Question about 2001 Mitsubishi Pajero

1 Answer

Flikkers don`t work.Just working when it`s fors

Flikkers work and just by the next turn stop working

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 71 Answers

I need more information.
What happens exactly when you try each side when the vehicle is stationary.
ie: Do they work normally?
In not, does 1 side work, or do the both only work for a few clicks?

Posted on Apr 01, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When start my opel astra 96 and in idle my engin light flikkers and go away for few seconds


throw a scan tool on it. the ecm should store the code even if the light went out. that will tell you the code and why it was on

Mar 13, 2014 | Cars & Trucks

1 Answer

Which fuse is for the rear outlets on 2008 veracruz


For Hyundai Veracruz, rear outlet fuse box is in engine compartment. On left side (next to blue water cap). Refer to manual page 7-47 and 7-51. There is two 30Amp fuses.

Feb 15, 2013 | Hyundai Veracruz Cars & Trucks

2 Answers

Our masterbedroom light started flickering, sometimes making a little buzzing noise and then it stopped working. Now the living room light which is right next to the bedroom flickered a couple of times and...


I found this posted in the car section, but I will post an answer anyway.
You have a short in the house wiring. Could be in the switches, or the light fixtures, or the wiring going back to the breaker.
Yes it could be a fire hazard if not repaired.
If you can't get it fixed before you leave town, I would turn the breakers off for that section of the house.

Dec 14, 2012 | Cars & Trucks

1 Answer

The auto. door locks, radio, and dome lights not working


You have burned out the vehicle's controls modules, call your insurance company, they should cover this type of unfortunate mistake.

Jun 15, 2017 | 2000 Mazda MPV

1 Answer

1997 Cadillac Deville wipers stopped working


Just by your discription of the way it acted up i would think it's the pulse board . This pulse board screws on the wiper motor .

Go to Bing homepage

http://www.autopartswarehouse.com/shop_parts/wiper_pulse_module/cadillac.html

Mar 27, 2017 | 1997 Cadillac DeVille

1 Answer

2000 chrysler concorde turn signal/hazards don't work fuses good changed multifunction switch still no go whats next?


I am having the same problem with my 1999 chrysler concorde amoung other problems. But they will work at times and then they will just stop for no reason. Have you found any solutions yet?

Aug 24, 2011 | 2000 Chrysler Concorde

1 Answer

I have a 1996 Jeep Cherokee. Headlight Problem: Year ago? Switched on high beams, complete darkness (low beams don't work at the same time I've come to find out). Solution: Don't turn on...


ok, first ,, check all the bulbs again, and *** make sure that your hands never touch the actual bulb, these lights will turn the oils from your hands into cooking grease when it comes to these bulbs and cause them to blow out much to early on in their life span, , next,, Pull the light switch ( high beam switch towards you for a quick flash of the head light high beams,, if this doesn't make the high beams come on, your problem is going to be in the switch itself ( what your calling the high beam/turn signal lever) before going to that extreme though,, if you have a junk yard near you, go pull one of the relays off a junked vehicle, and stab it into your system one at a time, it could be something as simple as a relay heating up and disconnecting prematurely due to heat ,, if you don't have a junk yard that you can grab a relay,, here is a link that shows how to check them, But its time consuming http://www.youtube.com/watch?v=C8t25GjZ6i4&NR=1

Aug 10, 2011 | 1996 Jeep Cherokee Sport

Not finding what you are looking for?
2001 Mitsubishi Pajero Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...