2001 Ford Windstar Logo

Related Topics:

April Posted on Jun 15, 2009

Engine cool fan won't work 2000 Ford Windstar

BUT my AC works fine? Aren't they connected? If not how do I find the correct fuse and relay. Buddy's dog ate my book :(

5 Related Answers

dustyboner

alex metro

  • 364 Answers
  • Posted on Oct 22, 2008

SOURCE: 1996 windstar relay

The fuel pump power on the Windstar is controlled by a component called a Constant Control Relay Module (CCRM).
Its located located on the driver's side of the engine compartment.d7fb0ae.jpg

Ad

Anonymous

  • 94 Answers
  • Posted on May 27, 2009

SOURCE: cooling fan relay

its not an actual relay is like a relay assembly

Constant Control Relay Module (CCRM)


The Constant Control Relay Module is located at the LH front of the engine.

Anonymous

  • 104 Answers
  • Posted on Jul 15, 2009

SOURCE: Radiator cooling fan fuse location for Ford Taurus

The cooling fan on a ford car usually does not have a fuse. The cooling fans are controlled by a relay in the power distribution box inside the engine compartment. The box is usually located near the battery. Your owners manual should have a guide showing you what each relay in the box is for.

Anonymous

  • 3 Answers
  • Posted on Jul 16, 2009

SOURCE: 2000 ford windstar power door locks do not work

The actuactors for your locks have a little motor in them. In this motor there is a resistor that will give out over time. Usually the locks gradually stop working over time. You can remove the actuator and take it apart and fix by removing the resistor in the motor and putting a peice of copper in its place. Takes about 30 minutes per door if you know what you are doing. Do a google search for ford windstar door lock fix and you will find several blogs with detailed descriptions of the repair.

for_df_250

  • 2 Answers
  • Posted on Dec 15, 2009

SOURCE: need to find circuit/relay location for cooling fan. fuse is good, fan motor tested fine. need wiring schematic

where is the cooling fan relay located on a 92 taurus

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Fan not working

check fuses & relay. Probably need workshop manual from local auto store to locate relay. Check earth connections coming off fan motor to body, are clean & tight.
0helpful
1answer

My cooling fans dont work, and the heater blows cold air.

head gasket is blown....big job and expensive
3helpful
3answers

Engine cooling fan only works when ac or defrost is on

if engine at long stand still,the engine temperature will rise about 190 degrees the cooling fan suppose to automaticaly turn on when coolant temperature sensor get hot it cause its resistance decrease causing pcm to send power to coolant fan relays and cooling fans, when you turn on AC the cooling fans suppose to turn on to cool down AC CONDENSOR, IF NOT AC WONT WORK COOLING FAN COOLS DOWN REFRIGERANT SO IT CAN RECYCLE THROUGH THE SYSTEM AGAIN.your cooling is suppose to turn on when engine at a sit still if vechicle not moving as coolant temperature rises at a set point the cooling fans will turn on cool down engine.cooling fans dont turn on when you first cold stsrt vechicle unless you have AC SWITCH ON.if cooling fans dont turn on when vechicle at a long stand still or moving along slow traffic.if coolant temperature sensor been replaced and fuses and relays okay have dealership check see if pcm driver circuit working faulty pcm will cause cooling fans not to turn on.
0helpful
1answer

AC and Cooling Fans Not Working

Try installing a jumper across the N/O terminal at the relay socket. Temp sensor in the radiator or in the thermostat housing supplies the signal for the relay the other relay signal is supplied by A/C in on position. both fans will run continuous with A/C on. One fan runs intermittent relative to water temp. Be careful not to blow a head gasket. If you leave the jumpers in place, the fans will stop when the ignition is turned off, save the engine until you isolate the relay signal problem. then simply remove jumpers and reinstall the relays
2helpful
3answers

Ford focus 2006 engine overheating once ac swicth is on..

CHECK TO SEE IF COOLING FAN IS RUNNING.IF NO CHECK COOLING FAN FUSE AND RELAY.THE COOLING FAN NEED TO BE RUNNING WHEN AC ON BECAUSE AIR CONDITIONER PUT A LOAD ON ENGINE.COOLING FAN KEEP RADIATOR AND AC CONDENSOR COOL.FAN NEED TO RUNNING.
1helpful
1answer

1996 Honda Odyessey engine cooling fans don't come on and engine on and engine temperature tends to go up. it will only come on when the AC is switched on. i do not need to run the AC all the time but i...

Check all fuses first. if the fuses are okay, disconnect the engine cooling fan connector and using jumper wires, connect the fan motor directly to the battery and ground. If the fan still doesn't work, replace it. If the fan does work, its relay may be faulty. Check in the engine compartment fuse box for the cooling fan relays. Try switching the cooling fan relays and see if the engine fan comes on and the a/c condensor fan stops working. If so, the engine cooling fan relay is faulty. If the engine fan still doesn't come on with a good relay, then check the engine temperature switch located at the passenger end of the front cylinder head. It is supposed to switch (have continuity) when the engine temperature reaches 205 deg F. You can remove the switch and put it in a pot of close to boiling water (212 deg F). If it doesn't have continuity at that temperature, it is defective.
2helpful
1answer

2004 Ford Focus overheating when ac is on. no leaks, fluids are fine too. ac isnt as cold as it used to be either.

sounds like your engine cooling fan is not working. it should come on when the AC is on. there is a relay that controls the radiator fan . It's a 5$ part at rockauto.com . check fuses first.
0helpful
1answer

2000 FORD WINDSTAR A/C NOT COOLING IN THE FRONT

well there could be 2 problems...1. might be that your ac needs to be rechargedor 2.your ac pump/and or compressor is out
0helpful
1answer

1995 Ford Windstar wont start win the cooling fans are on

If cooling fans are running then the PCM is not powering up. Check or replace the PCM relay in the under hood fuse panel
Not finding what you are looking for?

239 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...