Question about 2003 Toyota Sienna

Open Question

Abs and tire pressure light s on

Abs and tire pressure lights on

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Tire pressure light

On the lower left hand side of the dash, near the Traction control button, is a small push button. Just press and hold until the Tire Pressure light goes out. Of course, make sure you're pressure is ok, otherwise, it will just come back on in a couple minutes.

Posted on Feb 27, 2009

dsacco86
  • 1077 Answers

SOURCE: low tire pressure light won't stay off after proper reset.

Some newer Toyota vehicles have a sensor in the spare tire. Tires loose air over time naturally. I would check out the spare.
When did this TPS light start coming on?
Have you had new tires put on, or had a flat repair done before the light?

Posted on Apr 28, 2009

Molson02536
  • 3854 Answers

SOURCE: tire pressure light is on even though all tires are inflated prop

You can reset the TPMS system on your Toyota Highlander. There are instructions in the owner's manual on how to do so. However, resetting the system without checking the cold-air inflation of the tires is not necessarily solving the problem. The recommended tire pressure inflation sticker is located on the driver-side door frame. On the Highlander, it calls for 30 pounds per square inch (psi) of tire pressure per tire, including the full-sized spare. If the Highlander had a donut spare tire, it will not have a TPMS sensor and subsequently will not effect the TPMS system one way or the other. To reset the TPMS system in the Highlander, there is a reset button under the driver-side dashboard that needs to be held for a period of time (a few seconds) while the ignition key is in the "key-on/engine-off" mode. The TPMS warning light will blink rapidly for a few more seconds, and the system will reset itself. Refer to the manual for the exact procedure. If the TPMS warning light reoccurs, have the system or tires checked by a professional. Good luck and hope this helps, keep me posted. Be glad to help.

Posted on Jun 19, 2009

  • 1 Answer

SOURCE: Toyota Tundra 2005. ABS, Airbag, Tire & cruise dash lights flash

how do you turn the maintenance light off after making oil change?

Posted on Sep 02, 2009

  • 66 Answers

SOURCE: i changed rims and tires on my 2008 toyota sienna

Sounds like they did not swap over your tire pressure monitoring sensors. They probably just used regular rubber valve stems. I would call and ask whoever put them on.

Posted on Dec 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tyre Pressure and ABS


By operating the tire pressure warning system reset switch, tire pressure warning system ECU can be set to issue a warning at an inflation pressure that corresponds with the type of tires.
Operate the tire pressure warning system reset switch only after the inflation pressures of all 4 tires have been adjusted on the vehicle.
To initialize the system, press and hold the tire pressure warning system reset switch for 3 seconds or longer with the power switch turned IG-ON. When starting the initialization, the tire pressure warning light blinks 3 times at 0.5 Hz.
During the initialization, the tire pressure warning system valve & transmitter measures the inflation
pressure of the tires, and registers the signals that are transmitted into the ECU at a frequency of 1 per
minute. The initialization process is completed when the signals from the tires have been received.
Once the tire pressure warning system reset switch has been pressed, do not turn the Ignition switch OFF for a few minutes.

Mar 05, 2014 | 2002 Toyota Corolla

1 Answer

Low Tire Pressure Light, ABS light, Trac Off Light and Service Traction Control


I assume this is a Ford vehicle. Start by having the rear axel serviced At the dealership. There is probably metal dust on the magnetic speed sensor, that triggers off of the ring gear inside the axel housing, causing the fault warning lights on the dash. Run an OBDII scan with a print out while at the dealer. Of coarse fix the tire.

May 15, 2017 | Cars & Trucks

1 Answer

The abs light came on? What might be the problem?


the abs light will come on if there is low pressure in one of the tires on the vehicle.
The abs system detects the drag the low air pressure tire is causing , and allerts you of this.
other causes are bad wheel bearings which cause a vibration in the abs sensors .
there are other reasons the abs will light up , but these are the most common.

Aug 21, 2011 | 1999 Jeep Grand Cherokee

1 Answer

I have 3 sensor lights that came on at the same time. The brake light,tire pressure light, and the ABS light(I think). A friend had a portable diagnostic computer and plugged it in. No problems...passed....


there area magnitude of things that can be the issue here. I wil take a chance here and say that there is an issue with a couple of sensors. This situation involves 1. The brake light sensor (which indicates that i brake light bulb is faulty) 2. The Tire pressure sensor (which is the tire pressure) and 3. ABS sensor ( Which i would associate it with a wheel speed sensor)

You should check the tire pressure, and correct it. Check the bulbs on your brake light and replace as necessary. Then check for a torn or broken ABS sensor, which are located on each wheel,

May 31, 2011 | 2003 BMW Z4

1 Answer

Low tire pressure light stays on in spite of adequate pressure in all four tires.


Your wheel bearing needs replaced! You can have the abs diag and will tell you which whell bearing is bad. Soon your traction light and abs light will come on.

Jan 14, 2011 | 1999 Buick Regal

1 Answer

My car has several lights on and im not sure why. I have 2001 olds alero with 125,000 miles on it. The service engine light and the anti- lock and abs lights come on and stay on here lately. any clues why?...


I'll try to answer these as asked.
1. check engine light is telling you that you have an emission control problem and needs to be scanned for codes.
2. The abs and traction control light are connected and when the abs sets a problem code it will turn both on , It also needs to be scanned for codes.
3. Having a tire that is a diffrent size or more worn than others will set the tire pressure lamp and it can be cleared by removing the fuse panel door on the side of the dash and holding the red button in with the key on engine off untill it flashes or beeps and goes out.

Jul 28, 2010 | 2001 Oldsmobile Alero

3 Answers

My ABS light is coming on what does that mean?


1. check and make sure that your tires are inflated to the correct pressure

2. turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (think the switch is in the glovebox, but not sure) until the warning light turns off and then release the switch.

3. now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.



As for the ABS light, that means your antilock brake system has detected an issue such as a block sensor, or a faulty relay, etc.. when this light is on, it means that your abs may not engage when it should, or may engage when it shouldn't.

Aug 21, 2009 | 2003 Ford Expedition

1 Answer

Indicator lights


You may have a issue with the ABS sending unit(module). i would get this checked out. this is normally the issue when it stays on or blinks. The tire pressure light will come on if the pressure in any tire on the vehicle is lower than the factory specs. this is normal.

Mar 15, 2009 | 2004 Lexus RX 330

2 Answers

Toyota Tundra 2005. ABS, Airbag, Tire & cruise dash lights flash


how do you turn the maintenance light off after making oil change?

Mar 09, 2009 | 2006 Toyota Tundra

Not finding what you are looking for?
2003 Toyota Sienna Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...