Question about 2008 Chevrolet Impala

1 Answer

Fender removal instructions to remove left front fender on 2008 impala

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 444 Answers

It's not always real easy to remove a fender, screws/bolts under wheel house cover, at back of fender accessed from open door, possibly from behind headlight, you just have to keep looking for all the bolts til you can pull it off

Posted on Jan 04, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: removal of a cv joint from the gear box of a 2002 impala

The easiest way is to rent an inner axle shaft removal tool. You should be able to from a local parts supplier.

Ian

Posted on Aug 07, 2008

  • 10 Answers

SOURCE: I need to remove the front headrest of a 2008 chevy cobalt lt

Push the button and pull up on it at the same time

Posted on May 25, 2009

  • 1509 Answers

SOURCE: how to remove door interior to replace the handle on 2008 impala

A trim tool used for all trim work that can be aquired at auto parts stores and tooldealers looks like a forked ended screwdriver with a 30 degree bend near the end inserted under the edges of the panel and pry out the pop connectors and the panel may need to be raised up just some to unhook the top edge but the bottom will need to swing out first. Power window switches should be unhooked first, the rear edge pried up first then the switch lifted and the wire connectors removed. there are light fixtures with either the blub to remove or the connector to unplug the inside door handle may have screws behind the trim that s removed with the trim tool also. It helps removing plastic parts when warm as the cold makes the pop connectors easy to break new connectors can be baught at auto body parts and auto paint stores and sometimes regulat auto parts stores. These stores also sell the trim tools

Posted on Sep 15, 2009

  • 58 Answers

SOURCE: how do you remove the old car battery on a 2008

  1. Disconnect the negative battery cable.
  2. Remove the right front diagonal brace. The brace goes from the rad support to the fender area.Three bolts need to be removed.
  3. Reposition the positive battery cable terminal cover (1).A red cover over the positive cable at the battery.It pops off.You may need a screw driver to pop it off.
  4. Loosen the positive battery cable terminal nut.
  5. Remove the positive battery cable terminal from the battery.
  6. Reposition the underhood accessory wiring junction block.See steps 9-14.
  7. Remove the battery retainer bolts (1) and retainer (2).
  8. With the aid of an assistant, remove the battery.
  9. Remove the electrical center cover (1).
  10. Disconnect the positive battery cable from junction box
  11. Remove the fasteners (1) securing the electrical center board (2).
  12. Unlock the tabs on the electrical center board.
  13. Lift up on the electrical center board.
  14. Remove the fasteners (1) securing the electrical center bracket (2) to vehicle.

Posted on Nov 01, 2009

  • 2926 Answers

SOURCE: I have a 2008 impala

1. Put windsheild wipers in up position.
2. Remove the weather stripping from the passenger side cowl.
3.Unclip the wiper fliud hose.
4.Unscrew and remove fitting on sides of cowl.
5.Remove center screw cap
6.Take out the cowl cover. You may need to use a flat head screw driver to help it along.

Posted on Mar 13, 2010

Testimonial: "Thanks for the detailed help!!!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the driver side front fender on a 92 chevrolet s10 pickup?


remove the driver side front fender Teeta, Removing fender on your truck, Check the attached links,instruction and guides may be not identical but really close to yours. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
1994 to 2003 Chevy 10 GMC 15 Blazer and Jimmy Left Front Fender...
http://www.s10forum.com/forum/f137/s10-fender-removal-457021
http://www.automotiveforums.com/t561502-need_help_on_removal_of_front_fender_my_91_s10_blazer.html
S10 Fender Removal eHow

Jun 24, 2016 | Chevrolet Cars & Trucks

2 Answers

What size allen needed to remove break pads


Allen wrenches usually come in a set, try 3/8.

Apr 30, 2016 | 2008 Chevrolet Chevrolet Impala LS

1 Answer

Remove left front fender 1980 300sd


Remove marker lamp and headlamp assemblies.

Remove bolts behind lamp assemblies holding fender to frame of car.
Remove bolts along seam hidden under hood.
remove left front wheel and splash guard.
remove more bolts in wheel well
open left door, remove bolts in sill by door hinges.
Take lots of wires and stuff loose from fender.
Tada, fender is removed.

