Question about 2006 Chevrolet Cobalt

1 Answer

Busted oil pan now can wont start tryed cranking to start

Ther a new battery in ther lots of gas we put a new one in ther

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 30 Answers

Did you replace the oil pan? many new cars have an oil level sensor and will not start if they read low oil so as to prevent the motor from seizing from too much heat and friction/wear.

Posted on Apr 02, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Busted oil pan


Oil pickup tube is likely bent as well, replaced that with the pan?
The click is either because the starter was hit as well or the bent tube is blocking engine rotation. That's on the optimistic side, there could be other damage to the engine or transmission causing this if the starter, battery and power connections check out.

Apr 01, 2014 | 2006 Chevrolet Cobalt

1 Answer

Oil pan busted and car wont start


If the starter goes clunk It is seised

Apr 01, 2014 | Chevrolet Cobalt Cars & Trucks

1 Answer

Oil pan busted and then car shut down and wont start


Sounds like the engine seized from lack of oil. It only takes a minute without oil...

Apr 01, 2014 | Chevrolet Cobalt Cars & Trucks

1 Answer

How do you replace or fix ticking lifters


I,m going to share something with you that i found out my van had ticking lifters and all i did was clean the oil pan filter

1. drain all the oil from oil pan
2. take oil pan off
3. once that is done you will see a long tube comming down by the crank.
4. remove the 1 or 2 bolts that hold the filter on
5. once removed you can give it a good rinse out with a gas/2stroke oil mix
6. once fully dry replace back to original location
7 put new oil pan gasket on
8 put oil pan back on
9 torque bolts down to 12.5 foot pounds
10 full with oil
11 start vehicle and let run

Good luck!
Let me know how it turns out

Sep 10, 2011 | 2002 Dodge Durango

1 Answer

How to replace head gasket and how to put it back in time when assembling back together on 2.4l (quad4) engine??


There will be marks on the cam gear and the crank gear. Some are dots, some are diamond shaped. You just line the two up so the top mark is directly over mark on the crank. You may have to turn the crank by hand which is easier with all the plugs out, to line it up. You will want to drain oil,change filter, and put in new oil to get rid of contaminated oil in oilpan.
If you fail, you are not talking about a lot of money to try to fix the top of the engine compared to engine replacement. For the most part, you could still tow it.
You could ask how much it would cost just to replace the gasket and let someone else bust their knuckles.

Apr 16, 2009 | 1998 Pontiac Grand Am

2 Answers

Car wont cank over


check for spark at spark plugs, spray some carburator cleaner in the air filter housing then try to start the engine and watch oil pressure

Jan 03, 2009 | 1996 Ford Thunderbird LX

1 Answer

86 comanche wont start


check the crank senser i had the same problem changed senser run great

Dec 16, 2008 | 1986 Jeep Comanche

1 Answer

1997 ford taurus will not start


voltage is not really the issue here, the amperage is the thing that make things go.
you battery may have 1 or 2A, but hte bettery still reads 12v.
are you getting any gas to the engine.?
try a new battery, and give it a short bust, not a long cranks. and give enough gas in between the bust.

Nov 12, 2008 | 1997 Ford Taurus

1 Answer

Honda Civic


just off the wall guess here but sounds like oil filter sending unit in the pan these get cloged with old sitting oil use a solution like warner mystery oil in pan with normal oil this will break down old oil after 500 miles replace oil and do it again for 3 + 500 mile oil changes this will help clean out the old oil
also you might have gotten your plug wires wrong in fireing order

9915787.jpg

May 15, 2008 | 1997 Honda Civic

Not finding what you are looking for?
2006 Chevrolet Cobalt Logo

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...