Question about Toyota Tundra

Open Question

2000 tundra trys to start up itself

With no key in. truck tried to start itself

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: 2000 tundra v-8

No special processes. Just unplug the wire and remove the bolts. Very easy to do.
I hope that I have helped you and your problem.
The graciousness of a FixYa rating would be most appreciated.

Posted on Nov 18, 2008

dttech
  • 4803 Answers

SOURCE: My 2007 tundra went dead. The ignition won't start

There are several possibilities ranging from a defective starter, to bad cable connections, to the onboard security system locking out the starter relay, or an aftermarket accessory interfering with the starter circuit, or a locked-up/damaged engine.

I have had vehicles towed into my shop for similar complaints when the only problem was that the customer was using a cheap duplicate key that they had made at the hardware store that did not have the required computer chip in it.

I have also had vehicles towed in where the customer had replaced the battery and did not have good cable connections or forgot to connect one of the wires that was supposed to to get hooked-up to the battery connector.

Then there are the questions: Are you getting any kind of "clicking" noises when turning the key or is it completely dead? If it is clicking, WHAT is clicking? Is it the starter motor itself that you hear or just the starter motor relay? Do you have battery power at the starter "S" terminal when turning the key? If not, is the transmission selector in "PARK"? Does the shift indicator on the dash indicate that the transmission range sensor is in "PARK"? (possible defective transmission range sensor) Are there any fault codes stored in ANY of the modules connected to your onboard computer network?

It is really hard to say without being able to see the truck.

Posted on Mar 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My truck will turn over but won't start


Toyota Tundra Maintenance & Repair Questions - CarGurus

www.cargurus.com > Questions > Toyota > Tundra

CarGurusfrustrated2000tundra asked a 2000 Toyota Tundra 2 Dr SR5 V8 4WD Standard Cab LB Maintenance ... My 2000 tundrasr5 4.7l 4x4 wont start! ... 2008 Toyota Tundra ...won't Start ... Report. rckwll asked a 2001 Toyota Tundra Maintenance & Repair question 2 months ago ... 2002 Toyota Tundra Turns Over But Will Not Start.

Toyota Tundra Questions - CarGurus

www.cargurus.com > Questions > Toyota

CarGurusGet fast answers to your Toyota Tundra questions from experts in the CarGurus automotive ... My 2000 tundrasr5 4.7l 4x4 wont start! Thought wasn't getting fuel because tries to turn over but wont. ... Tundra Dead Battery, How Do I Open The Door Or Hood To Recharge? ... 4wd Hi Light Flashing, But Will Not Engage.

Jan 22, 2016 | 2001 Toyota Tundra

1 Answer

2000 tundra engine doesn't start only one "click" sound


Sounds like battery is dead or low on charge possibly from bad battery connections or bad alternator. Check cranking and charging systems.

Aug 14, 2014 | 2000 Toyota Tundra

1 Answer

2000 Tundra why I only hear click sound and nothing start the engine ?


The battery is probably dead and/or bad. Could be corroded battery cable connections. If not any of these then the alternator might be bad (not charging the battery) or the voltage regulator or start relay could be the problem. The start might be bad also.

Aug 14, 2014 | 2000 Toyota Tundra

1 Answer

2000 toyota tundra slow to accelerate, will oly reach 10mph in drive.---- run good in reverse


what is max rpm on engine, at 10mph ?
that is the KEY question. and solves
bad engine
bad tranny
and is first, after checking all fuses. always.

Feb 03, 2014 | 2000 Toyota Tundra

1 Answer

My tundra wont start but all the lights and radio


That might be a possibility. Asssuming when you say it wont start you mean it won't crank over. First check battery voltage at the battery with a dvm when you turn the key to the start position. Then check the voltage at the starter when you turn the key to the start position. If both readings are the same and you must have a reading of at least 12dcv. Try turning the ignition key to the on position( not the start) and jump the positive voltage from the starter to the solenoid terminal. The starter should crank over if the proper voltage is present.If the starter just clicks or just attemps to start. yes, you need to replace your starter

Mar 25, 2010 | 2000 Toyota Tundra

1 Answer

Ignition locking up. can't turn the key and steering wheel locks.so vehicle wont start


Rotate the steering wheel a little bit to take pressure off the ignition switch lock. At the same time, turn the key to start the truck.

Jan 18, 2010 | 2000 Toyota Tundra

1 Answer

Truck starts occassionally.


You need to replace the starter solenoid contacts, or the starter itself.

Note that the starter is UNDER the intake manifold. This is a VERY difficult job, and is not recommended to those who do not have sufficient automotive experience.

If you DO remove the intake, you MUST replace the intake manifold gaskets, or your engine will not run properly, due to air leaks at the intake mating surfaces.

Sep 12, 2009 | 2000 Toyota Tundra

2 Answers

2000 Toyota Tundra starts occassionally. Sometimes starts right a way, sometimes have to turn the ignition key several times before it will fire. Battery good, all terminals cleaned. What should I check.?


Welcome to FixYa! You need to replace the starter solenoid contacts, or the starter itself.

Note that the starter is UNDER the intake manifold. This is a VERY difficult job, and is not recommended to those who do not have sufficient automotive experience.

If you DO remove the intake, you MUST replace the intake manifold gaskets, or your engine will not run properly, due to air leaks at the intake mating surfaces.

Sep 12, 2009 | 2000 Toyota Tundra

2 Answers

Periodic power loss to ignition on 2000 Tundra.


Check the connections on the battery,It sounds like one or both may be loose.

Jun 02, 2009 | 2000 Toyota Tundra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...