Question about 2005 Audi A4

Open Question

2005 Audi A4 hood latch will not work

I see that you need to remove the plastic pan under the car as the first step...what are the rest of the steps?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Technopro
  • 243 Answers

SOURCE: oil pressure warning light on my audi a4 2005

The car has entered into fail safe mode. It wil not allow the engine to rev high but allows you only to get to a mechanic or to get some oil into the engine. What's the level like? Is there any trace of leakeage?

Posted on Nov 23, 2008

Ad
  • 184 Answers

SOURCE: 2005 Audi 1.8 a4 check engine light on and car now spudders??

FYI also when you get those codes you can look them up and get their description at http://www.check-engine-light.com

Posted on Jan 03, 2009

Technopro
  • 243 Answers

SOURCE: I have a Audi 2005 Audi A4 Diesel and this sign

You might need your brakes checked. Check your brake fluid level first and make sure it's on full mark and if it is not, don't add too much but drive carefully to a workshop to have your brakes checked. Cheers

Posted on Mar 26, 2009

  • 3600 Answers

SOURCE: audi a4 bonnet release mechanism broken

This can be over come by getting a pair of vise grips and gripping the cable that is sticking out and pulling it out, once you have opened it Do not attempt to close the hood without replacing the cable. You have maybe only one chance at this so if you don't succeed you will make it harder for a mechanic to fix it. a new cable is not to difficult to replace, buy the cable and housing replace both.

Posted on Jul 07, 2009

  • 1 Answer

SOURCE: 2000 Audi a4 headlight bulb replacement

At least on the driver side, there really is no reason to remove the entire headlight assembly. I was able to swap out the bulb fairly easily but simply removing the dust cap, popping the connector off the bulb, and then undo the clip holding the bulb in place. The just reverse order to install the new bulb. Took about 3 minutes.

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 quattro , battery is dead and hood wont release.Is it an elecrtonic release?


Heidi, No electric release. The latch is probably stuck. While you pull the interior hood release have an assistant push down and pull up repeatably/vigorously until hood releases from stuck position. Lube latch and cable before closing hood. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Open Hood How To 2001 2005 Audi Allroad Quattro 2002 Audi Allroad Quattro...
2007 Audi A4 2 0t hood latch fix when you can pop the hood
Hood Latch Release Cable Broken How to open hood
Help Hood release cable disconnected somewhere any ideas how to open hood...

Apr 15, 2016 | 2005 Audi Allroad Quattro

1 Answer

2001 A4 thermostat location


Hello! Ignore my request regarding the engine size, The thermostat is well hidden..Standard labor to replace is 2.0 hours...Thermostat is part # 06B-121-111-G....
Step 1: Drain coolant...

Remove bottom belly pan... Remove coolant reservior tank cap... Remove plastic clip holding coolant sensor in place at lower radiator hose/pipe... With bucket/catch pan underneath, remove sensor and let coolant drain...


Step 2: Remove upper radiator hose...

Remove the small hose connecting the coolant reservoir to the upper radiator hose... Then remove the larger hose from the hard pipe running along the intake and from the radiator... You'll need to pop up (but not off) the metal clip holding the hose to the radiator, then firmly pull back..

Step 3: Remove intake hose (throttle body to inter-cooler)...

Remove driver's side headlight (not necessary but makes it a lot easier). Loosen clamp at each end and remove hose...

Step 4: Remove throttle body...

Remove electrical connector and 4 hex bolts (5mm)...

Step 5: Loosen serpentine belt and slip off of alternator...

Use a box-end or adjustable wrench on tensioner, pull to the right... Carefully slip belt off alternator (towards front of car). Allow to hang loose below...

Step 6: Remove alternator bolts...

Remove 4 bolts holding alternator to bracket...

Step 8: Remove vertical support piece from intake manifold to block...

Remove the two bolts holding the support piece (6mm hex)...

Step 9: Remove bolt from metal hose on thermostat; remove bolt from top of oil cooler...

