Question about Toyota Camry

Open Question

2005 toyota recirculate air button does not work

Air recirculate button not working

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
salvidordali
  • 103 Answers

SOURCE: bulbs not working on a/c and recirculation buttons

The switches have to be removed and the bulbs are on the back of the switch. they look like a grey plastic screw. the bad news is that they are a dealer only item.

Posted on Jan 09, 2009

Ad
  • 1861 Answers

SOURCE: 2005 Toyota Corolla air conditioner is cold but

The air flow does not 'increase' with the recirc button pressed. The fan motor blows at specific speeds, no matter whether fresh or recirc is selected. The recirc feature is there so that you do NOT admit 'fresh/hot' air from the outside into the AC box. In short, the recirc feature is to re-use, or, recirculate the existing air in the car. When it is properly working, on a hot day, the recirc selection should drop the internal temperature at the center air vent about 6 degrees lower than with the fresh selected.

Posted on Jul 19, 2009

SOURCE: the heaters on my 2005 hyundai santa fe have

dear friend-it is basicly impossible that no air can enter unless the duckting pipes is completely blocked,your heater valve control the hot and cold air as it is only a two way switch,the air-con make use of the same tunnels but will not come on if there is no gas in the system.

Posted on Nov 05, 2009

  • 1 Answer

SOURCE: Air Conditioner Will not turn on Recirculation

there is a selector motor on the side of the heat ac coil box under the dash. it should have 2 or 3 levers on the side of it. it controls the dampeners the select where your air is moving to from the defrost to the bi level to the floor or all of the above find that control module and then turn the car on and start moving the selector switch back and forth slowly while watching that module if its moving the levers then you have a more serious problem and need to have a professional look at it. check to make sure that the levers are even connected and that the wiring harness is even hooked to the control module

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Dual Zone Air system will not flow recirculated A/C air to Driver's side of my 2005 Toyota Avalon Limited.


The controller that directs the flow of air to various vents has an issue - it may have to be replaced.

Sep 27, 2016 | 2006 Toyota Avalon Limited

Tip

Toyota Air Conditioners


This tip pertains to maximizing the cooling efficiency from your Toyota's Air Conditioning system.

(The info that follows is for vehicles that are not equipped with "Auto" AC.)

On really warm days, nothing is better than getting in a hot vehicle, and turning on the AC for a nice comfortable driving experience.

In our service facility, we continually see customers who are not totally satisfied with their AC output. Hopefully, this tip will address those issues, and just might be useful to you.

The number one reason for poor cooling with the AC on, is neglecting to select the "Recirculate" function on the heater/AC control panel.

What is Recirculate?
That mode is where the AC system 'recirculates' the air contained in the car, thru the AC box, over and over, until the desired temperature is reached. The Recirculate button, knob, lever or slide is easily identified by seeing a picture of a little car, with an arrow doing a 'U-Turn" inside the car. This is the opposite of the "Fresh" mode, which is an arrow going 'straight through' the little car icon.

If you are using the "Fresh" mode, you are actually admitting ambient air into the car. Ambient air is much warmer, and makes the AC work harder, and you will see a 10 degree rise in the air temperature from the dash vents. Also, some vehicles admit the 'Fresh' air from under the hood, so, leaving the 'Fresh' mode selected could actually draw in the much hotter underhood air into the AC system.

So, what to do? Anytime you use the AC, please verify that the Recirculate function has been selected. As stated above, this uses the air in the car over and over, and your cooling efficiency will be 10 degrees colder. You can easily check and verify this with an 'instant-read' thermometer. Put the thermometer in the center dash vent, start up the car, turn on the AC, select Recirculate, and watch the temperature drop. It should stop dropping around 34-36 degrees F (depending on humidity, sun load, and a few other things). Now, when the temperature is as low as it will reach, turn off the Recirculate device. You will see the temperature actually rise, maybe 10-12 degrees.

Some additional info: As long as the car is in Recirculate mode, the AC compressor will eventually turn off, when the interior makes the selected temperature. This saves you gas. If you run the AC with the fresh mode selected, the AC compressor runs all of the time. This wastes gas, and costs you more money.

The best way I can easily sum up Fresh versus Recirculate is this:

Running the car with 'Fresh' selected is like running your refrigerator with the door open. It works, but it does not work good. Choosing 'Recirculate' is like running the fridge with the door closed.
If this tip helps you, please leave a positive helpful rating. Thanks!

on Jul 17, 2010 | Toyota Corolla Cars & Trucks

1 Answer

Inside cab blows out hot air controls are off but air still comes out


OUTSIDE AIR: Press this button to direct the system to use outside air.
Pressing the OUTSIDE AIR button will cancel the RECIRCULATION button.

RECIRCULATION: Press this button to limit the amount of outside air entering your vehicle.
This is helpful when you are trying to limit odors entering your vehicle or attempting to quickly cool down the interior. Pressing RECIRCULATION will recirculate air continuously.

RECIRCULATION is used when the fan control is OFF to limit odors, outside air and dust from entering your vehicle. All button lights will go off. The last setting selected will activate when the blower is turned back on.
Pressing the RECIRCULATION button will cancel the OUTSIDE AIR button. To return to normal operation and to prevent stale air, be sure to return the OUTSIDE AIR.

Between HEATER and BLEND mode, outside air is forced to reduce window fogging. If the RECIRCULATION button is pressed, the LED indicator will flash three times indicating that forced outside air is activated and RECIRCULATION is not available.

I think what your experiencing is normal. If you want to keep cold air form coming into the cabin, press the recirc button.

I hope this helped, icon_e_biggrin.gif

Aug 23, 2014 | 2001 Chevrolet Blazer

1 Answer

2005 Toyota Tacoma PreRunner- A/C Blower Noise


That is the acuator motor,make it a hobby in replacing this cause you are going to be doing it all the time, when you get a new one then you will know why8_12_2012_9_36_27_am.jpg

Aug 11, 2012 | 2005 Toyota Tacoma PreRunner

1 Answer

If you push the "recirculate air" button the air


now i do know that on some vehicles i dont know about yours but the air recirculation only works in certain switch locations.

Jan 11, 2011 | 2005 Ford Five Hundred

2 Answers

Fan (blower for interior) only works on high setting all other settings basically turns the fan off. Air conditioning still works. There is not air flow at all on the settings (other than high) when the...


The fan speed resistor is the problem........when you are on full speed the current bypasses the resistor and this is what gives you the fastest speed from the fan motor.......on 1, 2, or 3 speed setting, it is directed through the fans speed resistor circuit

It is located in the air box behind the glovebox on the interior of the car passenger side

Aug 30, 2010 | 2000 Toyota Camry

1 Answer

2005 Toyota Corolla air conditioner is cold but


The air flow does not 'increase' with the recirc button pressed. The fan motor blows at specific speeds, no matter whether fresh or recirc is selected. The recirc feature is there so that you do NOT admit 'fresh/hot' air from the outside into the AC box. In short, the recirc feature is to re-use, or, recirculate the existing air in the car. When it is properly working, on a hot day, the recirc selection should drop the internal temperature at the center air vent about 6 degrees lower than with the fresh selected.

Jul 18, 2009 | 2005 Toyota Corolla

1 Answer

Recirculate button not working


either your heater conrol head with the recirc button is bad, or the motor that opens and closes the inside/outside air door.

Jan 31, 2009 | 2006 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...