Question about 1995 Ford Taurus

1 Answer

No spark car cranks over but will not start, no spark and no fuel

Posted by on

Ad

1 Answer

No injector pulse either ?

You could try a crank sensor

But I'm NOT saying that is your problem

I only replace parts when they fail a test

Check for codes first & always

Posted on Apr 02, 2014

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 120 Answers

SOURCE: The car cranks but no start, fuel is fine, no

coil needs replaced.

Posted on Aug 24, 2009

Testimonial: "Thanks for your help, I should have mentioned I changed the coil, I thought the same thing "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

I have a v6 1985 gmc s15 sierra it turns over strong but wont crank


No, it cranks over strong but won't start an run is the right way to state that. Now then , did you check for spark , fuel pressure ? No Start Diagnostic Basics EricTheCarGuy

Dec 21, 2016 | GMC Cars & Trucks

2 Answers

Replaced bad coil van cranks but wont start?


Sure the new coil is working? Did you check for spark?Is the fuel pump working? Fuel injectors? ECM?

Feb 21, 2016 | 2005 Chrysler Town & Country

2 Answers

My car cranks but will not start RVR GDI mitsubishi


Check all fuses first, then with an assistant, check for spark with a spark tester. if there is spark at 2 plugs, check for fuel pressure at the fuel rail with a gauge. Engines need three things to run, fuel, spark, and compression. If there is spark and fuel, do a compression test, if the timing belt jumped/broke, you won't have any

Mar 03, 2015 | Mitsubishi Cars & Trucks

1 Answer

Low voltage


does it crank fast, at 250 spec RPM?
no year, no joy, all cars have a year,
and and engine option (displacement size???)
my wild guess, is it wont crank or cranks dead slow.
right?
and the battery is DISCHARGED. right,
use jumper start cables. start now?
that be first.

wont crank
cranks perfectly but wont start ?(check for spark, x number of cyl)
spark good, try test fuel
test fuel works for 3seconds and stalls,. then fueling problem , ask.

Jan 21, 2014 | Suzuki Grand Vitara Cars & Trucks

1 Answer

Car not starting


Fuel, spark and air. You are missing one of them you need to test for spark ,and fuel crank the engine then go to the fuel injector rail on the rail is a cap remove the cap and you will see a shrader valve just like your tire valve stem use a pointy object like a screw driver and press does fuel come out if it just dribble out well you need to test for fuel pressure. Better yet have someone crank the vehicle and you should be able to hear the fuel pump get activated you you do trouble shoot for spark. Your system uses a crank sensor it that crank sensor fails you get no spark. or even the ignition module may have failed pull one of the plug wires let it touch body ground about 1/4 inches away have some one crank it you should see spark jump out. if you dont troubleshoot for no spark condition

Feb 24, 2012 | 2005 Chevrolet Malibu

1 Answer

Van cranks but will not start


Hi, if the engine cranks over normally when you attempt to start you car, but the engine does not start, the problem may be NO FUEL, NO SPARK or NO COMPRESSION. The engine needs adequate fuel pressure, a properly timed spark and normal compression to start.

To find why the engine won't start, remove the air inlet tube from the throttle body, push the throttle open and spray a small amount of aerosol starting fluid into the engine. Crank the engine. IF it has spark and compression but NO FUEL, it will start and run a few seconds before dying. If it does NOT start, it probably has NO SPARK.

Another method to check for spark is to pull a spark plug wire off of a spark plug (if it has plug wires, coil-on-plug ignitions do not) and place the open end of the plug wire near a metal surface on the engine. Have a helper crank the engine while you watch for a spark. DO NOT hold the wire while doing this as it can shock you. If you see a spark, the problem is not spark, but most likely NO FUEL or NO COMPRESSION. If you do not see a spark, the problem is in the IGNITION CIRCUIT.

