Question about 2004 Dodge Dakota

2 Answers

HIGH IDLING Replaced thottle body sensor, did not take of the problem

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 223 Answers

Check the idle cable...you should be able to adjust it by a bolt.

Posted on Jun 15, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 986 Answers

Try fixing the idleing problem by replacing IAC ( Idle Air Control )sensor

Posted on Jun 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loss of throttle


That error is not the O2 sensor. It is tjhe throttle or gas pedal postion sensor. It is on the floorboard attached to the foot feed for the throttle. IT gets dirty, wet, loose etc. Check it, clean it, reseat it and if all else fails...replace it.

Mar 29, 2014 | 2004 Subaru Outback 2.5

1 Answer

Engine idle extremly high


check for vacume leak, if the check engin light is on have it scaned
throttle position sensor could be causing the problem but most likely its the idle air controll motor stuck fully open located on the thottle body not bad to replace held on by 2 torks hed srews

Mar 11, 2014 | Dodge Intrepid Cars & Trucks

1 Answer

High eratic idle


Try checking the adjustment screw on the throttle body. Two other possible causes could be the speed sensor or the TPS sensor.

Feb 28, 2014 | 1991 Mitsubishi Montero

1 Answer

IAT sensor i circuit high output


high RPMs is the sign of a bad idle air control valve. it is located on the thottle body next to the throttle posistion sensor

Dec 27, 2012 | 2006 Chrysler Pacifica

3 Answers

Rpm high idling after cleaning tb in my 2007 chevrolet silverado LT 4.8 2wd


I, feel sorry for you, after reading your problem, but don't worry you visit the Reliable-Store they will help you for sure.
Best Manuals

Nov 20, 2017 | 2007 Chevrolet Silverado 1500 2WD

1 Answer

Is a Throttle Position Sensor the same thing as a Transmission control Module


The TPS ( THOTTLE POSITION SENSOR) tells the engine computer and trans how far you are pushing the gas pedal. Its mounted on the side of the thottle body. It will make the engine surge if it is failing. Have replaced this part many times for this problem. TCM (TRANS CONTROL MODULE) control trans shifting. The tps is and one of the input sensor for shifting.

Feb 03, 2012 | 2004 Jeep Grand Cherokee

2 Answers

Have an automatic transmission, 2001 Kio Rio. Problems when idling, sometimes high, sometimes low and will stall but starts right back up. I've replaced the Mass Air Sensor, spark plugs, air filter, coil....


It sounds to me like you have replaced everything except the most likely cause of your idle control problem...The Idle Air control. (IAC) (or Idle Speed Control Valve) It is located onthe throttle body and looks like the picture below.

dttech_3.jpg

Feb 22, 2011 | 2001 Kia Rio

1 Answer

P2106 and p061b and the truck (05 f-150) wont start.


p2106 Throttle actuator control system-Forced limited power.

the tp sensor/s in your thottle body is the problem. the most common repair is to replace the thottle body, some people just replace the tp sensors.

It also can be a broken wire to the injector.

Apr 22, 2010 | 2005 Ford F-150

1 Answer

2500 to 3000 rpm idle


Change your Thottle positioning Sensor. My 93 lesabre did the same thing and i changed the TPS and it stopped.

Jun 11, 2009 | 1993 Buick LeSabre

Not finding what you are looking for?
2004 Dodge Dakota Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...