Question about 2009 Toyota Corolla

Open Question

Stalling the car starts up and idle smoothly as long as its in park or neutral gear. Once you put the car in gear then you would see the rpm dip way below 1. Just as it about to stall it goes back to just below 1 again. It happens when you come to a stop while the vehicle is still in gear. It has not stall once yet since it start doing this couple months ago. I clean the throttle body but still the problem not going away.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mas66
  • 104 Answers

SOURCE: 2002 sequioa sudden stall

Often when the battery is disconnected or replaced the computer will lose it's learned idle settings. You could try letting the engine idle in park until the engine temperature comes up to normal and leave it like that for a few minutes, then put the Air con on and let it idle again for a few minutes, then switch the air con off and put it into drive. If it does not stall, let it idle in drive for 2 minutes or so, and then do the same with the Air con on. This should relearn the base idle settings and stop it from stalling on you. Before you carry out this procedure you should make sure that when you replaced the battery you didn't remove any other plugs or knocked anything that may be causing the fault. If you try this procedure and it still stall when you select drive, you will need to get a Mechanic to check the vehicle over.

Hope this helps,
Mark.

Posted on Nov 02, 2008

losflip
  • 94 Answers

SOURCE: Low idle, stalling frequently

Hi, Check all vacume hoses and fittings make sure there are no vacume leaks also make sure ignition timing is correct.

Posted on Dec 01, 2008

  • 160 Answers

SOURCE: 1992 Toyota Camry Rough Idle

start by pulling hose off egr valve see if idles smoother almost instantly

Posted on Mar 17, 2009

  • 73 Answers

SOURCE: 2000 totota camry le 4 cyl stalling.

Possible EGR valve sticking open.

Posted on Sep 09, 2009

  • 90 Answers

SOURCE: Idle up and down when Neutral

Hi
The clutch perssure plates seems worne off. you will have to replace them .
You can start by adjusting the clutch setting ...drive for a few days and if still problem persists then go in for a pressure plate change..
Regards
Berry

Posted on Feb 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When car is in neutral what would cause it to idle high


No load on engine. When a car is in any gear except park and neutral it has the load of the transmission. Which causes the rpm to drop. Therefore the rpm at idle will be a little higher or it would stall

Apr 18, 2015 | Cars & Trucks

1 Answer

I own a 1989 dodge d100 3.9v6 automatic it starts and runs but when put into gear it just stalls out?


Does it happen when you shift just to 1st
what is idle in park
when you turn on the ac in park does the idle go up a hair??

May 01, 2014 | Dodge D150 Cars & Trucks

1 Answer

1991 Chevy Caprice has a mild miss fire and stall at low rpm: This is my latest update: I checked and cleaned the EGR,PCV,IAC valve, M.A.P sensor and Throttle body(bore/butterfly). with carb cleaner....


Do you have the idle speed turned up to keep it from dying? Because it is high. Check engine light on? Have you checked for vacuum leaks at the gasket under the throttle body? How does the car run under acceleration? You might have a worn distributor shaft.

Jun 22, 2010 | 1991 Chevrolet Caprice

2 Answers

1990 Buick stalls when coming to a stop


Sounds like the torque converter clutch solenoid is bad. Unplug it and see if the problem stops. Unplug the 4 wire plug on the front of the transmission.

Aug 14, 2009 | 1990 Buick Century

2 Answers

93 Honda accord - idle real low (500 rpm) HELP, please!!


near the throttle body there is an adjusting screw(flat head) for air fuel mixture, it's on a deep cavity sometimes with a cover, adjust counterclockwise will increase the idle.

May 07, 2009 | GMC Canyon Cars & Trucks

2 Answers

1992 Toyota Camry Rough Idle


start by pulling hose off egr valve see if idles smoother almost instantly

Mar 17, 2009 | 1992 Toyota Camry V6

2 Answers

Vibration when in gear, and stalling.


The problem is the torque converter solenoid. I had it happen on my 94 Cavalier a few years back and was a cheap fix at the local car mechanic. What happens is the transmission warms up and hits a certain speed where the solenoid engages, but then it sticks and won't disengage until it cools down sufficiently. When it sticks, it causes the car to shake when slowing down and will snub out the engine if you come to a stop.

Mar 09, 2009 | 1994 Chevrolet Cavalier

1 Answer

'90 900 manual starts, stalls, and can't start again


The complete loss of oil suggests that you might have a piston problem!

First, check the compression on all cylinders; all values should be within a range of 10% from highest to lowest. Typical value about 140 psi.

One cause could be a blown piston or rings, allowing pressure into the crankcase, and blowing oil out of the filler pipe - very fine and barely visible, not spouting. You might feel the pressure pulses from the damaged or leaking cylinder.

If one cylinder has zero pressure, it's more than likely the cause of the problem. Do a wet compression test (pour a little oil into the cylinder immediately before connecting the compression tester - it usually seals any leaking rings for a little while) and if it holds pressure, that points to the rings; if no pressure again, that points to the piston.

Let us know the compression test results.

saabreur

Jan 21, 2009 | 1990 Saab 900 Hatchback

1 Answer

Engine stalls at stop lights and stop signs


sounds like the torque converter lock up might not be disengaging. You might also want to check for engine vacuum leaks. Does engine idle smoothly when in park or nuetral ? if the idle is good I would suspect torque converter problem.

Aug 16, 2008 | 1993 Ford Bronco

Not finding what you are looking for?
2009 Toyota Corolla Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...