Question about 1991 Honda Accord

2 Answers

Shaking steering wheel

Steering wheel shakes when letting off the gas. just replaced the power steering pressure hose due to a leak.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Honda Master
  • 2,620 Answers

Curtis have you checked the tierod ends for play? If you have and there is no play then I would look at the rack and pinion for wear.

Posted on Apr 01, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 82 Answers

Sounds like a wheel bearing has failed or the trackrod, jack up car and feel for play by wobbling each wheel left to right and up and down, if you can look over the wheel you could see play somewhere unless it's the main wheel bearing

Posted on Apr 01, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

SOURCE: power steering fluid leek on 89 honda accord

Should not be too hard. I have not done one on an 1986 model but I have on a 1983. The principle will be the same.

  • You need to drain the fluid.
  • Disconnect all the pump hoses.
  • Release the pump pivot and adjustment bolts and remove the pump from the vehicle.
Replacement is the reversal of the removal operation.
  • Tighten all the bolts.
  • Adjust the drive belt tension.
  • Fill and bleed the system.
Following the above procedure should get the job done. Take your time doing the job and double check your work at the end of the job. Check for any fluid leeks from the system.

Posted on Dec 01, 2008

  • 651 Answers

SOURCE: shaking & rattling above 50 mph

have a tire shop balance your front tires.

Posted on Nov 28, 2008

  • 1 Answer

SOURCE: POWER STEERING PRESURE HOSE

power steering pressure hose over the exhaust manifold cover? me too. just planning on buying new and replacing.

Posted on Jul 26, 2008

bitchn65cuda
  • 70 Answers

SOURCE: Engine Shaking.

they changed the timing belt? if so they put it wrong, its probably off a tooth. take it back and make them recheck their work

Posted on Apr 20, 2009

  • 57 Answers

SOURCE: honda crv high pressure steering hose leaking

You need a line wrench or a crow's foot. Power steering lines are hard to deal with. The fittings are fine thread and hard to start.You can cross thread them easly.be carful.

Posted on May 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

5 Answers

Why does it shake whenever i let off the gas and shakes real bad when i apply my brakes


If when applying the brakes the steering wheel shakes then your front rotors are warped and at the least need resurfaced and most likely the brake pads replaced. But more likely the rotors are too thin which has allowed them to overheat and warp which causes the shaking. In this case new rotors and pads are in order. If when braking tou feel the shaking in the seat of your pants then most likely the rear brakes are the issue. Same problem as the front, warpage, but your rear brakes are most likely drums. Again, possible resurfacing and new shoes; but more likely new drums and brake shoes.

But I wonder? Did this vibrating just start all of a sudden or maybe after a near accident requiring you to brake very heavily and possibly overheat the brakes. Or my main concern, to keep this from happening again, after pulling some type of trailer that you intend on pulling again. Pulling a trailer without its own brakes puts a much heavier load on your trucks brakes and just repairing them won't keep it from happening again if you ARE pulling a trailer. Higher quality rotors/pads/drums/ and brake shoes can help but if the trailer is too heavy for the truck nothing but installing brakes on the trailer or a lighter trailer will stop you from warping them again.

Lastly, in general when you let off the gas and the whole vehicle shakes the driveshaft/u-joints are common causes. Same with the steering wheel if it shakes when letting off the gas, but only on a 4x4 or AWD vehicle. So check your driveshafts and u-joints and make sure they are tight. But unless you find something obvious there I would wait until you have the brakes sorted out and see if that doesn't stop all the shaking.

Good luck!

Jun 24, 2014 | 1995 GMC Jimmy

1 Answer

Power steering hard to turn


Engine running ask someone to turn steering wheel for you . Look for power steering hose move like there is pressure. and noise from power steering pump . if not change power steering pump
You don't really need power assistance when moving on the road ... where you need it more specially in parking or not really moving
hope it helps

Mar 31, 2014 | 2002 Chevrolet Tahoe

1 Answer

2000 subaru outback sedan steering wheel shakes except when applying brakes


have a wheel alignment dine ( back first then front ) as it indicates a castor wobble
could be wheel bearings , tie rod ends or suspension rubber mounts

Apr 23, 2017 | Cars & Trucks

1 Answer

I have a 2006 Scion XA that shakes when you press the gas pedal. It doesn't pull left or right and it stops shaking when you let of the gas.


i have the same experience.please check for crack or brooken plate under chases that holds the shaft of the steering wheel. it happens to my car too.

