2001 TOYOTA COROLLA NO POWER

for better result download the pdf file
TOYOTA COROLLA SERVICE REPAIR MANUAL 2001 2002 2003 2004 2005 2006

Any codes set? Check TPS, fuel pressure and MAF.

It is probably a TPS, fuel Pressure regulator. Check engine codes.

See if you turn the wheel and try to turn the key at the same time if it releases. We might get a free spot where the key should turn. The lock may be in a bind and pressure on it may release it.
Clean and lubricate the lock cylinder. Electric cleaner to flush the dirt and liquid graphite to lubricate. A substitute for the electric cleaner is a spray of isoprophyl alcohol.
You may also need to tap the assembly for the ignition switch to release the mechanical parts. See if you can get the cover of the steering column off to gain access to the ignition switch assembly.
Check also if the spare does the same, other wise the key may have deformed.

This vehicle does not use points, it has a solid state magnetic pick up to trigger ignition. Try changing the air filter. A dirty air filter can put the MAF ( mass airflow sensor) out of range.

Switch the ignition off and remove the key. Take a 12v light bulb and connect a wire to the chrome body of the bulb by taping it in place. Connect the other end to any metal part inside the cabin. You can use a clothes peg or insulation tape to hold it in place. Take the bare ends of any of the wires you have available as potential power leads and touch them to the lead contact on the bottom of the bulb. If it lights up it is to the battery. You must use an in line fuse on this wire. Isolate any other battery cables. Switch the ignition to acc and test again. Any wire that lights the bulb is working off the acc. If you touch the chrome body of the bulb with this wire you will blow a fuse.

check the battery terminals

If the check engine light is on, take the car to an autoparts store and have them scan the computer for fault codes. Most parts stores will do the scan for free. It sounds like it could be a faulty throttle position sensor, but getting the codes will end speculation and show what faults the computer has noted, so the problem can be properly addressed. Sorry for your trouble and I hope this helped. Best wishes.

can y tell me what enigne size ?

i would say you have water in your gas