This will allow you to move the hard pipe away from thermostat... Then wiggle it free from the pipe afterwards...

Bolt holding the hard pipe on the right, two bolts holding the thermostat to the block on the left...

Step 10: Remove upper and lower hoses from t-stat. Remove electrical connector on back side...

Step 11: Remove 2 bolts holding thermostat to block, and remove thermostat...See photo below...Guru...Saailer







10_23_2011_1_16_37_pm.jpg

Oct 23, 2011 | 2001 Audi A4

1 Answer

Where is the thermostat on my 2002 audi a 4 located


Hello,

The thermostat of a 2002 audi a4 is located between the engine and the radiator. The thermostat is small and crucial. It is meant for the vehicles cooling system. It moderates the flow of coolant into the engine by releasing it when the engine need it the most. The thermostat is designed to open its valve once the temperature of the engine reaches about 200 degrees F. Its purpose is to keep the engine running at a consistent temperature, allowing your Audi A4 to operate at peak performance.

If You are planning on replacing the thermostat, here are the steps to follow to replace them, try to get these instruments (Car ramps, 4-by-4 inch wood block, Metric socket wrench set, Socket extension, Pliers, Drain pan, Empty plastic container, Black marker, Towel, Emery cloth, Gasket seal) then follow the steps below:
  1. Raise the front end of your Audi A4 by driving up on a set of car ramps and placing your vehicle in park.
  2. Place a 4-by-4 inch wood block behind one of the rear tires to keep the vehicle from rolling backward.
  3. Use a socket wrench to remove the pan that covers the bottom of the engine.
  4. Locate the red plastic cap that was behind the pan that you just removed. This red cap is your radiator drain plug. Remove the radiator cap from the top of the radiator and then place a drain pan under the red drain plug and turn it with a pair of pliers to allow the coolant to drain completely from the radiator. Once the coolant has completely drained, turn the drain plug to close it off. Be careful when using the pliers on the drain plug that you do not snap the plug off.
  5. Slide under the vehicle and locate the thermostat housing that is sitting just above the oil pan drain plug. Pour the drained coolant from the drain pan into an empty plastic container and label the container so that you do not reuse the expelled coolant. Place the empty drain pan under the thermostat housing before you attempt to remove the housing to allow the coolant from the engine to drain into it.
  6. Remove the 10 mm bolts that hold the thermostat housing on the engine block with a metric socket wrench. Do not lay directly underneath the thermostat housing as the coolant from the engine will begin to drain as soon as you loosen the bolts on the housing. Keep a towel or cloth with you to clean off any spilled coolant .
  7. Remove the thermostat housing from the engine and lift the old thermostat out of the housing. Use a piece of emery cloth to clean the face of the thermostat housing and the engine block where the housing is mounted from any remaining gasket material or debris.
  8. Spread a layer of gasket seal around the face of the thermostat housing and place the new thermostat on the housing, with the thermostat spring facing out from the housing. Position the housing back on the engine block and secure it to the block with the bolts.
  9. Replace the pan the sits across the bottom of the engine of your Audi A4 and then refill the radiator with coolant and put the radiator cap back on the radiator. Remove the wood block from the back tire of your vehicle. Turn the engine on and drive the Audi A4 off of the car ramps. Allow the engine to run at idle for a few minutes to verify that the thermostat is working properly and then shut the engine off.
Hope this helped. Thank You for using FixYa!!!

Jan 27, 2011 | 2004 Audi A4

1 Answer

I can "release" the hood on my 1999 Audi A4 from


Yes, you will be able to open the hood if you pull off your splash guard and use a long long flat head screwdriver or something like that. You'll see the hood latch in front of the radiator with the cable attached to it at the top near the hood, put it on the drivers side edge of the bottom of the latch and pry to the passenger side, the lever moves from the drivers side to the passengers side, the cable basically pulls the top of it to achieve this. so your doing the same thing on the bottom with the screwdriver.

tdisline_0.jpg
Release the latch from underneath by the lever that you have to pry towards the passenger side. Then open the hood, and repair or replace the safety release mechanism. This is very simple to remove out from the hood.

