Question about 2005 Hyundai Terracan

Open Question

P0320 error

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ford f150 Manuel trans. Code p0320 is it a expensive repair? Stutters while in gear 3/4 but doesn't stall. Just started a few days ago


P0320 means that an ignition pulse that's supposed to fire a spark plug was missed. It could be as simple as a chafed wire under the hood. Watch this video:


Ford has some information too:
P0320 2000 Ford F150 Ignition Distributor Engine Speed Input Circuit...

Oct 02, 2015 | Ford Cars & Trucks

2 Answers

Went to Deq for emissions test and the diagnostic codes read p0320 on 2004 Hyundai sonata what needs to be replaced?


P0320 =no signal detected from crankshaft position sensor during cranking, my guess is replace the CPS

Feb 24, 2015 | 2004 Hyundai Sonata

1 Answer

P0320 '06 kia optima


P0320 Ignition/Distributor Engine Speed Input Circuit Malfunction. Most likely an ignition module or coil.

Aug 31, 2012 | 2006 Kia Optima

3 Answers

Error code p0320


P0320 Ignition/Distributor Engine Speed Input Circuit Malfunction Check the connection and wiring to the CKP sensor. Be prepared to replace this sensor

Jun 10, 2011 | 2005 Hyundai Sonata

1 Answer

I have a 2004 Jeep grand cherokee 6.0 4WD and a code P0320 came on what is that. My car will turn on then after a while if will turn OFF please help ......


p0320 is-- ignition/dist, engine speed input curcuit malfunction. Check the two hoses on either side of the engine that go to the intake. Any kinks or cracks will give crank error. I beleive you have a bad crank sensor. not sending signal to pcm. crank sensor symtoms-- No RPM Signal to PCM . also check wires to crank sensor.

May 13, 2011 | Jeep Grand Cherokee Cars & Trucks

2 Answers

Trouble code P0320 ignition/dist. engine speed input circuit


P0320 - Ignition / distributor engine speed circuit malfunction

The ignition engine speed sensor input signal to Powertrain Control Module (PCM) or Electronic Control Module (ECM) is continuously monitored. The test fails when the signal indicates that 2 successive erratic profile ignition pickup (PIP) pulses occurred.

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- The engine may be harder to start
- The engine may stumble or stall

When is the code detected?
The P0320 code is triggered when 2 successive erratic PIP pulses are detected.

Possible Causes:
- Loose wires/connectors
- Faulty Crank Position Sensors
- Arcing secondary ignition components (coil, wires and plugs)
- Low battery charge
- Powertrain Control Module

Possible Solutions:
- Resecure loose wire or connectors
- If battery charge is low, recharge or replaced battery
- Replaced crank position sensor
- Replaced starter motor


Test it and tell us news.

Nov 18, 2010 | 2004 Ford Explorer

1 Answer

I have code P0320 and P0340 on my jeep liberty what does this mean


P0320 Ignition Engine Speed Input Circuit malfunction

P0340 Camshaft Position Sensor Circuit malfunction

Apr 15, 2010 | 2003 Jeep Liberty

2 Answers

I am getting the codes p0320 and also the code p1299 the truck is shutting down when driving down the road sometimes will start right back up and sometimes you have to wait for a bit and then drive for...


Hello

The codes you are getting:

P1299
- Cylinder Head Over Temperature Protection Active Indicates an engine overheat condition was detected by the cylinder head temperature (CHT) sensor. An FMEM Strategy called Fail-safe Cooling was activated to cool the engine. Engine cooling system concerns

Causes:
Low engine coolant level
Base engine concerns


P0320 - Ignition Engine Speed Input Circuit Malfunction - The ignition engine speed sensor input signal to PCM is continuously monitored . P0320 indicates that two successive erratic profile ignition pickup ( PIP ) pulses have occurred

causes: loose wires / connectors , arching secondary ignition components ( coil , wires , + plugs ) , on board transmitter ( 2 - way radio )

This is the explanation for the error codes you are receiving, at least it is a good place to start looking for the problem. Hope this can help you.

Kind regards
Andrea

Nov 13, 2009 | 2002 Jeep Liberty

1 Answer

Fault code


P0320 Ignition/Distributor engine speed input circuit
countrycurt0

Sep 05, 2008 | 2000 Ford Focus

Not finding what you are looking for?
2005 Hyundai Terracan Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...