Question about Chevrolet Equinox

Open Question

Chimes sound when driver door is opened on 2005 Equinox

Had to have the ignition switch replaced. Now, when the driver's door is opened, the chimes sound until it is closed. How can I turn the chimes off?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 15 Answers

SOURCE: Door chimes sound when key is out of the ignition

Perhaps your battery is in need of replacing, in the Handheld Ponder?

Posted on Jun 06, 2009

Ad
harley9701ha
  • 424 Answers

SOURCE: chimes ring when you open drivers side door no keys in ignition

Sounds like the contact for the key chime in the steering column is shorted to ground. The only way to get the contact is to buy the clockspring. If you can live with it leave it alone. The clockspring is labor intense. You have to remove the airbag,steering wheel, and trim around column. If you ar mechanically inclined you could just disconnect it by cutting the wire going to the chime. It is under the key tumbler. I hope this helps.

Posted on Jul 09, 2009

  • 61 Answers

SOURCE: 2007 HHR Radio and chimes not working

Check the radio fuse. As unusual as it seems, GM has started having the radio (even though not turned on) generate the chimes and turn signal sounds. If the radio fails, all the chimes fail too.

This applies to other vehicles besides the HHR. My 2003 Silverado had the door chimes fade down so I could barely hear them. The fix was to replace the radio (under warranty, fortunately...).

Posted on Mar 22, 2010

hepcars
  • 1249 Answers

SOURCE: My Chevy Venture 2003 door

Sometimes the ignition key does not "deactivate" when removing the key...try wiggling the washer behind where the key goes...sometimes this sticks...:)

Posted on Dec 08, 2010

  • 219 Answers

SOURCE: open door chimes and keys left in in car chimes

Door left open chime is operated by your interior light switch. It is located in a few places on different vehicles. Often in the door jam at the front or low down on the pillar at the rear of the door. You will notice a little black rubber boot and when you push it it goes in and out. That is your interior light switch.

Posted on Oct 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Disable seatbelt chimes,will not go off, since driver door been replaced.


Sounds like the door switch is not switching or not connected. Sometimes the switch is external in the door jamb/closing area, sometimes it is part of the door catch. Maybe check if the door light on the dash stays on, also if the interior light works on door setting.

Jun 24, 2015 | Cars & Trucks

1 Answer

98 Ford Explorer. No chime sounds when keys left in ignition and driver door open. Also no chime that lights are on. Passenger door chimes when opened and key in ignition.


Bad door switch, or it may be dirty and "stuck" in the recessed position as it would be when the door is closed. I find WD-40 or equal is a good solution for this. Otherwise the switch's connections are bad (corrosion) or the switch itself is bad. More extreme is a break in the wiring to the switch and or connection near the fuse.

Mar 26, 2015 | 1998 Ford Explorer

1 Answer

No chimes on 2005 silverado


sounds messed up but is the door sensor working correctly?some of the electronics works off of the vehicle drivers door sensor, to tell it when you get in and out.

Nov 13, 2013 | 2006 Chevrolet Silverado

1 Answer

Ford ZX2 courtesy lights and chimes


Sounds like a problem with the sensor in the driver's door latch.

Jun 28, 2013 | 2002 Ford ZX2

1 Answer

How do you stop door chimes from going off on a 2005 kia sorentor


Scan the body module to see what door is "open". Then check or replace that door switch.

Aug 07, 2012 | 2005 Kia Sorento

1 Answer

My door chime does not ding when the key is in the ignition and the door is open


Do the interior lights come on when door is open? If not, you need to check driver's door jamb switch. The driver's door control module could also be the problem. If the interior light do come on, then I would suspect the ignition switch.
You haven't changed out the radio recently? All chimes go thru the radio.

Sep 05, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

My Chevy Venture 2003 door chime on drivers side chimes without key in ignition with door open. Before this happened my dash lights acted funny and then went out. When I shut off the van and opened the...


