Question about 2006 Ford Freestar
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Try your spare key first. also, does the anti theft visual indicator (red flashing light) prove out, that is light for three seconds when key is turned to on.
here's some info.
Principles of Operation
The passive anti-theft system (PATS) uses a specially encoded ignition key. Each encoded ignition key contains a permanently installed electronic device called a transponder. Each transponder contains a unique electronic identification code out of over 18 billion, billion combinations.
The passive anti-theft system (PATS), also known as SecuriLock ®, uses radio frequency identification technology to deter a drive-away theft. This system is known as SecuriLock® in North America, Safeguard® in the U.K., and PATS in continental Europe. Passive means that it does not require any activity from the user.
The SecuriLock® System (PATS) is not compatible with NON-FORD remote start systems, which allow the vehicle to be started from outside the vehicle. These systems may reduce the vehicle security level, and also may cause no-start issues. If equipped, the remote start system must be removed before investigation of PATS-related, no-start issues.
Each encoded ignition key must be programmed into the vehicle's powertrain control module (PCM) before it can be used to start the engine. The correct ignition key is a different design than prior model years. Consult the Rotunda Key Ordering Guide for the correct part number. There are special diagnostic repair procedures described in this section that must be carried out if a new encoded ignition key is necessary.
This system contains a new feature named Unlimited Key Mode. This feature allows a customer to program more than eight keys to the vehicle if they request it. Each vehicle in Unlimited Key Mode is set up with a special unlimited transponder security key. This allows all the customer vehicles to share the same keys, but no other keys from outside can be used to operate the vehicles. For an individual customer, any randomly selected security key is acceptable. Refer to Unlimited Key Mode Programming in Key Programming Switch State Control in this section.
The PATS transceiver module communicates with the encoded ignition key. The module is located behind the steering column shroud and contains an antenna connected to a small electronics module. During each vehicle start sequence, the transceiver module reads the encoded ignition key identification code and sends data to the PCM.
The control functions are contained in the PCM. This module carries out all of the PATS functions, such as receiving the identification code from the encoded ignition key and controlling the engine enable. The PCM initiates the key interrogation sequence when the vehicle ignition switch is turned to RUN or START.
All elements of the PATS must be functional before the engine is allowed to start. If any of the components are not working correctly, the vehicle will not start.
PATS uses a visual theft indicator. The indicator will prove out for three seconds when the ignition switch is turned to RUN or START under normal operation. If there is a PATS concern, this indicator will either flash rapidly or glow steadily when the ignition switch is turned to RUN or START. The PATS system also flashes the theft indicator every two seconds at ignition OFF to act as a visual deterrent.
PATS will be activated and will disable the vehicle from starting if there is:
Posted on Jan 09, 2009
It is on the same button as the Trip Odometer. Cycle through until you see Tire Reset and hold the button down.
Posted on May 04, 2009
Take another cd and push the stuck one all the way back then try and eject it. If it doesn't come out right away do the process again this time when you hit eject take another cd and push down or up on it. Wiggle it around so it catches the rollers in there. Using CDs with homemade labels causes jams when the stickers peel up.
Posted on May 15, 2009
Tips for a great answer:
Nov 01, 2014 | 2004 Ford Freestar SEL
Jul 25, 2013 | Cars & Trucks
Sep 29, 2012 | 2006 Ford Freestar
Jul 05, 2011 | 2006 Ford Freestar
Jun 06, 2010 | 2004 Ford Freestar
Nov 18, 2009 | 2006 Ford Freestar
Jul 24, 2009 | 2006 Ford Freestar
Jul 16, 2009 | 2005 Ford Freestar
Jun 23, 2009 | 2006 Ford Freestar
Feb 16, 2009 | 2006 Ford Freestar
273 people viewed this question
Usually answered in minutes!