Proper fuel pressure is critical for fuel injected engines to start and run. You should hear the fuel pump inside the fuel tank buzz for a couple of seconds when the ignition is turned on (no buzz means the pump is not running and the engine is not getting fuel). You can smell the tailpipe for gasoline vapors after cranking the engine. If you smell gas, the problem is likely not fuel but NO SPARK. You can also remove the plastic cap and press the schraeder valve test fitting on the fuel rail to see if there is any fuel pressure to the engine (not a very accurate test because fuel pressure must be at a certain level for the engine to start, for that you need a gauge). Even so, no fuel at the fuel rail would tell you fuel is not getting to the engine.

Dec 22, 2010 | 1996 Chrysler Town & Country

2 Answers

My vw will crank but will not start running i


Hi,


If the engine cranks over normally when you attempt to start you car, but the engine does not start, the problem may be NO FUEL, NO SPARK or NO COMPRESSION. The engine needs adequate fuel pressure, a properly timed spark and normal compression to start.


1) To find why the engine won't start, remove the air inlet tube from the throttle body, push the throttle open and spray a small amount of aerosol starting fluid into the engine. Crank the engine. If it has spark and compression but NO FUEL, it will start and run a few seconds before dying. If it does NOT start, it probably has NO SPARK.

2)Another method to check for spark is to pull a spark plug wire off of a spark plug (if it has plug wires, coil-on-plug ignitions do not) and place the open end of the plug wire near a metal surface on the engine. Have a helper crank the engine while you watch for a spark. DO NOT hold the wire while doing this as it can shock you. If you see a spark, the problem is not spark, but most likely NO FUEL or NO COMPRESSION. If you do not see a spark, the problem is in the IGNITION CIRCUIT.

3)Proper fuel pressure is critical for fuel injected engines to start and run. You should hear the fuel pump inside the fuel tank buzz for a couple of seconds when the ignition is turned on (no buzz means the pump is not running and the engine is not getting fuel). You can smell the tailpipe for gasoline vapors after cranking the engine. If you smell gas, the problem is likely not fuel but NO SPARK. You can also remove the plastic cap and press the Schroeder valve test fitting on the fuel rail to see if there is any fuel pressure to the engine (not a very accurate test because fuel pressure must be at a certain level for the engine to start, for that you need a gauge). Even so, no fuel at the fuel rail would tell you fuel is not getting to the engine.


Thank you!!

Jun 30, 2010 | 2001 Volkswagen Passat

3 Answers

"Cranks, but won't start". Replaced fuel pump, CKP, ICM & nothing


If the engine cranks over normally when you attempt to start you car, but the engine does not start, the problem may be NO FUEL, NO SPARK or NO COMPRESSION. The engine needs adequate fuel pressure, a properly timed spark and normal compression to start.


1) To find why the engine won't start, remove the air inlet tube from the throttle body, push the throttle open and spray a small amount of aerosol starting fluid into the engine. Crank the engine. If it has spark and compression but NO FUEL, it will start and run a few seconds before dying. If it does NOT start, it probably has NO SPARK.

2)Another method to check for spark is to pull a spark plug wire off of a spark plug (if it has plug wires, coil-on-plug ignitions do not) and place the open end of the plug wire near a metal surface on the engine. Have a helper crank the engine while you watch for a spark. DO NOT hold the wire while doing this as it can shock you. If you see a spark, the problem is not spark, but most likely NO FUEL or NO COMPRESSION. If you do not see a spark, the problem is in the IGNITION CIRCUIT.

3)Proper fuel pressure is critical for fuel injected engines to start and run. You should hear the fuel pump inside the fuel tank buzz for a couple of seconds when the ignition is turned on (no buzz means the pump is not running and the engine is not getting fuel). You can smell the tailpipe for gasoline vapors after cranking the engine. If you smell gas, the problem is likely not fuel but NO SPARK. You can also remove the plastic cap and press the schraeder valve test fitting on the fuel rail to see if there is any fuel pressure to the engine (not a very accurate test because fuel pressure must be at a certain level for the engine to start, for that you need a gauge). Even so, no fuel at the fuel rail would tell you fuel is not getting to the engine..

Aug 27, 2009 | Chevrolet Camaro Cars & Trucks

Not finding what you are looking for?
1995 Ford Taurus Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5581 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...