Question about 1989 Ford F 250

1 Answer

My manual 5 speed is popping out of 5th and 4th gear? 1989 with 5.0 302 single cab long box. any ideas????

Posted by on

  • Anonymous Mar 27, 2014

    only have 3rd and 4th gear on my 5 speed Manual Tranny. Any Ideas?

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 85 Answers

Please have the gearbox removed and let the technician check and replace the gears rod locks!

Posted on Jun 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi all I own a 2006 RA Rodeo 3.6Ltr petrol dual cab it is a little heavy on fuel that's fine but when you put it into 5 gear it just drinks fuel nearly 1/4 tank to go 15-20 klms. Any ideas greatly app


The only thing that comes to mind is that in 5th, the rpms may be so low that you are running on low speed potion of ignition module, getting weak spark and not burning fuel properly. This could be true in all gears at low rpms, but you would not notice it as much because you probably keep the revs up more in lower gears. Just a thought.

Jan 08, 2015 | Cars & Trucks

1 Answer

Manual Transmission loud metal noise 5th gear doesn't work


check the drain plug magnet for metal bits . If any the box has to come out 4.th gear is straight shaft connection and 5 gear connects from the cluster shaft up to the out put shaft . On either side is a rear main bearing and from your description if that bearing is failed then the 4th gear syncro will not align properly and the gear for 5th will be out of alignment so the syncro to work will not work

Mar 15, 2014 | 1993 Ford Escort 4 Door

1 Answer

I can only get 4th gear on my 2000 geo metro what do i do to fix it


I suggest that you have to pull the box and do a full overhaul on it. From your description you will need 5thgears and synchros--bearings -all gears synchro kit and may be some gear dogs as well. Consider a replacement box from the wreckers as it would be cheaper.

Nov 16, 2013 | Cars & Trucks

1 Answer

I have a 2000 hundai accent and when i shift into 4th gear it pops back out again


The problem is inside the box, could be a sliding sleeve and gear

Jun 25, 2012 | 2000 Hyundai Accent

1 Answer

Chevrolet 5 speed manual transmission stuck in gear


First I would try to pop it out by rocking it back and forth with engine off! Have a couple friends help you push it back and forth hard (ignition OFF) while you try hard to pop it out. If you cannot get it, and you have no experience with trans, call a local ****** shop. They may tow it in cheap. Get a recipt for the max your insurance reimburses. Good luck.

Mar 09, 2012 | Cars & Trucks

1 Answer

Truck has no fifth gear


not unless fifth seases to the baring's. but then it won't even go in to 4th or 5th. it's probably your sincro's that r bad between 4th and 5th.

Feb 04, 2010 | 1992 Chevrolet C1500

2 Answers

Isuzu bighorn 1994 manual, slips out of 4th and


Problem is the detent springs for 4/5 gear have gone weak .
If you are handy its take the top off the gearbox from inside the car and you will see the plug then the springs and balls .
If not its a transmission shop job.

Sep 24, 2009 | 1994 Isuzu Trooper

1 Answer

Shifter seems to have shifted


just ram the shifter in your booty,.....duh

Dec 31, 2008 | 2003 Toyota Celica

1 Answer

1990 Honda Accord


IT SOUNDS LIKE YOUR CUTCH PLATE WHICH IS ULTIMATELY RESPONSIBLE FOR PUTTING THE CAR IN THE PROPER GEAR, SORRY NO QUICK FIX.

Aug 04, 2008 | 1990 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81342 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...