Question about 2010 Citroen C1 1.0

Open Question

Emission control system warning lamp on

Is the car still ok to run

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22156 Answers

SOURCE: My Citroen Berlingo 1.6 CDi Emission control system warning light.

Need new heaters for the starting ,as for the emmisions light then this is another problem ,on the exhaust is a NO2 filter abd its blocking up ,whet you need to do is add a bottle of diesel injector cleaner ,dont read the instructions just add a bottle to half a tank of fuel or more and then drive at legal speed limit for half hour or so and this should clear it out if it doesnt ,wait till fuel level goes down and refill and another bottle it will clear the filter out eventually .Now if the heaters dont cure the starting then fit a non return valve on the fuel inlet pipe as well

Posted on Feb 21, 2016

Testimonial: "I put a bottle of injector cleaner in the tank and it's worked, the warning light has gone and no more smoke on start up. Just got to sort the heaters out now, booked in for tomorrow. Thanks."

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I clear a service emissions message on a 2005 Mercury Mariner with a 3.0L engine. I have performed the required maintenance procedures at both 30,9000090's and 60,000miles. Still have message.


Warning Messages The warning messages can interrupt the display until cleared or reset by the driver. The warning messages are either single cycle, non-resettable, or repetitive warning messages.
The single cycle warning messages display once whenever the ignition switch is turned to the ON position or a fault occurs in a system, and can be cleared by pressing the RESET button. The single cycle warning messages are:
  • liftgate ajar
  • liftgate glass ajar
  • service emission system
  • low brake fluid
  • service brake system
  • check left headlamp
  • check right headlamp
  • check left turn lamps
  • check right turn lamps
  • check left high beam
  • check right high beam
  • check brake lamps
  • check parking lamps
  • washer fluid low
  • check fuel cap
  • change oil soon
  • change oil now
  • low fuel
  • service 4x4
  • turn signal on

Jun 15, 2016 | Mercury Cars & Trucks

1 Answer

Emissions warning light


no year, car, or model. stated?
nor engine option, , (strike 3)
and makes any answesr impossible
and there is no Emissions light, you named it wrong.
my wild guess is its the Check engine light or CEL or MIL
seen
here
http://dashboardsymbols.com/the-symbols/

if the CEL glows, get car scanned.
on cars with automatic transmissions, if it fails the same lamp glows.
cleaning it , is no trivial task.

Feb 20, 2014 | Suzuki Cars & Trucks

1 Answer

Diagnostic code p0701


P0453 means EVAP emission pressure sensor high input. Possible causes:
- Faulty Evaporative Emission System (EVAP) Pressure sensor
- Evaporative Emission System (EVAP) Pressure sensor harness is open or shorted
- Evaporative Emission System (EVAP) Pressure sensor circuit poor electrical connection.
Code p0701 means Transmission control system range/performance. Possible causes:
- Open or short transmission control system circuit
- Poor transmission control system electrical connection
- Check powers and grounds to Transmission Control Module (TCM)

Aug 27, 2013 | Cars & Trucks

1 Answer

Toyota echo won't start code 440 441 446


Error Code: P0440
Fault Location:
Evaporative Emission (EVAP) System - Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Soution:
Check Evaporative Emission (EVAP) System Sealing.
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .

Error Code: P0441
Fault Location:
Evaporative Emission (EVAP) System - Incorrect Flow Detected
Possible Solutions:
Check Evaporative Emission (EVAP) Canister Purge Regulator Valve .
Perform Output Test.
Check Evaporative Emission (EVAP) Canister Purge Solenoid Valve .
Check Evaporative Emission (EVAP) Canister.
Perform Basic Setting.
Check Pipes between Tank Breathing and Throttle Body.

Error Code: P0446
Fault Location:
Evaporative Emission (EVAP) System, Vent Control - Circuit Malfunction
Possible Cause:
Wiring harness.
Evaporative emission (EVAP) canister purge valve.
Engine control module (ECM).

Feb 25, 2013 | 2002 Toyota ECHO

1 Answer

Yellow engine light has been on for 2 days but the car runs perfect. What could it be?


This is the Check Engine warning light (the light is required by law to be amber/yellow, it means that a problem or problems have been detected in the electronic engine control or the emission control system. this control system is called the OBD2 Electronic engine/emission control system. This system has over 200 possible faults that turn this warning light on, what needs to be done is to have the system scanned to see what fault codes are in the memory of the computer (called the PCM), it can be as easy as a defective or loose gas cap on up to Oxygen sensors failing, it is a long list, so the system scan is the very 1st thing that must be done to start the diagnosis.

Mar 18, 2011 | 2006 Ferrari F430

1 Answer

1999 saturn light with a wrench is on. Disconnected batt. But that didn't work


Hello. this is a warning indicator. this light is on because there is either a problem with the engine control system, or even possiblity the abs unit. you will need to have the vehicle scanned for trouble codes to see why this light is coming on.

The SERVICE (Wrench) telltale is pulled to ground by the powertrain control module (PCM). When the lamp is pulled to ground, current from the ignition circuit flows through the indicator lamp, allowing it to come ON. The PCM will turn the SERVICE (Wrench) telltale ON for all non-emission related DTCs that require that a telltale be turned ON (some DTCs do not turn on a telltale but are stored to aid in diagnosis).
The SERVICE (Wrench) telltale will also be turned ON if the ABS control module has detected a fault in its own warning indicator system. If the ABS system cannot turn on its own telltale, a message will be sent to the PCM through the class 2 data bus (circuit 1807) to turn on the SERVICE (Wrench) telltale.
The SERVICE (Wrench) telltale will be turned ON for 2-3 seconds when the ignition is turned to RUN for a bulb test.

Jun 23, 2010 | 1999 Saturn SL

1 Answer

2005 Audi A4 Emission Control System Indicator Warning Light is on. What does that mean?


A vehicle's Emission Control Light is a generalized indicator that there is fault or possible malfunction in the vehicle's operating system. In some cases, these warning lights will come on if a gas cap is not fully closed. It could any one of a number of sensors such as the o2 sensor or map sensor. The thing to do is have a reputable mechanic/technician run a diagnostics test on the vehicle.

Aug 20, 2009 | 2005 Audi A4

1 Answer

Malfunction Indicator Lamp Illuminates: Chev Aveo 2005


U can still drive the car, the light means that a malfuntion has occured in the engine/emission system electronic controls, have the system tested for the trouble code that was stored with the light.

Jun 18, 2009 | 2004 Chevrolet Aveo

1 Answer

Brake warning lamp on steady only when engine running. Brake fluid level is ok. General brake operation is normal. When park brake set, brake warning lamp is brighter. Is it possible that the rear brake...


No.
It might be in the switch for the parking brake. Try to release it a little more with your hands. It's either in the parking brake system or the regular brake system. Anything ABS has it's own warning light. Have it checked by a tech; it's a safety item, ok?

Jun 17, 2009 | 2003 Chevrolet Tracker

1 Answer

Emission control system light on dash


audi a4 tdi Emission control system light on dash

Jun 02, 2009 | 2007 Audi A6 Avant Wagon

Not finding what you are looking for?
2010 Citroen C1 1.0 Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...