Question about 1994 Ford Taurus

3 Answers

DoI have to pull the engine to get the transaxel out of car?

1994 Ford Taurus LX do I need to pull the engine out to replace the transaxel?

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

The normal way to remove the transmission from this car is to drop it out the bottom, after raising the vehicle. You can pull it out the top, but you would first have to remove the engine, since it sits on top of the transmission. The specific steps are best found elsewhere, such as Autozone's website, at the path

  • HOME /
  • REPAIR HELP /
  • 1994 FORD TAURUS 3.8L EFI 6CYL REPAIR GUIDE /
  • DRIVE TRAIN /
  • AUTOMATIC TRANSAXLE /
  • TRANSAXLE
  • (the advantage with the Autozone instructions is that they're free, and they're illustrated), or you can buy an official Ford service manual for this vehicle (often still available on eBay for decent prices), or from online repair subscription services like AllData, etc., though AllData's instructions for transmission removal from this vehicle aren't illustrated.

    Posted on May 03, 2013

    Ad
    • Level 3:

      An expert who has achieved level 3 by getting 1000 points

      Superstar:

      An expert that got 20 achievements.

      All-Star:

      An expert that got 10 achievements.

      MVP:

      An expert that got 5 achievements.

    • Master
    • 3,600 Answers

    No you can just remove the axle on the driver side and disconnet the lower ball joint and disconnect the tie rod end to drop it out.

    Posted on Jun 16, 2009

    Ad
    • Level 3:

      An expert who has achieved level 3 by getting 1000 points

      All-Star:

      An expert that got 10 achievements.

      MVP:

      An expert that got 5 achievements.

      Vice President:

      An expert whose answer got voted for 100 times.

    • Master
    • 321 Answers

    No not the axle shafts.
    if you want to remove the transmission you will but not the axle shafts.

    hope this helps
    thank you
    jm

    Posted on Jun 16, 2009

    1 Suggested Answer

    6ya6ya
    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    Hi,
    a 6ya expert can help you resolve that issue over the phone in a minute or two.
    best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    goodluck!

    Posted on Jan 02, 2017

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    1 Answer

    Knock sensor for Honda 1998 Accord LX


    Duplicate question.
    I doubt the sensor would make the engine stop running. The computer would slow down the spark timing to prevent engine knock, but not shut it off.

    Jul 08, 2013 | 1998 Ford Taurus

    1 Answer

    OK!! I resume my question lollll I want to check the oil level of my automatic transaxel, Honda accord lx 1993, but What is the method ??


    get the engine hot put the car in park pull out the transmission dipstick wipe it then put it back in,pull out and check the reading

    Apr 07, 2013 | 1993 Honda Accord

    1 Answer

    My transmission is slipping.How do I take it out,and put a other one in ?1994 ford Taurrus LX 3.8L 6C.And what tools do I need???


    That is not an at home job

    No Transaxle is

    You really need a lift and experience

    You also, never install a used trans,
    could be worse than yours

    Feb 24, 2011 | 1994 Ford Taurus

    1 Answer

    Need to replace thermastat in a 1994 ford taurus, where is it located at,


    Follow the upper radiator hose from the radiator to the engine. the hose will lead you right to it. The upper hose is connected to the thermostat housing. The thermostat is located under the thermostat housing. Hope this helps :)

    Dec 18, 2010 | 1994 Ford Taurus

    1 Answer

    How do i remove transmission from a 1994 ford taurus lx


    Not alone and not in your driveway,on a transaxle

    That job is best left to a transmission repair shop
    That is what they do all day long

    I used to own one

    You need to break the suspension apart,
    remove the drive axles,support the motor,
    then what.
    Even in a repair shop, you loose a lift,after that,although,
    there are ways of getting the vehicle off and outside

    Dec 01, 2010 | 1994 Ford Taurus

    1 Answer

    Where is the veical speed sencer located


    The vehicle speed sensor for a 99 taurus 3.0 2v, is located on the transaxel between the engine and firewall. At the center of the engine
    compartment. Hope this helps.

    Apr 20, 2010 | 1999 Ford Taurus

    1 Answer

    1994 Ford Taurus, there is a whinning noise in engine compartment


    Its not the computer its the EGR valve actulator de-energizing. Nothing to worry about unless your check engine light comes on.

    Jul 02, 2009 | 1994 Ford Taurus

    1 Answer

    What are the metal tubes for above the transaxel filter? 1 is lose and need to know how to get it to stay up in the trans. Axod transaxel


    They are to transfer fluid to different parts of the transaxle. If it is loose it could cause an internal leak which could result in lower that normal oil pressure in the transaxle. Low oil pressure could cause transaxle failure because clutches would not apply with enough holding pressure. I would suggest replacing it with a new one or see if you can expand the loose end and press it back into it's bore.

    Jun 07, 2009 | 1994 Ford Taurus

    Not finding what you are looking for?
    1994 Ford Taurus Logo

    167 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    fordexpert

    Level 3 Expert

    5522 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...