Question about 2003 Lincoln Navigator

Open Question

Where i find the module 3w4t-13c789-aa on the lincoln navigator 2003

Need to replace module

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75822 Answers

SOURCE: 2003 Lincoln Navigator door sensor problems

One of your courtesy light switch's is defective, it can be in any of the five doors (rear hatch has 2), Ford can determine which one (courtesy light switch) is at fault by using a NGS (New Gen Star Tester) to monitor the switches through the Generic Electronic Module of your truck, these switches are attached to the door latch assembly and are time consuming to replace, so the Ford tester is the cheapest option.

Posted on Nov 13, 2008

emissionwiz
  • 75822 Answers

SOURCE: HOW TO REMOVE A HEATER CORE IN A 2003 LINCOLN NAVIGATOR

U must remove the entire dash assembly and then the heater core housing which is part of the air distribution box, time to do the job 10-15 hours.

Posted on Dec 01, 2008

  • 4369 Answers

SOURCE: 2003 where is the modules for the liftgate in a 2003 lincoln Nav

tascafordparts.com for discount.

The liftgate actuator and remote control are in the liftgate.
The module is in the left rear quarter trim panel.


SECTION 501-03: Body Closures 2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION Power Liftgate Module Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new power liftgate module once installed. For additional information, refer to Section 418-01 .

  1. Remove the rear quarter trim panel. For additional information, refer to Section 501-05 .
  1. Remove the power liftgate module.
    1. Disconnect the electrical connectors.
    1. Remove the bolts.
89dd4de.gif
  1. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new power liftgate module. For additional information, refer to Section 418-01 .

-----------------------------------------------------------------------------------------

Principles of Operation
The power liftgate is controlled by the power liftgate module.
The power liftgate module receives inputs from:
  • glass position switch (determines the ajar status of the liftgate glass).
  • forkbolt switch (determines the primary position of the latch).
  • detent switch (determines the secondary position of the latch).
  • home switch (determines the power cinch status).
  • power liftgate control switch (activates the power liftgate from the interior of vehicle).
  • pinch strip switches (determines if an obstacle is detected between the pinch strip and liftgate).
  • instrument cluster module (activates and sets the options for the power liftgate).
  • optical sensor (determines the direction, travel speed and obstacle detection of the liftgate).
  • UBP serial communication link.
The power liftgate module sends outputs to:
  • liftgate motors.
  • power cinching latch system.
  • liftgate chime module.
  • body security module
------------------------------------------------------------------------------------

The liftgate consists of the following components:
  • liftgate window glass latch
  • door lock actuator (power liftgate only)
  • liftgate latch
  • liftgate handle
  • liftgate latch remote control (power liftgate only)
  • liftgate ajar switch
  • chime module (power liftgate only)
  • -------------------------------------------------

Posted on Apr 19, 2009

MNfisherman
  • 11896 Answers

SOURCE: How do you replace the CABIN AIR FILTER in a 2003

You will have to remove glovebox and possibly dash panel to access the cabin filter compartment. Once you get the screws out and open the door, you then can pull out and exchange the filter

Posted on Jul 17, 2009

emissionwiz
  • 75822 Answers

SOURCE: need to find fuel pump relay on 2003 lincoln

in the passenger compartment fuse box the relay is
R303 Fuel pump relay

Posted on Jan 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 lincoln town cardrivers door module,will #3WITZ-13791-AE module replace the DDM 4W1Z-15K601-AA?


Numbers tell us nothing. Years do. I believe Ford was 2000 to 2003. When I buy used parts , I ask the junk yard what is compatible. Because there are year specific modules.

Jul 15, 2016 | Lincoln Cars & Trucks

1 Answer

I need an Air Suspension Module for a 2003-2006 Lincoln Navigator....Anyone got a clue where to find one...other than the dealership??..


I changed one recently on about same year navigator
I found one at a local salvage yard pretty cheap
I Also cut harness off of donor vehicle cause the one I was repairing also had melted connector at module
The module is located behind from bumper on pass side

Apr 06, 2014 | 2006 Lincoln Navigator

1 Answer

What causes the left side seat not to heat up in a 2003 lincoln navigator


Make sure you first check every fuse in the car and under the hood.If every fuse is good then its either the seat heater control module located under each seat,or burned out heating elements.The mirrors could be a faulty switch.