Sometimes the ignition key does not "deactivate" when removing the key...try wiggling the washer behind where the key goes...sometimes this sticks...:)

Dec 08, 2010 | Chevrolet Venture Cars & Trucks

1 Answer

I have a 1999 Olds Intrigue, headlight left on alarm is stuck


The Body Control Module (BCM) controls the audible warnings. Refer to Body Control System Description in Body Control System for more information regarding the BCM.
The body control module (BCM) controls these reminders:
• Key in ignition reminder: An audible warning intended to remind the driver that the key has been left in the ignition cylinder. The BCM sounds the chime for this reminder at a rate of 150 chimes per minute.
• Fasten seat belt reminder: An audible warning intended to remind the driver at the beginning of the driving cycle that the driver's seat belt is unfastened. The BCM sounds the chime for this reminder at a rate of 50 chimes per minute.
• Fasten belts indicator control: A visual warning intended to remind the driver that the driver's seat belt is unfastened.
• Parking brake reminder: An audible warning intended to remind the driver that the parking brake has been left applied with the transaxle shifted out of PARK. The BCM sounds the chime for his reminder at a rate of 200 chimes per minute.
• Turn signal reminder:
An audible warning intended to remind the driver that the turn signal has been left on while the vehicle has traveled over 1.2 km (¾ mile). The BCM sounds the chime for this reminder at a variable rate (in unison with the turn lamps on) of 90 chimes per minute.
• Headlamps ON reminder: An audible waring intended to remind the driver that the headlamps have been left on. The BCM sounds the chime for this reminder at a rate of 200 chimes per minute.
• Last door closed locking confirmation: An audible warning intended to provide the driver feedback that the last door closed locking feature is active. The BCM sounds the chime for this remainder at a rate of 200 chimes per minute.
• Feature customization and diagnostics feedback: An audible feedback used when changing feature customization modes. Also used by service technicians during the BCM diagnostics. The BCM sounds the chime during the feature customization, and also during diagnostics. Refer to Body Control Module (BCM) for additional information.

Step
Action
Value(s)
Yes
No
1
Was the BCM diagnostic system check performed?
--
YES - Go to Step 2
NO - Go to Diagnostic System Check - Body Control System in Body Control System
2
Check for Powertrain Control Module (PCM) Diagnostic Trouble Codes (DTCs). Refer to Powertrain On Board Diagnostic (OBD) System Check (LX5) or Powertrain On Board Diagnostic (OBD) System Check (L36) in Engine Controls for more information.
Are there any PCM DTCs present?
--
Go to Appropriate DTC Table in Engine Controls
Go to Step 3
3
Connect a scan tool to the Data Link Connector (DLC).
Using scan tool, select BCM data display inputs and monitor the park brake switch input.
While observing the scan tool, apply and then release the park brake.
Does the scan tool indicate that the park brake input is off while the park brake is released?
--
Go to Step 7
Go to Step 4
4
Turn the ignition switch off.
Disconnect the scan tool from the DLC.
Disconnect the BCM connector C1.
Release the park brake.
Using a test light, connect between B+ and the BCM connector C1 terminal D5.
Is the test light off?
--
Go to Step 7
Go to Step 5

Your best bet ,take it to a qualified repair shop

Aug 01, 2017 | 1998 Chevrolet S-10 Pickup

1 Answer

Chimes ring when you open drivers side door no keys in ignition


Sounds like the contact for the key chime in the steering column is shorted to ground. The only way to get the contact is to buy the clockspring. If you can live with it leave it alone. The clockspring is labor intense. You have to remove the airbag,steering wheel, and trim around column. If you ar mechanically inclined you could just disconnect it by cutting the wire going to the chime. It is under the key tumbler. I hope this helps.

Jul 09, 2009 | 1996 Ford Windstar

1 Answer

Warning bell won't stop sounding


Section 13-09: Gauges, Warning Devices — Chime System 1996 Windstar Workshop Manual
DESCRIPTION AND OPERATION Warning Chime Systems Three distinct sounds are used to indicate the area of concern. Seat belt warning generates 1 chime per second
key-in-ignition generates 2 chimes per second
headlight on generates 4 chimes per second.
Key-In-Ignition Warning The key-in-ignition warning will sound when the driver's front door (20125) is opened with the key in the ignition switch. It will continue to sound until the key is removed, the front door is closed, the ignition switch is turned to START or the vehicle speed is over 24 kmh (15 mph).

Safety Belt Warning When the ignition switch is turned to RUN or START from OFF or ACC, the chime will sound for six seconds or until the safety belt is buckled.
  • The safety belt warning indicator lamp (10C859) will activate for 60 seconds or until the driver's safety belt is fastened. Both the chime and lamp activate at the same time.
Anytime the ignition switch is released from START and returns to RUN while the safety belt lamp or chime is activated, the safety belt warning lamp or chime will remain activated until either the timing sequence has been executed, or the safety belt is buckled.

Headlamp Switch On Warning The chime will be activated if the headlamps or parking lamps are ON, the key is not in the ignition and the driver's door is opened. The chime will sound at a rate of four per second.

Apr 23, 2009 | 1996 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...