Nov 03, 2010 | 1999 Audi A4

1 Answer

Cobalt 2005 ls headlight bulb replacement


Instructions Things You'll Need:
  • 9007 LL halogen headlight bulb
  • Wrench
  • Gloves or clean rag
  1. Step 1 Set the parking brake and remove the keys from the ignition to ensure your Chevy Cobalt won't roll while you're replacing the headlight bulb.
  2. Step 2 Open the hood by pulling the hood release latch located under the instrument panel on the driver's side of the car. Locate the secondary release latch on the front of the hood at the center, slightly towards the driver's side. Slide the latch to the left to release the hood and raise it.
  3. Step 3 Locate the headlight assembly and remove the bolts by turning them counterclockwise. Set the bolts aside in a safe place, so you won't misplace them.
  4. Step 4 Remove the plastic fasteners from the headlight assembly molding. Carefully pull back the front fascia, or molding. You may need an extra pair of hands to perform this slightly awkward task.
  5. Step 5 Grab the headlight assembly and pull it towards the radiator at a slight angle to remove it. This should provide easier access to the headlight bulb and wiring harness.
  6. Step 6 Lift the plastic locking tab on the wiring harness to disconnect the bulb base. Then, disconnect the wiring harness from the bulb socket and remove the black retainer by turning it counterclockwise.
  7. Step 7 Disconnect the bulb socket by turning it counterclockwise. Remove the old bulb from the socket by firmly, but gently pulling it straight out.
  8. Step 8 Replace the old bulb with a new 9007 LL halogen headlight bulb. Put your headlight assembly back together by reversing the steps when you disassembled it. Use 89 inch-lb torque when retightening the headlight assembly

Feb 26, 2010 | 2006 Chevrolet Cobalt

1 Answer

Hood won't open


first, try smacking the hood at one of the front corners while someone else pulls the release handle. or even after you've pulled on it. if that works, once open, adjust and lubricate the hood latch assembly. if it still won't open, and it's the cable and not the latch you'll have to replace it anyway, so instead of removing the grill, cut the cable behind the pull lever under the dash where you can reach it. then skin the outer cable insulation away from the actual steel cable exposing an inch or two of it. then holding the insulation and plastic housing with pliers, grab the steel cable itself with pliers and pull it to open the hood. then replace the cable. the further you can reach up under the panel the better your chances of getting past the broken part of the cable and avoid removing the grill. you might also be able to gain access from up under the car if you're lucky.

Jan 05, 2010 | 2002 Audi A4

3 Answers

Trying to open audi a4 bonnet, removed from grill and srews but can't get the third one which is right back, lever moves up and down no problem but looks to be catching


I took a long thin screwdriver and slid it under the bonnet and pressed it against the latch release and give the screwdriver a good whack and that freed the latch so the bonnet could open.. then I lubed the latch like crazy and it's been working ever since

Aug 10, 2009 | 2005 Audi A4

1 Answer

Where can i find step by step diagrams on how to fit serpentine belt on audi b5 a4,can anyone help please?


There should be a sticker some where under the hood. Have you found it?

May 11, 2009 | 1998 Audi A4

1 Answer

Audi tdi 2004 window wont go up or down


Remove all screws, some will be hidden under plastic taps like on the pull strap. Take a door panel tool and work it around the panel to find the plastic pins that hold the panel on then use the tool to pop them out. Real simple job, just pay attention. The problem is most likely a bad window motor.

Apr 24, 2009 | 2004 Audi A4

1 Answer

Need to remove front grill to open the hood?????


JACK UP YOUR CAR AND REMOVE THE RETAINING BOLTS THAT HOLD ON THE PLASTIC UNDER TRAY.AND NOW YOU CAN GET AT THE LOCKING MECHANISM ITS SELF..............(NO DAMAGE)...........

Apr 09, 2009 | 2005 Audi A4

Not finding what you are looking for?
2005 Audi A4 Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...