Engine code p0342 - 2005 Kia Sorento

The codes signify issue with the same component.

P0341 What the P0341 code means. P0341 is an OBD-II generic code that says the engine control module (ECM) detected the engine camshaft position sensor circuit is not within specifications. The sensor pulses do not correlate to the pulses of the crankshaft sensor.

P0341 OBD-II Trouble Code: Camshaft Position Sensor Circuit ...

P0342 Code: Camshaft Position Sensor "A" Circuit Low

https://www.carparts.com > blog > p0342-code-camshaf...
Dec 15, 2021 - P0342 is a diagnostic trouble code (DTC) that stands for "Camshaft Position Sensor 'A' Circuit Low." It basically means that your PCM is not ...

code p0342 refers to cam shaft position (CMP) sensor A bank 1 --low input===causes--wiring short to ground---CMP sensor---ECM
Check for wiring shorting out on the engine /body, replace the cam sensor on bank 1

Yes that would do it.
Someone would need to test the sensor and the wiring to see if the sensor has failed.

Po300 is a misfire probably all three caused by a faultymap sensor

P0137 Error code Faulty O2 sensor Exhaust leak near the rear sensor

• Plugged catalyst
• Short to voltage on O2 signal circuit
• High resistance or open on O2 signal circuit
  

Possible Solutions

• Replace faulty sensor
• Repair exhaust leak near the rear sensor
• Check for restriction in catalyst and replace as necessary
• Repair short, open, or high resistance on o2 signal circuit

P0141 Error code means Downstr Heated Oxygen Sensor Heater circuit fault - Bank No. 1.

- replacement is needed for this issue.

P0342 Error code means Camshaft Position Sensor Circuit Low Input

P1792 Error code means P1792 means the computer isnt properly programmed so if this code keeps comming back the pcm may need to be replaced

code p0342 is referring to the cam shaft. i am not getting anything for the other code for your vehicle so i would start there.

P0342 - camshaft position sensor A circuit low input
( bank 1 or single sensor )

P0217 - engine coolant over temperature condition

hallo
P0342 code means: camshaft position sensor- low imput. Check wiring (short to earth), if OK change camshaft position sensor.
Marko

the code for camshaft sensor is--p0341 and p0342, po341 is camshaft range or performance problem. p0342 is camshaft curcuit , low input. hope this helps carl.

I just replaced mine on an '04 8.1 vortec. Ez fix. Pd $33 at Rockauto. The sensor in located on the front of the engine &slightly toward the drivers side. Unplug the electrical connector and remove the single nut (10mm). Evenly pull the sensor out from the block. Only use the force needed. Don't yank. Place a oil on the new sensors o ring & reinstall.