood panel while the other was in the dash fuse panel. It's not uncommon to blow a brake light fuse [LR and RR] if you tow a trailer but some of these had seperate fuses for the trailer lights also. If you have a test light check both sides of the two fuses for power [ignition key on] while stepping on the brakes. It should at lest narrow your search a bit.

Jun 08, 2010 | 2006 Chevrolet Silverado 1500 2WD

1 Answer

Brake lights don't work, one in back window works but ones on tail lights don't checked bulbs and fuses and they are okay


I would check the wiring to the 2 side lights, and make sure they are grounded or none has been cut or corroded. You have good power going to the rear if the 3rd brake lite is working fine so I would trace the wire from the 3rd brake light to where it splits and goes to the 2 rear brake lights...

Nov 05, 2009 | 2001 Chevrolet Malibu

1 Answer

1997 monte carlo. 3rd brake light works, but tail lamp brake lights do not.


The 3rd brake light working does reveal that the fuse is good, and the brake switch is good. Check the bulbs, sockets, and the wiring between the brake lights

Jul 04, 2009 | 1997 Chevrolet Monte Carlo

2 Answers

Right brake light out; tail light works fine


most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine

Mar 31, 2009 | 2006 Dodge Stratus

Not finding what you are looking for?
Cars & Trucks Logo

251 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...