Question about 1992 Dodge Dakota

1 Answer

92 dodge dekota truck runs good for the first 3o minuts and afther that it starts lossing its power. I removed air temperture sencer cleaned it n put it back and the truct starts running good again, can u help me.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 249 Answers

Is your check engine light on,and is there any codes?

Posted on Jun 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How will a bad intake manifole temperture senser make a 1995 dodge dekota run.


the bad sensor is telling the ecu it is in danger of damaging the engine and so shuts it down to prevent seizure

Mar 02, 2015 | 1995 Dodge Dakota

1 Answer

Were is 1997 dodge dekota map sensor located


It's located on the air intake tubing between the air filter box and throttle body.usually rectangular,mounted to intake w/screws,and has a wiring connector.DON'T touch the wires inside,clean only with electrical contact cleaning spray. Best O'Luck

Feb 21, 2015 | 1997 Dodge Dakota

1 Answer

The car wont start afther changing fuel pump and ignition coil


it shouldnt be pumping out gas it should spray very little might want to check the fuel regulator it might be flooding out from to much gas

Mar 17, 2013 | 2005 Chevrolet Cobalt

1 Answer

92 dodge dakota stalling,running rough,loss of power


Did you replace the fuel filter when you replaced the pump ?
Was it running rough before the pump was replaced.
Did you replace the cap and rotor too ?
"Sucking a ton of air" could be a vac leak, or the sound of the throttle open when the engine is bogging down.
Is the check engine light on when it is running ?

Jul 05, 2012 | Dodge Cars & Trucks

1 Answer

My 1999 dodge v10 2500 4x4 truck dies while driving after about 15 -20 minutes it starts again I had a new fuel pump put in on monday and it ran good for two days now today it is doing it again it quit...


Hello
Something that you may want to check, or have checked is the, ( MAF ), " mass air flow ", sensor.
Some of the symptoms are, bad idle, loss of engine's power, stalling, and eventually preventing the
engine from starting, especially in cold weather.

This is usually easy to check;

The sensor is usually located in the air intake duct system, the duct system that the air filter is in )
between the air filter and the engine. Most have a plug with 4 or 5 wires. Very carefully discon-
nect the plug. If the engine doesn't start either remove the battery cables and clean them very
good, or try to jump start the engine. Once the engine is running leave the plug off and go for a
short test drive to see if you notice the engine performing better.

You can drive while this is disconnected, but try not to do that too long. It can cause other
sensors to trigger the, " check engine light ", and over a longer period of time can damage the
catalytic converter.

Some handy people go to a parts store and get, " mass air flow ", cleaner. It does seem to work
well, but you have to follow the instructions very closely.

I hope this helps you.

Feb 10, 2011 | 1999 Dodge Ram

2 Answers

Got a 92 dodge Dakota i have problems starting it, when i try to turn the truck on it wont fire over but if i leave the key to the run position it takes about 10 minutes before i can hear the relay start...


Check the Auto Shutdown Relay (ASD) in engine power distribution box (left inner fender-under hood)
You should hear fuel pump for 15 sec after you turn on key

Oct 18, 2010 | 1992 Dodge Dakota

1 Answer

Hi hope u can help me ..... replaced thermostate housing


Sounds more like it has a leaking head gasket, which would explain your loss of water, have a mechanic (possible a different on) pressure test the collant system, and then check it for exhaust gasses in the coolant! unless you have unplugged somthing during the housing change, or had removed part of the throttle body or intake and didnt get a good seal, there should be no air leak!

Feb 11, 2010 | 1996 Ford Explorer

1 Answer

2000 dodge dekota stalls


Check your Idle Air control motor, it is located on back of your thottle body. unplug and remove two srews, cost about $40.

Jul 04, 2009 | 2000 Dodge Dakota Quad Cab

Not finding what you are looking for?
1992 Dodge Dakota Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...