Question about Honda Civic

1 Answer

Car wont start

Tuned up my car it started went back to drive it put it in gear started and stalled now it wont start

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 65 Answers

First of all, I need info. Year? Engine? mileage? conditions? What all was replaced? By tune-up I'm assuming you replaced plugs/wires/cap and rotor/etc. On earlier Civics it is VERY easy to miss the coil tower with the contact pin while installing the dist. cap. And it's also easy to knock one of the wires off of the igniter/ignition module while doing so as well. Also, if you replaced the fuel filter, keep in mind you'll have to give it a couple key cycles to prime the new filter. Hope that helps. Post back if you still have a problem.

Posted on Apr 01, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2005 g6 stalling

I would suggest checking your wiring (core wire on the distributor, plug wires and the negative battery ground) I would imagine that the forward motion of the vehicle is possibly making your wires lose connectivity and making the car stall. Just a thought though.

Carl

Posted on Oct 03, 2008

  • 8 Answers

SOURCE: 91 camry starts and shuts off when put in drive or reverse

I was an ASE master auto tech for 13yrs and have seen this problem before. It sounds like the idle air control valve on the intake manifold has stopped working and the idle speed is not being controlled(letting the engine idle too slow which causes a stall when put under a load such as putting it in gear). Try giving it a little throttle while putting it in gear if that works let off the throttle if it dies you will know the Idle Air controll is not working.

Posted on Oct 31, 2008

  • 109 Answers

SOURCE: nissan sentra 1997 starts but wont go when put in gear

is it a manual or automatic?if it's manual check clutch.if it is automatic check transmission fluid.

Posted on Dec 02, 2008

  • 1619 Answers

SOURCE: 88 pontiac 6000 shudders and stalls after approx. 30 min. driving

What was replaced in the tune up? Usually the coil paks cause these types of issues. Also fuel filter or fuel pump will allow enough fuel to start and sputter like you describe.

Posted on Jun 16, 2009

  • 50 Answers

SOURCE: I have a 2002 dodge neon. It wont shift into gear.

if it has a manual transmission your clutch has gone bad and needs to be replaced

Posted on Oct 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 jeep wrangler 2.5 starts up and will run all day but when driving its starting to stall when in 2-3 gear.. after it stalls its starts right back up n runs fine but still stalls if in gas so much or to...


1990 2.5L 4 banger. (just sold mine a 2002) I have 3.8L now. 2008
what transmission mine was 5speed manual stick , is yours?

ever do the 60,000 mile tune up, all service points under that column?
tune ups do work and have pay back in fuel savings.
" if in gas so much" i cant noodle that.....????
stall when , when you lift throttle and push in clutch.
when it stalls is everything !!
and when, coming to a stop light??????
and last and very important, can a fast right foot save the stall..?
i only have questions, and need all answers above, to proceed.
we can fix it. but i cant drive it and see all this.

Jan 24, 2014 | Jeep Wrangler Cars & Trucks

1 Answer

1992 olds cutlass supreme wont accelerate when pushing the gas pedal


Check oil first, Low oil sensor will shut down if more than a quart low. Change fuel filter, could be fuel starvation, change the air filter. stopped up air filter will put MAF sensor out of range. PERFORM OBDII SCAN SOON.

May 19, 2017 | 1992 Oldsmobile Cutlass Supreme

2 Answers

1999 mazda 626 lx engine stalls when put in any gear


It can be low fuel pressure issue or clogged fuel pump. Or its engine related issues,---------------
Check the help link mentioned below to troubleshoot the problem: ------

Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,
http://alltypesofpartsreplacing.blogspot.com/2012/12/engine-stallscar-stalls-while.html

------
These will help.
Thanks.

Dec 17, 2012 | 1999 Mazda 626

1 Answer

I was driving then temp. gauge went hot and it stalled checked by coolant fine now it starts but when you put in gear it goes 10 feet then stalls and wont restart for about 20 min.


Check if the fan turns on a few minutes after a cold start. It may be a problem with the fuse or the relay. Check if you loose coolant, there may be a leak somewhere, the hose, bad fuel pump, radiator leaks or a bad radiator cap.

Apr 26, 2011 | 1994 Dodge Intrepid

2 Answers

As you've probably heard before my 91 cav starts fine gets warm stalls at lights starts right back up but cuts off when i put it in gear


pull off the transmission transition switch wire pluged on to tranny
start car drive should be fine never hook op again 0 money
or pay 700 dollars to install a new one
or buy switch pull tranny and install your self

Jul 14, 2010 | 1991 Chevrolet Cavalier

2 Answers

Stalls when warm 95 camry


sound like your have the bad distributor, when you have trouble starting remove the distributor and have the auto part check it.

Nov 23, 2009 | 1995 Toyota Camry

1 Answer

91 camry starts and shuts off when put in drive or reverse


I was an ASE master auto tech for 13yrs and have seen this problem before. It sounds like the idle air control valve on the intake manifold has stopped working and the idle speed is not being controlled(letting the engine idle too slow which causes a stall when put under a load such as putting it in gear). Try giving it a little throttle while putting it in gear if that works let off the throttle if it dies you will know the Idle Air controll is not working.

Oct 12, 2008 | 1991 Toyota Camry

1 Answer

Car wont start. it would turn on at times, but did not seem to turn over as quickly


i have a 1992 isuzu rodeo its 12 deg. out -5 with wind chill truck would not start today played with batt.termanal and started went 1 mile or less to bank and stalled turns over fast but will not restart went back 5 hours later started right up got back home less 1 mile stalled in drive way and wont start.........help

Jul 31, 2008 | 1992 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...