Feb 20, 2012 | 2005 Scion xA

1 Answer

Replace pressure house on 1985 mustang


For procedure to replace power steering hoses,click the link below :----http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-pressure.html
----------Also its advisable to go through this additional help links.Click the link to go through the procedures:----How to Remove Power steering Pressure Hose?

http://schematicsdiagram.blogspot.com/2011/12/how-to-remove-power-steering-pressure.html


Vacuum hose Routing diagram?

http://repairhelpcenter.blogspot.com/2011/11/vacuum-hose-routing-diagram-for-acura.html


Ac line and evaporator drain hose?

http://repairhelpcenter.blogspot.com/2011/10/ac-line-and-evaporator-drain-hose-on.html


How to disconnect the hose form the Evap Canister?

http://schematicsdiagram.blogspot.com/2011/12/how-to-disconnect-hose-form-evap.html


Vacuum Hose Routing Diagram For Throttle Body?

http://schematicsdiagram.blogspot.com/2011/12/vacuum-hose-routing-diagram-for-1995.html


How exactly the Vehicles A/C Hose works?

http://repairhelpcenter.blogspot.com/2011/11/how-exactly-vehicles-ac-hose-works.html


HOW TO REPLACE AN UPPER RADIATOR HOSE

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-upper-radiator-hose.html
HOW TO REPLACE A LOWER RADIATOR HOSE

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-lower-radiator-hose.html



Fail smog test due to gas filter hose?

http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html


EGR Hoses melting?

http://repairhelpcenter.blogspot.com/2011/12/egr-hoses-melting.html


EVAP connecting hose to PCV valve Collapse?

http://schematicsdiagram.blogspot.com/2012/01/evap-connecting-hose-to-pcv-valve.html


--------How to replace Power steering rack and pinion gear? http://technoanswers.blogspot.in/2012/02/how-to-replace-power-steering-rack-and.html
--------How to replace Power Steering Pump?

Also bleeding:

http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-power-steering-pump-on.html

----------------
How to replace Steering Linkage? http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-steering-linkage-on.html
-----Car steering wheel makes noise?

http://schematicsdiagram.blogspot.com/2011/12/car-steering-wheel-makes-noise.html

------
Car makes clicking or tapping sound? http://schematicsdiagram.blogspot.com/2011/12/car-makes-clicking-or-tapping-sound.html
---------This will help.Thanks.

Feb 16, 2012 | 1985 Ford Mustang

1 Answer

Shakes, steering wheel hard to turn. RPM's at 2 when going 15mph.


Have you checked the power steering fluid? Do the belts squeel when you turn the steering wheel?
I know this might sound silly but are your air pressures in your tyres correct? Low air pressure will cause your steering to shake at speed and it will be hard to turn at low speed.
I hope this helps,
Scott.

Apr 25, 2011 | Dodge Durango Cars & Trucks

2 Answers

Steering wheel shakes when braking and have to add coolant and oil very frequently


brakes need rotors turnd or replaced find leaks in oil and coolant

Nov 28, 2010 | 1994 Ford Thunderbird

2 Answers

Driving 50 plus MPH, why does the front end start to shake


Hi, jack up the car and hold the front wheel. Shake back and forth, and side to side. Movement sideways indicates ball joint wear, easy replacement.

Movement back and forth = wheel bearings gone.

Check the condition of the CV boot rubbers. If split, you will need new ones and to swap the CV joint.

Check the power steering fluid, if it is low then the pump might have a leak and casue the shaking from inadequate fluid supply.

Hope this helps.

Jul 13, 2010 | 1995 Jeep Cherokee

3 Answers

At 40 mph the car starts to shake. It last to 5o


I have this same car with exactly the same problem. Begins shaking at 40mph and stops shaking as soon as you let off the gas, but then begins again as soon as you press on the gas and smooths out as you get over 50. And the shaking is not felt through the steering wheel. Solution: Replace the transmission mounts. There are two of them, one on each side mounted on the frame right next to the shock strut. There is also a front and rear engine mount, but I replaced the two as described and shaking is gone.

Jun 29, 2009 | 2000 Buick LeSabre

Not finding what you are looking for?
1991 Honda Accord Logo

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...