Question about 2005 Chevrolet Suburban

1 Answer

Fuse blows out 5-10 min after replacement

Fuse blows out just minutes after replacement for heated front seats, both power chair adjusters, power pedal adjust, and passenger side only power windows (front and rear). Power locks still operate, power windows still operate on driver's side (front and rear). These accessories will operate for a very short time after fuse replacement, but it's not necessary to use any before fuse will go out. Fuse will burn out even if none of these items are touched during operation of the vehicle. All it takes is starting the truck and waiting a few minutes. The passenger rear window had started dragging pretty badly and then stopped functioning a few weeks before the fuse business started. When operating the switch, there was an obvious heavy electrical drain. Thinking this could be the culprit, I disconnected the motor and switch from the harness inside the passenger rear door. Fuse blowing problem remains. Not sure where to start looking for this, any help greatly appreciated.

Posted by on

  • Keven Burress
    Keven Burress Apr 01, 2014

    I disconnected the power window motor and switch just as a test by the way, wasn't an attempted fix.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Check all your wires ,make none have rubbed and exposed the bare wire .vibrations might cause the wire to short out on metal

Posted on Apr 01, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heated seats


fuse is the go to area for electrical problems- if it keeps blowing fuse then look for problem in the seat cushion areas- Denny

Dec 31, 2013 | 2006 Nissan Maxima

1 Answer

On a 2004 BMW X5 4.4L Eng, The Fuse # 26 blows when ever I start the car. But if I turn Key on with the eng off. it does not blow. Any Ideas? The Fuse 26 & 32 are for the front power seat


Fuse 32 is for heating for seat 26 adjustment driver seat they are both related they go in the motor seat adjustment, you may have a rub thru wire as it reaches a certain position then it blows

Jun 08, 2011 | BMW X5 Series Cars & Trucks

1 Answer

2006 tahoe with heated seats. when the seat is


The heating element in the seat may be failing, even thogh it heats the seat, the element could be causing the circut to spike upon power shut down. Relay takes mili-second to shut down after ignition kill and power feed comes direct from battery. Check amp. draw at switch of bad seat and good seat upon shut down. If bad seat higher that 5 amp difference element n/g. Also check for bad relay as they can short internal and cause problems if primary power cut before switch shut down.

Jan 30, 2010 | 2003 GMC Sierra 1500

2 Answers

What would cause my power seats to just stop working


You blew a fuse or a relay if not the wires are probably nicked and grouned out to the chair causing a fuse to blow

Jan 15, 2010 | 1997 Ford Mustang Cobra

2 Answers

The driver seat heater just quit. all fuses are good. how do you tell if the relay is good?


Swap it with a relay you know to be good and see if it works again,pick a relay that is not important to the function of your car.

Nov 01, 2009 | 2004 Cadillac SRX

1 Answer

2003 Chevy s 10. The fuse marked cruise control module, body control module, heated seats (it doesn't have heated seats) keeps blowing. It can happen 1 minute down the road or 10 minutes. The odd thing is...


The fuse in question also powers the instrument panel cluster ,also goes to SP200 -splice pack 200 where it powers BCM , CCM,multifunction switch - turn sig. headlamp dimmer switch and the WSW .Also if you have utility vehicle without memory seats it powers the front seats lumbar switch . Do you know how to check circuit's for a short ? Locate SP200 Splice Pack SP200
(CKT 41, CKT 241, CKT 341, CKT 817) Strapped to the body harness, under carpet in the RH dash area about 30cm (12 in) from the right kick panel .Do you know what a splice pack look's like ?




gm splice pack-5vwjdo4vj5u5qn0cs4zh2oxv-4-5.gif Disconnect circuit's one at a time till the fuse doesn't blow , then you found the problem circuit or componet . Disconnecting the BCM will cause the vehicle not to start an run . Anti-theft system . You mite try having the BCM checked for DTC'S - diagnostic trouble codes

Oct 24, 2017 | Chevrolet S 10 Cars & Trucks

2 Answers

A/c fan only blows to floor will not adjust to dash vents


Under the back seat on the drivers side is a fuse panel. Fold the seat forward, remove the fuse block cover, and locate the HVAC fuses.They are 10 amp fuses, remove the fuses and let set for 5 min or so. Reinstall the fuses, start the vehicle and the A/C system should do a relearn. It will take1 minute to do so do not touch any controls for at least 1 min. This should help. Good Luck

May 14, 2009 | 2003 Chevrolet TrailBlazer

2 Answers

Seats not heating on either of front seats. Also seat adjustments are not working


I have the very same problem, no seat heat on either side and no power seat control on the drivers side. anyone know which fuse or switch operates the drivers side power seat? Thanks

Nov 13, 2008 | 2006 GMC Sierra

1 Answer

Front passenger power seat inoperable


That is the power distribution center, the fuse box is under the dash to the left of the steering column under a cover, they are marked, the plastic cover will have FUSES molded into it.

Oct 13, 2008 | 2003 Chevrolet Trailblazer Ext

Not finding what you are looking for?
2005 Chevrolet Suburban Logo

177 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...