Question about 1997 Ford Expedition

1 Answer

Rear washer ford expedition

The rear washer starts spraying on it's own until the reservoir is empty and the pump keeps running until I finally pulled the plug. I'm wondering if it could be the switch on my turn signal, or something else. Any ideas?

Posted by on

  • Dave Peterson Apr 03, 2014

    I can hear the pump running and it doesnt stop until I pull the plug. I have plent of relays to consider, any idea which one?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Ford Master
  • 2,620 Answers

Would check the relay or fuse first.The relay could be sticking.

Posted on Apr 01, 2014

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
01fordeb
  • 1033 Answers

SOURCE: 1998 ford expedition front windshield washer

fuse for washer pump, can you here the pump, if not then power to pump isn't present. Check the fuse for it.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the rear windshield fluid reservoir located on a 1994 Toyota Camry Station Wagon?


not 100% on this, but typically, you have to open the back hatch, and there will be a small rubber cap over the opening for the washer fluid located on or near the top of one of the taillight lenses on either side of the vehicle.

Apr 23, 2017 | Toyota RAV4 Cars & Trucks

4 Answers

My 2004 Ford Expedition will not spray windshield wiper when the button is pushed. The wipers do turn on, but no spray. Would this be caused by a fuse (the wipers do turn on) or is the motor bad?


Can you hear the washer pump running when you operate the washer switch? The washer pump is in the bottom (side) of the washer fluid reservoir. You should hear it running. If not, you can disconnect the wire connector at the pump and use a test light to check to see if there is power and ground at the connector when you operate the switch. If there is power and ground, replace the washer pump motor. If there is no power or ground, you most likely have a bad washer control switch. (You have to replace the entire Multifunction Switch)

If you can hear the pump running, check for washer fluid pouring on the ground. If this is the case, you have a broken hose between the washer pump and the jets that spray on your windshield.

Also note that there is no way possible that your problem could be CAUSED by a fuse!
For more information on this subject, please review this article: Where's The Fuse?

May 17, 2011 | 2004 Ford Expedition

1 Answer

1997 ford expedition will not start turns over


Try spraying starting fluid into the intake of the air cleaner while someone else starts the car. Keep a continual spray going while the car is cranked. If the car starts more than likely the fuel pump went out.

Jan 25, 2010 | 1997 Ford Expedition

1 Answer

WINDSHIELD RESERVOIR RAPIDLY EMPTIES WHEN WASHER FLUID IS ENGAGED. THE RESERVOIR RETAINS FLUID WHEN THE PUMP IS NOT ENGAGED.


There a small diameter hoses that run the the nozzles for the front and rear windshield. More than likely, one is loose or cracked and is leaking. Do you have good spray on the windshield as you operate it? Is one weaker than the other? - If so, you definitely have a leak in a hose or nozzle. Another common leak area is around the reservoir edge or near the pump. The pump commonly resides at the bottom of the reservoir.
Hope this helps!
Rate this solution!

Jan 05, 2010 | 2005 Chrysler Town & Country

1 Answer

Washer wiper not working, possibly used when


the fuse is the same as for the wipers and push on washer switch and see if you can hear washer pump run,otherwise try this (unless the motor pump has been dry run too long and ruined pump assy) and can't pump any longer go to a garage that has compressed air and at the wiper nozzles first gently blow air into each nozzle, then go to reservoir and remove supply hose to wiper nozzles and blow air gently and see if there's an obstruction in the line, you can use say 30 lbs max,reason being if any hoses where you cant get to them they can blow off fittings, also take air hose and on top of reservoir blow into hole on top of reservoir to push product thru lines and help pump (same as removing hose) on reservoir, I bet its unprimed itself or blocked with dirt,try this first

Oct 13, 2009 | 2006 Ford Focus

1 Answer

2003 Ford Expedition Rear Drivers Side Window


get a can of silicone spray lube from a hardware or auto parts store and lube the glass run channels, pour/spray it in there until it runs out the bottom of door, the run the window up and down a few times, this should cure the problem. keep it off the paint and plastic parts.

May 05, 2009 | 2003 Ford Expedition

1 Answer

Wash wipe on a Focus 2000 model


I blieve it's the same pump taht runs the rear and front washers.

The windshield washer comprises the following parts:
  • Windshield washer reservoir, below the front left-hand fender
  • Washer pump, on the outside of the washer reservoir
  • Two washer nozzles on the hood/bonnet, adjustable.
---------------------------------------------------------
Windshield Washer Pump and Reservoir Removal
All vehicles
  1. Remove the windshield washer reservoir filler neck.
  1. Raise and support the vehicle. For additional information, refer to Section 100-02 .
  1. Remove the right-hand fender splash shield (wheel shown removed for clarity).
  1. Remove the washer reservoir.
    • Disconnect the electrical connectors.
    • Pull off the hoses.
  1. Remove the windshield washer pump with rubber gasket (shown with reservoir installed).
    1. Disconnect the electrical connector.
    1. Disconnect the hoses.
    1. Lift out the pump.

Feb 27, 2009 | 2000 Ford Focus

1 Answer

Wipers


Fuse #11 is the one to pull.
30A Runs Front Washer Pump Relay, Wiper Run/Park
Relay, Wiper Hi/LO Relay, Windshield Wiper
Motor, Rear Washer Pump Relay

Nov 21, 2008 | 2000 Ford Expedition

Not finding what you are looking for?
1997 Ford Expedition Logo

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...