Question about 2003 Ford Mustang

1 Answer

Push clutch in to start car wont start? starter or clutch switch?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 54 Answers

It is quite possible it is the clutch switch. If it wont turn over this is quite possibly the problem.

Posted on Jun 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

`1998 GMC SONOMA WONT START WITH KEY ON CLUTCHPUSH IN STARTER OKBUT MOTOR TURN OVER


clutch safety switch bad. may be bad wire/fuse. shld be located on the clutch pedal normally kind of square to oblong box type switch abt inch and half long.you can unplug it, and place a jumper wire in the plug terminals and if it starts then you know its the switch (note: it works the same as a nuetral safety switch on an automatic)

Aug 27, 2012 | 1998 GMC Sonoma

1 Answer

97 honda accord manual clutch safety switch


try to have someone push the clutch and hold the key ...get something with a little weight on it and tap on starter

Aug 16, 2012 | 1997 Honda Accord

2 Answers

94 civic wont start, only if i push start it. changed starter and ingnation swith.


SOUND LIKE FAULTY STARTER CLUTCH INTERLOCK SWITCH LOCATED NEAR THE UPPER END OF THE CLUTCH PEDAL OR YOU HAVE A FAULTY STARTER RELAY.CHECK TO SEE IF POWER GOING TO THE CLUTCH INTERLOCK SWITCH WIRES WHEN CLUTCH PEDAL PRESS DOWN. IS YES SWITCH IS BAD.IF NO POWER GOING TO CLUTCH INTERLOCK SWITCH YOU HAVE FAULTY STARTER RELAY OR BLOWN STARTER FUSE.

May 04, 2011 | 1994 Honda Civic

2 Answers

Starter wont turn over ,where is it and where is


The clutch switch is on the clutch pedal and it has an arm that connects to the pedal and a 2 wire or 4 wire connector as the car may have cruize control if it has a clutch swith there is no other neural switch as starting in gear with the clutch pushed in is allowed. The starter can fail as can the ingtion switch ( Key switch).

Jun 12, 2010 | 1995 Honda Civic

1 Answer

Where is the starter solonoid located 04 aveo


You will need to verify if the starter solenoid is getting power when you are attempting to crank it. I dont have a diagram, but the clutch switch may be the problem if you must depress the clutch to start the engine.

Jan 16, 2010 | 2004 Chevrolet Aveo

1 Answer

1995 nissan pu wont start... everything turns on


check for power to the starter at the starter's connectors while you have someone turn the key. If there is power, change the starter. If not check your ignition switch, (manual trans)clutch pedal switch, and starter fuses/relays. Hopefully this helps

Jul 19, 2009 | 1995 Nissan Pickup

1 Answer

My car wont start. It started out that I had to push the clutch further and further in to get the car started. Now it jsut doesn't start at all. Replaced the clutch peddle switch but that only worked for a...


Switch is pretty much just a push button. You can easily check it by looking at it and making sure it's fully out with the clutch depressed (may be out of adjustment) Or, you can jump across the switch terminals and in neutral, with brake engaged and clutch pressed to the floor, see if the starter engages when you turn the key. (never do this with anyone standing in front of or behind the car, or in a place where you will run into anything if it happens to be in gear. If it starts with switch bypassed, the switch is defective. Otherwise, check the wiring going to and from the switch.

Jul 13, 2009 | 1998 Pontiac Sunfire

1 Answer

93 honda prelude dohc vtec engine will not can be push started


Sounds like you accidently pulled the thin wire from you starter motor. Look at the connections at the end of the solenoid, mounted on starter motor.The thick red wire is Battery + next to that connection is a smaller male push- on terminal, locate loose wire (thin) in the same area and reconnect to male push-on terminal on solenoid or check if earth cable between body/battery to engine wasnt removed in the process.Also some vehicles you have to engage the clutch before starting, check for a switch located on clutch pedal where master cylinder connects to clutch pedal (Is clutch switch mounted and wiring connected?)

Jan 03, 2009 | 1993 Honda Prelude

1 Answer

Won't start


does this have a factory alarm? aftermarket? check for power out from the switch. starter relay, clutch safety switch, or starter......... have someone get a starter bypass and try to see if it starts. any parts store will tell you if its bad. good luck mark as fixya thanks

Sep 13, 2008 | 1993 Honda Prelude

2 Answers

89 wrangler


there should be a sloenoid on the firewall it could be bad

Aug 26, 2008 | 1989 Jeep Wrangler

Not finding what you are looking for?
2003 Ford Mustang Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...