Question about Jeep Cherokee
I have a 1996 jeep Cherokee country and the driver side door would not open... So I took the lock mechanism out and the spring that goes on it broke. So I need a diagram of where the spring goes on the mechanism
Why not go to any dealer or there online page and read.
all cars, today have on line ordering with full drawings.... its not a new deal this.
drivers door, right>?
here are all the parts.
now you are IMPOWERED
also there is a FSM
what more can you ask?
Posted on Apr 01, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the same problem with now power to windows, mirrors and seat. The common soulution is the orange and or black wire in the boot have broken between the door and post.
Posted on Dec 07, 2008
SOURCE: Jeep Cherokee door lock repair.
heard of your problem! open drivers door,look at door jam were wiring harness comes out of body,thier be a break in main door harness! peel back rubber boot and tug on wires.
Posted on Apr 22, 2009
according to my partsman (who has had great advice for many years), you do not have to remove the door panel to replace the door handle which contains the cylinder lock. the handle is released with a screw which you can see when you open the door. you will need a starhead screwdriver or socket. A new handle costs around $40 at a parts store in my area. call around for a locksmith who will re-key your key to the new lock or use the key which comes with the new lock, your choice. i am in dealing with this also
Posted on Jun 07, 2009
Lock and unlock both run off the same power supply...I'd be looking for a bad switch or a broken wire in the door harness where the wires go through the rubber boot between the door and pillar.
Posted on Feb 08, 2010
Tips for a great answer:
Apr 02, 2015 | 2001 Jeep Cherokee
Dec 08, 2013 | 1995 Jeep Grand Cherokee
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
Feb 11, 2013 | 1996 Jeep Grand Cherokee
Nov 07, 2012 | 1996 Jeep Grand Cherokee
Aug 21, 2012 | 1997 Jeep Cherokee Country
Apr 29, 2012 | 1997 Jeep Cherokee
Nov 09, 2010 | 1996 Jeep Grand Cherokee
Jul 03, 2010 | 1996 Jeep Grand Cherokee
Nov 16, 2008 | 1996 Jeep Grand Cherokee
55 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: