Question about 2001 Ford Focus

1 Answer

Wot start hi my focus wot start on a stand still but will go of a dump

Posted by on

  • alan270983 Jun 16, 2009

    the car thys to start it thys to turn over but still wow go but it will go of a dump



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

Replace starter.

Posted on Jun 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

What causes blue smoke on Isuzu npr tipper dump truck?

Could be bad piston rings letting oil up into the head Could need engine work to repair.

Jul 12, 2015 | Isuzu Cars & Trucks

1 Answer

Hi my moms 1.8 focus tdci 53reg the charge light as come on wot voltages should i be looking for on the multi plug the red wire is the battrey feed and 12.4 volts but the other 2 wires have smaller...

car off not runing should rear 12.8 volts across battery
car running should read 13.8 volts same location
remember to load up charging system and retest should be above 13.0 volts
with all accessory on

Jul 05, 2011 | 2003 Ford Focus

1 Answer

Hi i have a 1800 ford focus deisle the power stiring belt went n now it dosnt start so iv checked the timing belt i think it has jumped iv took the belt off n now it will only turn so far befor it locks...

The timing belt controls the timng of the opening of inlet and exhaust valves in the engine. With the belt removed, if you try to turn the engine over some valves will have been left open and intruding into the compression chamber. By turning the engine over they will be struck by the pistons as they move upwards and you will have just bent at least one exhaust and one inlet valve. This is what has stoppes the engine turning over.

Sorry to say you just wrecked the engine and all hope of getting it started again without having the cylinder head taken off, the damaged valves replaced and re-ground. Hopefully the pistons will have survived the impact (They usually do).

Jun 23, 2011 | Ford Focus Cars & Trucks

6 Answers

Diesel mondeo glow plug indicator keeps flashing when driven

Hi Shaunbarry, Have you been able to fix the problem changing the EGR valve?

Aug 18, 2009 | 2006 Ford Focus

1 Answer

Wont start

power on cluster ,does that mean the spark?? can you hear the fuel pump work does it have petrol in it ?? is starter turning angine over?? have you lost the chip out of the end of the key??is the battery flat??left lights on ??has vehicle been left standing for a long time with battery connected ??

Nov 15, 2008 | 2001 Ford Focus

2 Answers

Fuel pressure regulator

you have disconnected a wire somewhere under the bonnet look agin

Aug 10, 2008 | 2001 Ford Focus

1 Answer


about 600miles depending on driver and conditions .roof rails ??never done one sorry

Aug 10, 2008 | 2001 Ford Focus

Not finding what you are looking for?
2001 Ford Focus Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides