Question about 2000 Toyota Corolla

1 Answer

2000 Toyota Corolla, vibrates when brake on and in reverse, check

2000 Toyota Corolla vibrates when put in reverse and when have the brake on and in drive. Doesn't do it all the time, does it here and there. It sets off the check engine light. Code P0301 which is clylinder 1 misfire. Have changed the cylinder and did tune up, also did a fuel system service. Any help would be appreciated.

Posted by on

  • lialmade Jun 20, 2009

    Moved coil from #1 cyl. to #3 cyl. Moved fuel injector from #1 cyl. to #2 cyl. Check engine light went off, code was P0302.

  • lialmade Jun 25, 2009

    Changed the fuel injector on cyl. #2. Engine runs better. Thanks for the help. Still having problem with the car vibrating when car in drive and foot on brake(not moving); also vibrates when car in reverse and foot on brake(car not moving). Any help would be appreciated.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Toyota Master
  • 358 Answers

Check the coil. you can switch them around to see if the code changes to the cly that has the coil from the #1 cly.thats the fastest way to check the coil.

Posted on Jun 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does my reverse gear grid on my 2000 Toyota


I take it you mean the transmission grinds when shifting into reverse with a manual transmission in which case the input shaft of the transmission is still partially engaged with the engine. One cause may be low fluid in the hydraulic clutch reservoir if it has a hydraulic clutch mechanism; use DOT-3 brake fluid and pump the clutch pedal a few times to remove any air. Another cause may be that the pilot bearing is hanging up; this is a major repair. Another possibility is that the clutch lining is coming loose or totally disintegrated requiring replacement.

Nov 17, 2014 | 2000 Toyota Corolla

1 Answer

Toyota corolla vibration


could be worn down rotors (the big metal disc). The thinner rotor will not dissipate heat during braking and the pads get too hot to be able to grip the rotor and while braking you get a shudder effect

Check also the rear suspension as this can cause font tire wear un evenly

Nov 05, 2017 | Cars & Trucks

1 Answer

!996 Toyota corolla, starts up ok but when put on reverse or drive, won't move even when pushed


Check the gear lever connection with the gearbox.
Check the gearbox oil level and colour. Replace if necessary.

Nov 13, 2012 | 1996 Toyota Corolla

1 Answer

VIBRATION ON STEERUING AND PEDEL WHEN BRAKING UP TO 100KM


could be anything ,most obvious is brake disks but?? have it put up on a four poster jack and the suspension checked out ,Do you have a yearly vehicle mechanical inspection in your neck of the woods ??

Jan 01, 2011 | 2001 Toyota Corolla

1 Answer

Front end vibration


brake discs not warped?steering arms ok (no play in them)bent stub axel check these things and you will find the issue

Nov 02, 2009 | 1994 Toyota Corolla

2 Answers

2000 Toyota Corolla Vibrates


try giving a good tune up gas filter cap, rotor,wires,plugs,should feel a dramatic change

Jun 25, 2009 | 2000 Toyota Corolla

2 Answers

Car trembles while on Drive as soon as one halts by applying brakes


you should find a workshop equipped with a diagnostic computer. it should tell you whats wrong with your car.

May 28, 2009 | 1996 Toyota Corolla

1 Answer

2000 toyota corolla ce motor trembling when on drive holding down brakes.


check the brake disks. surface should be cleaned. also check the brake pads.

May 20, 2009 | 2000 Toyota Corolla

1 Answer

When you put the brake pedal, does the rear drum brake work?


the rear drum brakes work on foot and hand brake , noise under stain does it rattle could be a loose exhaust heat shield ,

Apr 18, 2009 | 2001 Toyota Corolla

1 Answer

2009 Toyota Corolla


1st, is your foot on the brake? That's a safety feature, u must depress the brake pedal before u can shift out of park.

Jan 15, 2009 | 2009 Toyota Corolla

Not finding what you are looking for?
2000 Toyota Corolla Logo

Related Topics:

590 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...