Question about Cars & Trucks

Open Question

Bosch m100 fuel injection pump

Need new seals

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ilragatzzo78
  • 241 Answers

SOURCE: no fuel coming from fuel injection pump,bosch inline 5 cylinder

IT SOUND LIKE A BAD FUEL PUMP TO ME.
TRY SCANNING THE VEHICLE FOR ANY CODE.
IF THERE ARE CODES POST THEM HERE AND I WILL LOOK THEM UP FOR YOU

Posted on May 28, 2008

  • 15 Answers

SOURCE: my s10 will turn over, but wont squirt gas through injecter

Does it crank? Do you have any codes? Check engine light? Do you have spark? No spark check coil, and connections, also it would be nice to know what year it is. Get codes read. No crank check battery and starter. No codes or lights check crank position sensor, make sure your pcm is good after replacing your ignition mod you could have blown it if you did do it right. (engine computer) Check cam sensor if applies. Crank and cam could prevent it from starting and I know one I think cam controls pcm's fuel delivery on gm's

Posted on Dec 30, 2008

SOURCE: diesel fuel leak. looking for diagram of injector

Get a professionally rebuilt pump. Don't try to mess with rebuilding yours, it isn't worth it. I know the rebuilt pumps are high ($450) plus, but it will pay off in reliability and performance.

Posted on Mar 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reseal cav pump willnot inject fuel after a seal kit install


if you have not bled the air out of the pump after fitting new seals , the problem is probably there
i bleed the pump and then if it is not common rail loosen off each injector line nut and turn over until there are solid drips of fuel
tighten the nuts and it should start

Sep 29, 2016 | Cars & Trucks

1 Answer

Checking timing on bosch ve type injection pump


put some fuel in it then turn the pu,p ovedr till you see fuel spit from no1 ,also if this is a rotary pump you remove the little cover on the side of the pump and look at the letters ,i cannot for the life of me remember what they are and all my notes from the ford training centre in daventry got eaten by mivce when i moved to spain ,you could ask in your local bosch agent /repair centre they would know

Dec 28, 2013 | Dodge Cars & Trucks

1 Answer

Can a fuel pump relay cause poor gas delivery


NO, the relay will either work or it won't. (Unplug it and look at it; if the terminals look corroded... replace it.) Most cars have fuel injection systems these days. In addition to the fuel pump that pumps fuel out of the gas tank... there is an injection system pump which is quite expensive. In order of operation: 1) have your injectors cleaned or replaced as needed (new ones run about $30 each), 2) have the injection system pump pressure checked and get a rebuilt pump if needed (brand new one ~$850), and 3) check the fuel pump. If the car has more than 80K miles on it, then suspect clogged or partially obstructed injectors. A BOSCH SERVICE CENTER has a machine to test and clean most makes of injectors. At the same time, replace your fuel filter and use good gas when you fill up. NEVER fill up from a station that just had a fuel truck delivery (if you see the tank truck) as the garbage on the bottom of the tank takes a day or so to settle back down again. Magneti Marelli Check Star also offers good injection system servicing. The dealership should be your last resort as they just replace parts until the problem goes away... leaving you with a hefty bill and a bag of old parts

Aug 27, 2012 | Cars & Trucks

2 Answers

Wheres the fuel pump located on a 2002 1.9 TDI jetta


Removal & Installation
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve the fuel system pressure.
  3. Disconnect the negative battery cable.
  4. Remove or disconnect:
    • Cover under rear seat
    • Electrical connector
    • Fuel supply and return lines
  5. Using spanner tool 3217, remove the fuel pump flange nut.
  6. Remove the fuel pump unit and seal.
  7. Installation is the reverse of removal. Be sure to use new sealing rings and/or gaskets. Tighten the fuel pump flange nut to 55 ft. lbs. (75 Nm) and make sure the markings on the flange nut match the marking on the fuel tank.

Jun 16, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

Leak injection pump


Sounds like you are going to have to drop the tank out to inspect and fix. with luck it will be leaking from the fuel pump seal or the return line. If your truck is fuel injected , and the pump is in the tank , regular fuel line hose won't do, need to buy stronger hose rated for fuel injected cars. If it is the return line, won't be as high presure.

Keep us updated or send us additional details.

Jan 22, 2011 | 1991 Toyota Pickup

1 Answer

Diesel injection pump leaks


all diesel cars built before 1996 have seals in them which are not suitable for the new low sulfur diesel fuels sold today.Only way to remedy the problem is to have new seals fitted.Can be a costly job.Get 3 quotes.
Hope this helps.

Jun 28, 2009 | 1989 Toyota Corolla 2 Door

1 Answer

Renault megance Dci doesn't start in the morning - injection prob


look in fuel filter you are looking for metal fillings. i suspect you have a broken high rail pressure pump. if all ok.
check the pump to see if bosch or siemens.
if bosch can you hear a wine noise for 3 seconds, this is a lift pump.
if ok i suspect a faulty injector, this stick open.
poss the fuel regulator.
crank shaft sensor.

May 27, 2009 | 2005 Renault 181

1 Answer

Hard to start when engine is cold


The thing you need to do is run a leak down test on the fuel pump overnight, hook up a fuel pump test guage to the fuel injector gas rail test port, run the engine, note the fuel pressure when you shut the engine off, it should not drop more than 5 PSI overnight, if it does you need a new fuel pump. Your car doesn't use a cold start valve, that was used on very early Bosch K-Jetronic fuel injection systems, they where last used in the 80's

Oct 28, 2008 | 1990 Mitsubishi Galant

1 Answer

No fuel coming from fuel injection pump,bosch inline 5 cylinder


IT SOUND LIKE A BAD FUEL PUMP TO ME.
TRY SCANNING THE VEHICLE FOR ANY CODE.
IF THERE ARE CODES POST THEM HERE AND I WILL LOOK THEM UP FOR YOU

May 28, 2008 | 1996 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...