Question about 2010 Toyota Venza

1 Answer

2010 venza. Wont start. Had autozone check battery- good. Pulled started took to autozone- tested good. it just clicks. any ideas.

Ignition problems? starter tested good, reinstalled and click, click, click.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 76 Answers

Possible starter. Contact Toyota and check for recalls on your car.

Posted on Apr 01, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 958 Answers

SOURCE: 1996 Toy Tocoka ignition/starter

that is a starter solenoid problem.

starter has its own solenoid. the big round thing besides the real motor.

it has contacts inside which could be worn out .

that is why sometimes it make contact and sometimes not.



tnx 4 using fixya,

drcool

Posted on Sep 16, 2008

  • 12 Answers

SOURCE: 1994 Toyota Camry 4 cylinder Starting problems

your starter is bad.... the two contacts inside the solinoid are worn out only way to fix is replace the unit as a whole bet ya you get click click click then my start.. bet my life on this one been fixin toyotas for 20+ years

Posted on Dec 30, 2008

  • 16 Answers

SOURCE: won't even "click" nor " crank" when trying to start .

Agree, it sounds like the starter and it happens often on old Camry. When was the last time you had the starter replaced? The cartalk guys once suggested getting a mallet and bang on the starter and it will work. Eventually you will need a replacement. It is way cheaper to go to junkyard and get a used one (ask them to test before buy).

Posted on Feb 03, 2009

  • 19 Answers

SOURCE: 1994 Toyota Tercel Starter Problems

sounds to me that you have an igniton problem not a starter problem and or if you have or had an alarm system could be cause if u do give me feedback and i will explain but seems that your starter is fine from what u say but if you think in terms of the elemts to start a vehicle batery gives pwoer to ignition which sends to starter which gives spark etc i would check you ignition system something is causeing a short and not alowing starter to function

Posted on Feb 10, 2009

  • 770 Answers

SOURCE: when I turn the key my starter just clicks once or

The click indicates that not enough power is going to your starter to engage it, much less spin the engine. If you are POSITIVE your battery is good, then you likely have a bad connection at either the battery, the selenoid, or the starter. You must check and clean all connections, not only positive but grounds as well, from the battery to the starter and from the ground post to your ground on the car. Good Luck! I hope you find this very helpful!

Posted on Nov 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car won't start


replace the ignition switch the tumbler has came apart

Jul 21, 2015 | Toyota Cars & Trucks

2 Answers

My 07 chevy colorado will not start just clicking of starter when holding the ignition down and while holding the ignition down the gauges jump as if Its to dead to start . It will start if someone gives...


If your battery has been tested OK, and Bosch is a very good battery by the way, then a clicking sound from the starter motor contactor means it is not getting sufficient current. This means a bad conductivity somewhere. If the engine turns over when you use a jump start from another vehicle, it suggests that there is enough energy to overcome the poor conductivity. The most likely culprit is the inside of the battery terminal connectors, which may have a layer of contaminant which is limiting the good connection. Clean the inside of the terminal connectors with an abrasive action and make sure the bolts are tight. Failing that, the same problem may exist where the cable from the battery joins the starter motor. Check both the primary circuit (through ignition key relay) and the secondary circuit which carries the starting current. This, unfortunately usually means getting to a hard to access place (where the starter motor is mounted) Good luck. Cheers, Don.

Jul 07, 2014 | Cars & Trucks

3 Answers

Car ran fine until I pulled into driveway. After I turned off ignition it wouldnt start again.


Have the battery tested and clean the battery cables. Just because it reads 12 volts doesn't mean it can supply power under a load.. Autozone and others test batteries for free

Aug 09, 2012 | 1989 Lincoln Town Car

1 Answer

Car won't start. battery good, all electrical components in cab work along with headlights. what can it be


Check for power at the starter solenoid with key in crank position. Use a testlight or voltmeter to see if 12 volts is there. The circuit path is from ignition switch to neutral safety switch (automatics), or clutch safety switch (manual) and then to starter relay, if used, and to the starter solenoid.
If no power at solenoid in start, check your fuses in the power distribution box by battery. If car has any fusible links around battery, check them also for melted insulation or appearance of burning. If you do have power at solenoid in crank, the solenoid must be bad and needs replacing.

Dec 24, 2011 | 1999 Saturn SC

1 Answer

My 1999 mitsubishi diamante will not start. I got a friend to jump it but it still would not start. I took the battery out and took it to autozone to charge it. But autozone would not charge it because...


It sounds like you need a new starter. If you hear the starter click when you turn the key to start, replace your starter since you already replaced the battery. You might want to have your alternator checked out, or when you get your car started, test the battery terminals with a multimeter. You should have around 14 volts with the car running. If not, you will need a new alternator. The alternator won't keep the car from starting though, unless the battery was drained because it wasn't charged. Even then it is the battery keeping the car from starting.

If the starter is not clicking, check your fuses under the hood. If all checks out, you may have a bad ignition switch.

Jul 02, 2011 | 1999 Mitsubishi Diamante

2 Answers

Fx45. Won't start. Took out battery had it tested and it is good-all lights radio work when try to start it . Took key out of intelligent key to try to start it-it clicks but won't start- any ideas?


Hi, first try a jump start. If it will jump satrt, clean and tighten the battery terminals. If it will not jump start, take the starter/solenoid out and have it tested at your local parts chain. For more info, please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . Please let me know if you need instructions or have any other questions, and thanks for using FixYa.

Apr 23, 2011 | 2003 Infiniti FX45

1 Answer

Wont start--pulled starter bench tested ok


check your ignition did one of these before changed 3 starters before finding out it was ignition switch not making connection in switch good luck

Feb 07, 2010 | 1997 GMC Jimmy

2 Answers

Willnot start pulled starter bench tested ok


Check all cables to the starter and the ground or negative cable from the battery to the engine or frame. They get old and break down between the insulation and you wont get enough current to start the car

Feb 07, 2010 | 1997 GMC Jimmy

2 Answers

Pt wont start or turn over


try to get a jump from a friend and see what happens, does the same, faulty starter, may need replacing, try to use small hammer and tap lightly on the starter couple time and have a friend start the car while you tap lightly on it. check ignition switch where you stick the key in. stick the key in the ignition and turn the key back and forth jiggle and wiggle it and see if your igniting will make contact. do it several time to test and see if its the ignition problems, this part is not cheap to replace.

Sep 25, 2009 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
2010 Toyota Venza Logo

Related Topics:

297 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...