- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Transmission Floor Shift Control Indicator Lamp Replacement
Remove the front floor console. Refer to Front Floor Console Replacement.
Rotate the floor shift control indicator lamp socket (2). Pull the socket from the trim bezel.
Remove the bulb from the socket.
Front Floor Console Replacement
Remove the rear floor console. Refer to Rear Floor Console Replacement.
Remove the instrument panel lower trim plate. Refer to Instrument Panel Lower Trim Plate Replacement.
Set the parking brake, then shift the transmission into drive and push the shift indicator down until it locks, to allow clearance to remove the console.
Front Floor Console Screw (Qty: 2)
Caution: Refer to Fastener Caution in the Preface section.
2 N·m (18 lb in)
Front Floor Console Bolt (Qty: 2)
10 N·m (88 lb in)
Front Floor Console Assembly
Front Floor Console Retainer Clip (Qty: 2)
It wouldn't even be in a repair manual-seldom needing replacement. Where is it? If on the instrument panel- hard to get to- the cluster has to come out to replace the bulb. If on the center console-much easier- just pull the top of the console off, shifter, indicator there? The bulb should be easy to get to from there.
That is a very tough bulb to replace. Once you get the center console pieces out of the way there should be a couple of screws or blots that hold down the trim around the gear shift. Remove those and lift gentley. You will barley be able to access the bulb. but it can be done.
If the shift console is on floor then look for bolts holding it down. Take out bolts and then you can maneuver console so you can see where light is plugged in and get the right light to replace it. It will probably be a small light which tend to cost a bit more, but at least you'll have the light back.
The center console needs to be removed, pull the shift plate plastic
cover off, remove two bolts inside the console storage box, remove the
phillips screws that are visible, the front center storage box also has
to be removed, the bulb is located on the left side of the shifter from
Hope helped with this (remember rated this help) Good luck.
Remove the center console.
There will be a bulb underneath the PRNDL(Park, Reverse, Neutral, Drive, Low) - quarter turn to the left. Pull bulb down; put new bulb in - put back in hole quarter turn to right - reinstall center console...
Transmission shift indicator light on center console. First make sure the fuse is good. If the fuse is good then remove the screws holding the center console cover. You will need a long and short phillip screwdriver. Look for screws in the cup holder, under the handbrake handle and where the console runs under the dash. You may have to move seats forward/backward to reach the screws. When you attempt to raise the console cover you will notice you overlook a screws. Remove them also. You may be able to reach the bulb without removing the gear shift handle. DO NOT TOUCH any other electronics you see. The AIRBAG ACTUATOR is located here also. Replace bulb. Test before reassembly. Good Saturday morning project.