Question about Ford C

Open Question

1971 ford c600 how to put in brake fluid

How do you add brake fluid to a 1971 ford c series truck

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 297 Answers

SOURCE: need to add brake fluid which reservoir do i add it to

Is normal because the brake pads/liners wear off ! As long you do not have a wet area by any wheel or at the master cylinder.

Posted on Aug 16, 2009

Ad
  • 83 Answers

SOURCE: can anyone add brake fluid to the truck? is there

There is nothing special to adding brake fluid. With the hood open on the drivers side on the firewall you should see the master cylinder. The cover is either a small round cap that will just spin off or a rectangular one that will pull off. Use DOT 3 fluid and fill. Make sure no dirt falls in.

Posted on Oct 27, 2009

  • 740 Answers

SOURCE: where is the reservior to add brake fluid to a

that is your brake fluid reservior. if you have fluid and no brake noise you may have a faulty mastercylinder. the first thing i would check is to make sure the vaccum hose to the brake booster is connected to the brakebooster and to the rear of the engine (since you did not know where your brake fluid reservior was the master cylinder is the meatal part that holds the reservior and the brake booster is the big round bubble that the master cylinder is bolted to) hope this helps you out.

Posted on Dec 29, 2009

drsinister69
  • 2317 Answers

SOURCE: i need to add brake fluid - where is the brake

It will be under the hood, on the driver's side, mounted on the brake booster, mounted on firewall. The master cylinder is usually silver with a plastic reservoir on top with a black plasic cap, there should be 4 steel lines coming out of it. Remove the cap and fill up to the "FULL" level on the reservoir.

Posted on Mar 15, 2010

Testimonial: "wow immediate response very detailed thanks"

emissionwiz
  • 77499 Answers

SOURCE: what kind of oil do i use for a 1971 ford f100

use 10W40W

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 dodge caravan sport keeps running out of brake fluid


AMSOIL Series 600 DOT 4 Brake Fluid is a good brand of brake fluid. Series 600 DOT 4 Racing Brake Fluid (BF4) AMSOIL Brake Fluids provide superior high-temperature performance in auto/light truck, high-performance, racing and powersports applications.-------------------------------------------------------------------------------------
Super VAG K+CAN V4.8

Jan 22, 2013 | 2000 Dodge Caravan

1 Answer

Brake fluid


CHECK ON THE FILLER CAP OF THE BRAKES MASTER CYLINDER STATES WHAT HOT POINT BRAKE FLUID YOU HAVE TO USE .( DOT 4,DOT3,DOT5.1 ETC )

Aug 29, 2012 | Ford Cars & Trucks

1 Answer

Adding brake fluid


Remove the cap from the master cylinder reservoir. Add DOT3 or DOT4 brake fluid from a sealed container to the reservoir until the level reaches the full mark on the side of the reservoir. Reinstall the cap

Feb 14, 2012 | 2001 Ford Taurus

2 Answers

How do you put brake fluid into a 2001 ford windstar?


I know it wasn't a very good engineering design, but the brake reservoir is up underneath the cowling for the windshield wipers on the drivers side. The fill cap is on top, and not easy to access. You will need a very flexible funnel (like a tranny funnel) or a small funnel you can add a piece of flexible hose to to reach the fill cap. You should never need to add brake fluid unless you have just replaced some brake pads or shoes. If the reservoir is low it would indicate your brakes are worn and need replacing soon, or there is a fluid leak in the system.

Feb 06, 2011 | 2001 Ford Windstar

1 Answer

Where do i put clutch fluid?


This is for a 328, but should be the same for a 325.

Location 1 is where you add the clutch fluid. The brake fluid reservoir for both the brake master cylinder and clutch master cylinder. There is a line from the brake reservoir to the clutch master cylinder.

Also, read you owners manual. It should show the same ocation pictorially.

dimitrios_ga.gif

Dec 30, 2010 | 1999 BMW 328 Series

3 Answers

Brake pedal travel long-slow to stop.


check your front brake pads and see if they need replaced then check your brake fluid after you change them. If you add brake fluid first you will leak brake fluid out when you compress the calipers to change the front brake pads. In the end make sure your brake master cylinder is full of dot 3 brake fluid before you drive.

Dec 11, 2010 | 1996 Ford Taurus

1 Answer

I need to add brake fluid. Does the car have to be warm or can I do it when it is cold?


You can add brake fluid when its cold just make sure you are adding the right fluid most vehicals take DOT 3 brake fluid, look inside your owners manual in the recommended fluids and lubricants section and make sure thats the right brake fluid for your ford......

Dec 07, 2010 | 2005 Ford Taurus

1 Answer

1994 Crown Victoria: need to add brake fluid to master cylinder...


Why would you add fluid?
As the front pads wear,the fluid will go down, not an issue
If you keep opening the fluid resevoir,you will let moisture in.

May 05, 2010 | 1994 Ford Crown Victoria

1 Answer

How do i change brake fluid in a ford escort


In this video series you'll learn basic brake fluid maintenance and how to change the brake fluid on your vehicle. Expert mechanic Jon Olson walks you through the process step-by-step...

How to change your brake fluid video

Good work, and good luck.

Sep 15, 2009 | 1997 Ford Escort

2 Answers

CANT FIND WHERE TO PUT CLUTCH FLUIDON 99 FORD ESCORT


It is close to the firewall on the drivers side of the vehicle (most vehicles) it will look almost identical to the brake master cylender just a much smaller scale. Add your fluid their.

Jun 20, 2009 | 1999 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5608 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...