Question about 2000 Isuzu Rodeo

1 Answer

Engine stalling I have a rodeo 2000 4 cyclinder 2.2L (manual/standard), some times the engine stalls when reving at 1000 to 2000 rpm, a mechanic told me it was a fuel pump and another told me it could be the spark plugs and wires. Which one could it be or is it normal? i just got the vehicle. Thank you very much.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,623 Answers

Have a diagnostic scan run with freeze frame and capture mode. This way when your RPM reaches the point the problem occurs it will be 'captured; and saved on the scanner. From that information the proper repair procedures can be determined...otherwise it's just a guessing game.
Good luck...i hope this helps.

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2000 Isuzu rodeo dies when you hit bump starts back immediately


Is it setting any fault code in the Powertrain computer?

Oct 07, 2016 | 2000 Isuzu Rodeo

1 Answer

How to check the idle speed? my car stalls at the light


Hello Patricia Kennedy.

Besides a dirty air filter... listed below... idle air control valve... the idle speed is pretty tamper proof...

If the car has not been tuned up RECENTLY... that would be a STRONG recommendation before fine-tuning the idle speed.

The problem I am seeing ALL OVER the web... is the idle is too fast... (absolutely will cause STALLS).

All things being reasonable... your tachometer should show an RPM OF 650 to 1000 rpm... above that is quite EXCESSIVE...

A real TUNE-UP MANUAL would be required to properly set the SPEED ... but only after EVERYTHING had been serviced, cleaned and replaced...

Tuning up a car with DIRTY FILTERS & WORN spark plugs is an WASTE of MONEY!!

What I am seeing EVERYWHERE... is a HIGH IDLE problem... (above 2000 RPMs... That will ABSOLUTELY cause your car to stall at a STOP... because your TORQUE CONVERTER is designed to lock up (quit acting like a clutch)...

If your idle speed it above 1000 rpm... that WAS a BIG RECALL issue for GM engines...

Check out the links below... a high idle can stall an engine better than a low one...!!

Comment me back if I am not being particularly clear... or wwatch some of the videos I have attached.

Good luck.


More Information for ACDELCO A1208C
2005 buick rendezvous idle setting Bing video More Information for STANDARD MOTOR PRODUCTS AC5T

Mar 29, 2016 | 2005 Buick Rendezvous

3 Answers

2002 Isuzu rodeo stop while driving wont start


Need more information. Could be fuel pump, fuel filter, crank sensor, cam sensor. Starter??

Oct 16, 2014 | 2002 Isuzu Rodeo

1 Answer

Car will not move 2000 acura 3.2


ok you crank the engine over, it starts,
it can rev. to 3000 rpm for 1 second in park ?
y/n?
you then select, all gears forward and reverse and car can not move on flat ground, all brakes off?
can you push car in neutral on flat ground, , y/n ?

if no, brakes are bad. (or something more serious , ask)
if yes, tranny is dead (but....)

the if RPM rises, on engine (right foot action) and car MPH is 0
and rpm keeps rising that is a bad tranny (called slip or flare) in "D"
if you set the brakes hard,
and do the A/T stall test. (read the FSM)
and the RPM is way low that is a bad engine. (weak engine power)

if the RPM is good, stall tested. the engine and tranny are working. ( brakes stuck or frozen in ice?)
if the RPM flares, at stall test. it's a bad tranny
do the stall test for 5 sec max. rest for 15min and repeat.
STALL, test, makes tons of ATF heat. and heats the TC big time
RTM, it's all there. See FSM and read the manual.

Nov 23, 2013 | 2000 Acura TL

1 Answer

My 2003 Tiburon GT V6 5spd has been intermittantly hestitating and missing while at a contant speed and even stalling out from time to time. Also, the engine revs high at 2000 rpm then back down to 1000...


have you changed your fuel filter in the last year or so, if not. do it. a plugged up fuel filter will cause a lot of issues also. it can cause stalls, hesitation and stumbling.

May 08, 2010 | 2003 Hyundai Tiburon

1 Answer

2000 Isuzu Rodeo ls V6 4 wheel dr.


Check the fuel pressure it could be the fuel pump or pressure regulator.

Apr 28, 2010 | 2002 Isuzu Rodeo Sport

2 Answers

Unsteady idle rpm


the timing is problably off. you need a timing light and you need to get the correct specs and time it accordingly

Dec 20, 2009 | 1988 Oldsmobile Cutlass Ciera

1 Answer

I have an 89 Honda Accord lx and it idles too low


The idle speed for my 88 accord lx is 700-850 rpm for standard idle speed. The stalling is a seperate issue. When were plugs, wires, air/gas filters and distributor last checked? How long has engine been running for when you stall? Is the temprature gauge high? Any lights coming on when stall occurs? I am not a mechanic, but a DYI'er. These are common questions I am always asked when troubleshooting my Honda. :)

Sep 17, 2009 | 1989 Honda Accord 4 Door

2 Answers

Isuzu rodeo 2000 stalling out and rmp reving....


on 98 and up 3.2 and 3.5 v6 engines the intake gaskets are plastic.....thy crack and the truck runs rough.....listen for hissing sound or a check engine light....p0171 lean.
good luck

Nov 23, 2008 | 2000 Isuzu Rodeo

Not finding what you are looking for?
2000 Isuzu Rodeo Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...