First try toggling the hazard switch a few times. Sometimes it gets stuck. If no go and all associated fuses are ok, I would look at directional switch. Very common on these.if you're not mechanical inclined this could be a bit more than you may be able to handle. Diagnosis consists of removing steering column cover and checking for power at switch, but caution has to be taken because air bag system wiring also is in that area, you don't want to probe wrong wire.
SOURCE: 1998 Lincoln Town Car
If your main brake lights are not working and the third light in the back window is working
it is the turn signal switch on the column cost about 150 to have replaced
SOURCE: Diagram for 1998 lincoln continental
how do i ronte a serpentine engine belt on a 1998 lincoln continental
SOURCE: 1998 Dodge 2500 pickup turn signals, hazards
There is a conector box on the left side of your steering wheel on the colum loosen it and check your wires I bet when you just loosen the block they will start working,I hope this helps you
SOURCE: replace rear brake light bulb 1998 lincoln continental
pop the trunk and right behind where the lights are pull the carpet
down and their will be of the following depending on the trim.
You will either see the light sockets themselves that you can twist and pull to change the bulb, or you will see the plastic nuts/screws that you can remove to remove the entire assembly in order to access the bulbs.
If it's your 3rd brake light, the screws to access the housing are located in the upper part of the trunk
SOURCE: 1998 Buick Century Signal Issue
foun mine on the driver side between the drivers door and the dash if you but the trun signal on you should hear it cleak clak
48 views
Usually answered in minutes!
×