Dec 19, 2014 | Cars & Trucks

1 Answer

How to replace right front fender on a2007 replace fender 2007 chevy impala


There are four bolts and the hood hinge to remove on top. Remove the tire, remove the inner fender cover( seven or eight screws). There are two bolts to remove the fender from the front bumper cover. And one bolt to remove from inside the door( open the door, remove the cloth, the bolt is close to the top). Replace in reverse.

Oct 09, 2014 | 2007 Chevrolet Impala

1 Answer

How to change a coolant fan for a 2001 impala


  1. Disconnect the negative battery cable.
  2. Partially drain the cooling fan.
  3. Raise and support the vehicle. Refer to Vehicle Lifting.
  4. Remove the transmission oil cooler lines from the retainers at the bottom of the cooling fan shroud.
  5. Remove the lower fan shroud push pin retainers.
  6. Lower the vehicle.
  7. Remove the right and the left engine mount struts.
  8. Remove the left front fender upper diagonal brace.
  9. Remove the radiator inlet hose from the radiator.
  10. Remove the air cleaner assembly.
  11. If equipped remove the cooling fan heat shields.
  12. Disconnect the cooling fan shroud electrical connectors.
  13. Remove the cooling fan shroud bolts.
  14. Disengage the cooling fan shroud clip from the top of the radiator.
  15. Remove the cooling fan shroud.


25010346-uuob5xk5qpmufdktz2iyu4qm-2-0.gif

Aug 25, 2014 | 2001 Chevrolet Impala

2 Answers

Where is adjustment screw for headlights on 2008 impalla


Vic, the adjuster is either a allen key, torx, or #2 philips type bolt found close to the bolt that is holding headlight in place on inner fender rail/flange. I believe on the Impala the only adjustment is up and down of the light beam. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How to Adjust the Headlights in Chevy Impala eHow
How do you clean headlights on 2002 chevy impala
How To Change Install Adjust Headlights 2000 2005 Chevrolet Impala

Jan 11, 2012 | 2008 Chevrolet Impala

1 Answer

How do i remove the rear seat in a 2008 impala


Locate the t-handles on the left and right side of the rear seat cushion.They should be on the bottom front of the seat.Press down on the seat and pull the handles to release the retainers and pull the seat up and out to remove the seat cushion.Hope this helps.Good luck.

Feb 26, 2011 | 2008 Chevrolet Impala

1 Answer

How do you remove the old car battery on a 2008 chevy impala ss? (5.3L) thanks sam


  1. Disconnect the negative battery cable.
  2. Remove the right front diagonal brace. The brace goes from the rad support to the fender area.Three bolts need to be removed.
  3. Reposition the positive battery cable terminal cover (1).A red cover over the positive cable at the battery.It pops off.You may need a screw driver to pop it off.
  4. Loosen the positive battery cable terminal nut.
  5. Remove the positive battery cable terminal from the battery.
  6. Reposition the underhood accessory wiring junction block.See steps 9-14.
  7. Remove the battery retainer bolts (1) and retainer (2).
  8. With the aid of an assistant, remove the battery.
  9. Remove the electrical center cover (1).
  10. Disconnect the positive battery cable from junction box
  11. Remove the fasteners (1) securing the electrical center board (2).
  12. Unlock the tabs on the electrical center board.
  13. Lift up on the electrical center board.
  14. Remove the fasteners (1) securing the electrical center bracket (2) to vehicle.

Oct 31, 2009 | 2008 Chevrolet Impala

1 Answer

Where is the air pump on a 2000 chevy impALA


Underneath your driver's side front fender (in front of the tire), you will find a black removable panel on the bottom. This panel can be removed or adjusted by removing the three screws attached at the bottom (front) of the fender and two screws inside the wheel well towards the bottom front. With the car jacked up and safetly standing on jack stands, remove the front driver's side tire. You can now fold this black panel back (it has a hinge point for this purpose) and gain access to the secondary air pump.

Oct 06, 2009 | 2000 Chevrolet Impala

3 Answers

Battery changing


Ok, trust me on this one, take the drivers side tire off and remove the forward inner fender panel. If you try it without removing the tire, it is just a royal pain.

Aug 25, 2008 | 2008 Dodge Avenger

Not finding what you are looking for?
2008 Chevrolet Impala Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...