Question about 1999 Buick LeSabre

1 Answer

Cars stalling alot

Getting a mass airflow singal error code put in new senor now now it stalling more I don't no if I put it in right

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Buick Master
  • 1,250 Answers

Look for vacuum leak. if air goes into engine and the maf does not see it
look the seal at oil cap filler, look to intake vacuum and hoses
hope it helps

Posted on Apr 02, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Doubt its tranny more likely a mass airflow sensor or crank position sensor put vehicle on active scan tool while running watch the mass air sensor readout if it stops on a certain reading replace the sensor. Could also be a stuck egr pindle old engine codes would show this scan vehicle codes and get back to me

Apr 11, 2014 | 1996 Dodge Caravan

1 Answer

Code 157

Error code 157 on your vehicle indicates a problem with your mass airflow sensor. The mass airflow sensor gives a reading based on the air intake and output within the engine compartment. A properly functioning sensor will contribute to better fuel economy. In some instances, you may be able to clean your mass airflow sensor to clear the error code, but the error will most likely return in a short time. Fortunately, replacing the mass airflow sensor is a reasonably simple repair.

Read more: How to Correct Engine Code 157 '

Jan 17, 2013 | Ford Windstar Cars & Trucks

1 Answer

Airflow meter reset

their no reset unless your reseting the code after the fix go to checker auto and buy a mass air flow senor cleaner and spray the small wires in it sometimes they get dirty and dont need full raplacement. to reset the code remove the battery cable ground.

Aug 09, 2012 | 1995 Honda Civic

1 Answer

My 2005 rendezous wants to stall every time I try and pick up speed to go on the

The engine in the car is electronically controlled so the first thing that must be done is to have the systems control module scanned for fault codes before any work or parts are replaced. This may be caused by a part called a Mass Airflow senor, but that is just a guess and the part is fairy expensive.

Jun 06, 2012 | 2005 Buick Rendezvous

1 Answer

1996 isuzu rodeo keeps reading #2 misfire runs good xcept when cold it hesitates most times or jus occasionally hesitates then the check engine light flashes and its guzzling gas i only got 50 miles on a...

A misfire alarm typically means the coil pack mounted above the sparkplug indicated in the misfire had gone defective.

To test it, swap the coil pack with another cylinder, and see if the misfire goes from #2 to the cylinder you put it on.

If the misfire continues to be on #2, then consider changing the sparkplugs.

I hope this helps.

May 14, 2011 | 1996 Isuzu Rodeo

1 Answer

In my '98 Century I am having serious hesitation while accelerating... Only happens sometimes, but frequency is increasing. When the problem occurs, I will drive for a bit, and when put in park, idle...

P0101 Mass Air Flow, P0300 random misfire, Your problem is the Mass air flow, the P300 is the result of the mass air flow range, Mass air flow is a hot wire sensor they fail when contaiminated, as for the P300 that the engine detecting the condition when the mass airflow range is out, but here is another problem 1998 Buick used a back up its called a map sensor its on the top of intake plenum, make sure its seated and wire connection are there, Now you are going to fix the problem yourself if you ever taken out ,a airfilter and replaced it, then all you need to do is purchase a MAF cleaner mass airflow cleaner or brake cleaner or electrical cleaner clean the inside of your mass airflow you dont have to replace it the code is range performance the hot wire cant clean itself, so someone has to do it

May 04, 2011 | 1998 Buick Century

1 Answer

I get codes P0102 and P1128. My mechanic says I need to put a new mass air flow sensor on and it will take care of the problem. Is this correct?

This could very well be correct I believe code P0102 is the mass airflow circuit low input. P1128 should be a lean code.

I would first try cleaning your mass airflow sensor with a carb or throttle body cleaner, they have a tendency to get dirty and not read correctly.

Dec 13, 2010 | 2001 Volkswagen Cabrio

1 Answer

Rav 4 2004 stalls, sputters won't run changed plugs, ignition coil and camshaft senor.Put in cleaned used mass air thing.Sometimes code says cylinder one misfiring. What's the problem?

Change your plug wires. If you want to, switch wires with another cylinder. If the misfire moves to the new cylinder, you found your bad wire.

Feb 20, 2010 | Toyota RAV4 Cars & Trucks

2 Answers

Engine stalls while driving and sometimes while idling.

The stalling problem could be caused by a faulty mass airflow sensor. That is the PO100 code. The other code is for the engine coolant temperature sensor. Go to the autozone website at autozone .com and register your vehicle. It's free and you will have access to an online repair manual. The procedures for testing the MAF sensor is outlined there. Hope this helps and you find a resolution to your problem. Best wishes.

Jul 23, 2009 | 1996 Subaru Legacy

1 Answer

95 volvo 940 jetronic error codes 113 212 232

Change the the O2 senor on the catalytic convert. Its probably dead.

Jan 15, 2009 | 1995 Volvo 940

Not finding what you are looking for?
1999 Buick LeSabre Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides