Question about 1994 Mazda 323

1 Answer

What should I do I've tried just about everything

Have a 94 Mazda 323 changed coil distributor ECM spark plugs rotor still no spark it turns off but won't start help please...

Posted by on

1 Answer

I don't know who has been working on your car,
but I'm guessing all that is being done, is throw
parts at it.

You replace NO Parts until you do some testing &
find a failed part

By then, you most likely found the problem

If that work was done at any number of repair shops,
then they have no idea how to diagnose or test a vehicle.

Posted on Apr 01, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mazda etude 1.8 no spark


If you do not have any spark ( petrol engine ) check for distributor cap, rotor arm, ignition module inside the electronic distributor, or any loose wiring connected on distributor or ignition coil or any wire.Also check and the HT Leads.

Jul 02, 2014 | 2003 Mazda 323

1 Answer

Car turn over but won't start changed the fuel pump filer coil


Make sure the spark plug leads are in the correct order, if you changed the distributor have you set its timing yet?

Dec 21, 2013 | 1994 Mazda 323

3 Answers

94 Acura Integra wont Start


jump timing loosen distributor and plus or minus turn and retighten

Mar 09, 2013 | 1994 Acura Integra

3 Answers

I have a 1987 Dodge dakota and can't get any spark?


You need to see if you have voltage at the coil with the key on.
Make sure the check engine light comes on when you turn the key on.
If not, check the ASD relay in the engine compartment.
You will need a book and a meter to test the other components.

Jul 03, 2012 | 1987 Dodge Dakota

1 Answer

94 toyota corolla engine problems


should be idling roughly
engine check light on ?

faulty coil ok when cold no good when hot

do a compression test on number four
no compression on cylinder four

leaking intake or exhaust valves
the injector isnt working
if everything looks ok and no better
a blown head gasket
index-2zip2i3kmrsufpvzy1ztx3gq-4-0.jpg

Mar 21, 2017 | Toyota Corolla Cars & Trucks

1 Answer

I have a Mazda astina 323 94 model it cranks but won't start doesn't seem to be any spark from the leads I have recently changed the leads , Im guessing it's the coil and distributor cap please help


1 remove the cable from the coil to the distributor.
check this agains earth, when you turn the engine over.

if spark, suspect rotor arm is not setting spark to each spark plug lead.
open distributor and clean the rotor arm with a cloth or wire wool
not sand paper as this will take off too much and cause a problem

2 check inside distributor for moisture. spray inside with WD40 or equiventy water repelent.

3 if not spark at coil open distriutor cap and with ignition on, open and close points in distributor with a screw driver and check coil again against earth again if you get sparh, problem is points not opening and closing.

4 turn over engine with distributor cover removed to see if rotor arm is moving if not then cam drive to distributor is defective. this controls points and rotor arm.

if rotor arm turning and spark at points but no spark at coil suspect Low tension wiring or coil needs replacement.

i hope this was helpful

Dec 12, 2010 | Mazda 323 Cars & Trucks

1 Answer

Turned off then wouldnt start ,took ignition apart cleaned up ,no spark to plugs cap,rotor ,wires good power to coil and module


If there is no spark to the plugs, but good cap, rotor and wires; then if the there is good power to coil and module, then the module or coil must be bad.

Aug 01, 2010 | 1989 Mazda 323

1 Answer

Mazda 323 wont start until cold


If this vehicle has a distributor, try replacing the pickup coil. This should be located under your distributor cap and is responsible for spark. When your engine compartment gets warm from normal conditions, this plastic piece of **** shrinks and the metal tab attached to it doesn't make a good enough connection to conduct the electric spark to your plugs. Hope this helps!

May 23, 2009 | 1994 Mazda 323

2 Answers

94 toyota camery no spark


I had the same problem recently but replacing the ignition Coil under the distributor (inside) solved the problem. Also replaced the distributor Cap and rotor at the same time.

Jul 18, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
1994 Mazda 323 Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...