Feb 05, 2012 | 2003 Lincoln Navigator

1 Answer

Hi tank u for answer pls tell mi wer is horn of lincoln navigator 2003 and if u can send photo for mi my mail adress is sia79falcon@yahoo.com in dubai moor tanks


It's between the radiator and grille, one bolt hold both horns on.
part number 2L3Z-13832-AA HORN ASSEMBLY, HIGH & LOW TONE.

May 13, 2011 | Lincoln Navigator L Cars & Trucks

1 Answer

2003 Lincoln Navigator: The air suspension is gone and I need to know which relay controls the module.


Go to ebay motors and check out the air suspension compressor for the navigator, Mine is starting to go as well, runs all the time and getting noisy. I talked to an expert that says they are easy to change out yourself.

Nov 04, 2010 | 2003 Lincoln Navigator

1 Answer

Where is the airsuspension relay and module located on a 2003 lincoln navigator


the relay is by the water tank on top of the air pump and the relay is under the dash drivers side close to the upper brake pedal hope that helps

Sep 07, 2009 | 2003 Lincoln Navigator

1 Answer

I need Repairs manual Lincoln navigator II (2003). Where can I download it?


devicemanuals.com/guide/Automobile/Lincoln/Lincoln-Navigator-Owner's-Manual-2003-==TVRBM05EY3o=.html

in the above link you can download the manual

Aug 04, 2009 | 2003 Lincoln Navigator

2 Answers

2003 where is the modules for the liftgate in a 2003 lincoln Nav


tascafordparts.com for discount.

The liftgate actuator and remote control are in the liftgate.
The module is in the left rear quarter trim panel.


SECTION 501-03: Body Closures 2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION Power Liftgate Module Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new power liftgate module once installed. For additional information, refer to Section 418-01 .
  1. Remove the rear quarter trim panel. For additional information, refer to Section 501-05 .
  1. Remove the power liftgate module.
    1. Disconnect the electrical connectors.
    1. Remove the bolts.
89dd4de.gif
  1. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new power liftgate module. For additional information, refer to Section 418-01 .

-----------------------------------------------------------------------------------------

Principles of Operation
The power liftgate is controlled by the power liftgate module.
The power liftgate module receives inputs from:
  • glass position switch (determines the ajar status of the liftgate glass).
  • forkbolt switch (determines the primary position of the latch).
  • detent switch (determines the secondary position of the latch).
  • home switch (determines the power cinch status).
  • power liftgate control switch (activates the power liftgate from the interior of vehicle).
  • pinch strip switches (determines if an obstacle is detected between the pinch strip and liftgate).
  • instrument cluster module (activates and sets the options for the power liftgate).
  • optical sensor (determines the direction, travel speed and obstacle detection of the liftgate).
  • UBP serial communication link.
The power liftgate module sends outputs to:
  • liftgate motors.
  • power cinching latch system.
  • liftgate chime module.
  • body security module
------------------------------------------------------------------------------------

The liftgate consists of the following components:
  • liftgate window glass latch
  • door lock actuator (power liftgate only)
  • liftgate latch
  • liftgate handle
  • liftgate latch remote control (power liftgate only)
  • liftgate ajar switch
  • chime module (power liftgate only)
  • -------------------------------------------------

Apr 14, 2009 | 2003 Lincoln Navigator

2 Answers

2003 Lincoln Navigator door sensor problems


One of your courtesy light switch's is defective, it can be in any of the five doors (rear hatch has 2), Ford can determine which one (courtesy light switch) is at fault by using a NGS (New Gen Star Tester) to monitor the switches through the Generic Electronic Module of your truck, these switches are attached to the door latch assembly and are time consuming to replace, so the Ford tester is the cheapest option.

Nov 13, 2008 | 2003 Lincoln Navigator

1 Answer

AIR SUSPENSION QUIT


TOOK IT TO A LINCOLN DEALER:
REPLACED AIR SUSPENSION PUMP
(THEY FOUND PUMP TO BE "SUDDENLY"BURNED OUT) (heart-attack)...
1.) 6L1Z*5319*AA COMPRESSOR $433.10
2.) LABOR 287.00

YUCK $$$ GONE/ +TAX...

NEEDED TO HAPPEN/ FRAME WAS ON FRONT WHEELS/WOULD NOT LIFT.

THANKX FOR THIS FORUM...

lkah1218@AOL.COM


Sep 19, 2008 | 2003 Lincoln Navigator

Not finding what you are looking for?
2003 Lincoln Navigator Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...