Question about 2006 Chevrolet HHR

1 Answer

My sister is on the highway right now and says her car is jumping. says it kinda feels like a jolt when you get rearended. i told her to check to make sure she had a good connection on her battery. any other advice?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Chevrolet Master
  • 3,433 Answers

What kind of vehicle is it?

Posted on Jun 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine runs weird when decelerating from a high speed (100mph-160kmh) highway run.


I would expect a "check engine" light and a code if your O2 sensor was bad. You checked codes, right?

Oct 20, 2015 | 2003 Subaru Forester

1 Answer

My 97 cougar xr7 has a problem when accelerating. if i press on the gas hard it takes a min for the car to catch up and kinda stalls out until i let up on the gas and let it catch up. it also slowed way...


It may also be the catalytic converter. If that gets plugged up it puts a lot of back pressure on the motor. This will make it hard to get up to speed. When not pressing much on the petal it will seem to run fine. Then when you press more to increase speed you will feel it.

Oct 03, 2013 | 1999 Mercury Cougar

1 Answer

2000 pathfinder will hardly back up shakes bad


either the reverse gear is binding up in the trnsmission, the differential has issues or if its a stick(manual shift) the clutch needs adjusted or replaced..repost findings...

Jan 21, 2013 | 1987 Ford Ranger

1 Answer

Hi. I have a 2000 Nissan Xterra with approx. 157,000 miles on it. I have been its sole owner for 11 plus years with no major problems whatsoever (a few stupid things here and there). In August of this...


you might have a clogged catalytic convertor ( a clogged cat will throw o2 sensor codes) and make that repair shop check for freon leaks free of charge, they should not have re charged the system without checking for leaks,,, its a federal law 25,000 fine

Oct 21, 2010 | 2000 Nissan Xterra

1 Answer

Hyundai sonata jolt


if this happen when traveling at a constant speed it could be feul related.check feul pump pressure and replace feul filter

Jul 12, 2009 | 2000 Hyundai Sonata

2 Answers

I have a 2004 Chrysler Concorde Limited with a 3.5L engine - The car shut off on me as I was driving at 60mph. I coasted to a stop, put the car in park and it started right up. This has happened several...


I had the same issue that has evolved into the car starting and idling for 2-3 seconds then stalling. After doing this five times it won't turn over at all. All the dash lights are on but no turn over. After the car sits for appoximately 15-30 minutes, it starts and runs fine for 3-4 weeks then does it again. I was told this is due to the camshaft and crank position sensors needing replaced.

Jun 23, 2009 | 2004 Chrysler Concorde

1 Answer

My 89 toyota stalled in highway, now it wont turnover. No spark. Kinda a whining noise as it stalled. Any help????


Engine oil level ok? Check connections to battery (clean and tight at battery and starter). Try to jump start?

Mar 11, 2009 | 1989 Toyota Pickup SR5

2 Answers

Rear end in 1999 chevy 1500 binds on turns


well i had the same problem everyone told me the clutches in the rearend were sticking making it stick in positive traction (only your passanger side rear wheel pulls unless you start spinning then a type of clutch engages the other side so you have traction then when you stop spinning it disengages it should never be engaged if your on pavment) now you can do what i did listen to everyone when they tell you its normal or you can take it to someone with experience now and save yourself some money cause it will start popping then it will get some viberation then next it will break the clutches and when that happens you will have to replace the pinion,ring,and the spider gears as well as the clutches.make sure you have pleanty oil in rearend if you dont add the limited slip conditioner it might free clutches up but if i had it to do over id put it in the shop or stop driving it before i broke something hope this helped

Mar 10, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

1997 buick Lesabre studers when driving over 50


Sounds like what is called shutter changing to synthetic fluid fixed my 98 Lesabre

Jan 25, 2009 | 1997 Buick LeSabre

Not finding what you are looking for?
2006 Chevrolet HHR Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...