Question about 1997 Saturn SL

1 Answer

Were is my craik senser - 1997 Saturn SL

Posted by on

  • yadayada
    yadayada May 11, 2010

    what is a "craik senser"??

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 299 Answers

Located right above starter.

Posted on Jun 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I started my 2005 dodge diesel with ether it idle alright then when I revved it up it stayed revved up at about 2300 rpms and up what's wrong


Check vacuum lines. Check idle control senser check air control senser. If it had a MAP senser check it. For senser unplug them while running, should change performance if not have that senser checke. Vacuum leak will not change when unplugging air control senser.

Oct 13, 2017 | Dodge Cars & Trucks

1 Answer

1997 ford f150, starts and runs, but shut off and it will not restart.


Check catalytic converter mapp senser EGR valve o2 senser

Sep 03, 2014 | Cars & Trucks

1 Answer

I want to replace the knock sensors on my GMC Sierra 6.5 liter how do I do it?


Just ahead of the starter the knock senser just screws into the side of the block. The problem is it screws into the engine coolant and the coolantr will come out then you remove the old senser. even if you frain the raditor coolant will still be in the engine ( quite alot) and you'll need to catchir in some way. You can get about 2 gallons. The messly way to do it is to ( with the engine cold) loosen the senser till you can turn it by hand. With the new senser in th=your other hand remove the senser and quickly screw the new senser in. You'll almost certainly get coolant on you so be eady, covering your eyes and arms ( glasses and a raincoat) you do it quickly eniugh very little mess will be made. The plug just squeezes and pulls off. Knock sensers seldom fail but the connection and the wires do. Someone replaceing the startercan hit the senser and break it. Don't drop the senser as the fall can break it too.

Aug 09, 2011 | 2001 GMC Sierra 2500HD

1 Answer

How many sensors does my 2006 solara have


Dependa on the defination of the word senser. The main sensers that tell the computer what's going on and then thiers another set of sensers that tell the driver what's going on the ten are you just talking about the engine or the transmission or the brakeing system or the aircomditioning system. The ABS braking system has a fluild level senser, a wheel speed senser ( one at each wheel) if your solara has four wheel drive it's got a rear differantial speed senser and a transmission out[ut speed senser. then the sysyem uses sensers in other systems like the bdy control sysyem to get anbieant temperture and alaitude information and the stabitly system has a GPS conection and real speed and direction and conpass readings all used to just get the ABS system working and the traction control system That shares these sensers also has inputs from the engine conrol system as to trottle position and air flow and RPM and may require the engine control system to stall or satutrer the engine or even limit RPM to regain traction or get the vehical headed in the right direction. The air conditioning system depending on the yype of system installed and what factory it was made in and what country it was made for sale in can change the number of sensers that's in it quite highly. Some of the zone indepentant controlled fully automatic systems ( top of the line) can have as many as 5 temperture sensers alone never mind 1 or on some models two sunlight sensers. The freaon pressure sensers as many as four and no less then two. An RPM senser on the compressor clutch and information from the engine system as to throttle position( it turns the compressor off in wide open) and high RPM ( it turns the compressor off to prevent over speeding the compressor and to give the car all the power it can to go fast.) the evaporator temperture as to not allow it to freeze. amoisture senser as to direct dry air onto the windshield to clear it as a safty concern. I've not even begun to tell above the engine or the transmission or the theif recovery systems or the antitheif systems.

Apr 04, 2011 | 2006 Toyota Solara

1 Answer

3.5v6 tempt gauge is not moving as engine warms?


Coolant temperture senser can be unplugged or bad. Coolant can be too low to touch senser. Coolant can be too much water and is'nt circulating as it's frozen and where the senser is it is still cold. The senser is in the left rear of the engine facing the firewall it has a two wire weathertight connector unplug the senser and with a papaer clip ground the wire and look to see the gauge go all the way if it does the gauge and wire are good and the senser or the water getting to it is'nt hot.

Jan 04, 2011 | 2004 Chevrolet Malibu

2 Answers

94 lumina will not start after getting warm. will turn over but fuel injectors dont work. works during cold weather but not in hot weather.


The check engine light should be on with the engine running. The coolant temperture senser may be open at some temps the fastest way to test this is to change the senser ( it's cheap and a high failure rate part all auto parts stores will haveplenty of this high failure part in stock and they fail many ways. If the car ever overheated it's damaged or truly bad. A very good one will optimize fuel mileage so if it's suspect change it anyway as money well spent a working but wrong senser can cost alot of gas on any fuel injection car or truck, You get what you pay for in temp sensers and the brand name ones are better. All of them are suspect to be bad even when new and ohm test at temperture charts are is repair manuels. Crank sensers and cam sensers also get hot and quit they cost more are harder to change and fail more on the 3.8 motor than the 3.1 or the 3.4. Igiton modules do this too but it sounds like its been doing this awhile and modules and crank sensers don't stay half bad very long. they stop altogrther. Temp sensers can stay bad and work wrong. If you can get a scanner hooks to the car on data stream the senser may show room temp when cold but as it heats up goes up then to -34 thats open the system doesn't know that to do as the air charge temp senser doesn't agree and the system fails to start and will check as flooded. Flooring the gas and hoding it there may start it anyway. The trottle position senser were to show open thats the clear flood mode and the injectors won't fire. Tps voltage should show .5 volt les than 1 volt at idel (it'll start) and 5 volts at full throttle or nearly. if it shows with a scanner of a voltmeter on the center wire 5 volts or 0 it won't start. Coolant senser fails more often and is cheaper

Aug 11, 2009 | Chevrolet Lumina Cars & Trucks

1 Answer

Speedometer senser is jumping erraticaly


I had an Audi doing exactly the same. What happened was that through time, especially if the vehicle gets older with a higher milage, dust and dirt gets into the speedometer itself and causes all the small gears to get sticky. I opened it and lubricated all the small moving parts inside and all were ok. Try it before buying a new speedometer. (I'm talking about the speedometer clock itself) Hope this info might help.
Akirfa

Sep 02, 2008 | 2002 Hyundai Santa Fe

1 Answer

Cam senser


I believe you need to line up the line with the arrow.

Aug 06, 2008 | 1995 Ford Explorer

Not finding what you are looking for?
1997 Saturn SL Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...