Question about 2001 Volkswagen Cabrio

1 Answer

Where is the crank shaft positioning sensor on a 2001 vw cabrio

Iced the computer with no success.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Volkswagen Master
  • 733 Answers

NEED ENGINE CODE !!!!!!

Posted on Apr 01, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 dodge intrepid .sometimes will crank and then won't .changed crank sensor,cam sensor, fuelpump and computer.any ideas


it is cranking ( turning over ) but not starting
check the cam shaft position sensor wires . immobilizer operation

Apr 16, 2017 | Dodge Cars & Trucks

1 Answer

2001 vw cabrio start turn over


uh if it will turnover but not start is there gas in it? check the timing...the neutral switch and the crank sensor,

Oct 17, 2014 | 2001 Volkswagen Cabrio

1 Answer

On a 2001 vw cabrio,where is the cooling fan sensor?


The fans are controlled by a temp sensor that is screwed into the radiator. It is located on the bottom of the radiator, driver side. There will be an electrical connector with I believe 4 wires attached to it. This sensor controls both low and high fan speeds.

Oct 13, 2014 | 2001 Volkswagen Cabrio

1 Answer

My VW Passat wont start it cranks over has fuel at the fuel rail but no spark I removed a spark plug lead and placed a plug on it shorting the plug to earth cranked the engine over and not spark for a


check that the cam shaft is turning ( broken timing belt/chain will not allow position sensors to give spark). Check that the immobiliser is operational. have the fault codes read

Oct 05, 2014 | 2001 Volkswagen Passat

1 Answer

2001 vw cabrio ignition system sensor


Mass air low sensors can be cleaned. If a new one was installed you should be ok as far as metering the air, sensor has very sensitive and fragile wires, and should only be cleaned by mass air flow sensor cleaner. Unless they left it unplugged, or the computer is not picking up signal from one dead out of the box. The all points check may have dislodged a vacuum line. But if you are at the dealer, they need to be answering your questions, after that 4K tune-up.

Nov 27, 2013 | 2001 Volkswagen Cabrio

1 Answer

Where is the trottle position sensor for 01 vw cabrio glx


it is located right on the throttlebody intake right at the butterfly valve usually on the firewall side

Oct 06, 2012 | 2001 Volkswagen Cabrio

1 Answer

2001 vw cabrio radiator fan doesnt turn on


You should be able to jumper the relay to make the fan run. If you do that and the fan does not run, expect to find a bad fan motor.
If you jumper the relay and the fan runs, and the relay is good, the problem is in the computer or wiring to the sensor.

Sep 13, 2012 | 2001 Volkswagen Cabrio

1 Answer

Where is the crankshaft positioning sensor located on VW Cabrio 2.0L engine?


The crank positioning sensor is located on the transmission ,the bell housing on the left side of the engine block above the oil pan

Apr 26, 2011 | 1998 Volkswagen Cabrio

1 Answer

Where can i find the crank sensor in a VW 2001 V6 2.8L


Hi. The crankshaft position sensor is located on the intake sector of the engine block, near the flywheel.This will be on the AAA engine build.

On the ABA build, The crankshaft position sensor is mounted on the side of the engine block, near the crank pulley.

Apr 22, 2010 | 2001 Volkswagen Jetta TDI

1 Answer

Where is the camshaft position sensor on 2001 VW Cabrio?


try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 2001 Volkswagen Cabrio

Not finding what you are looking for?
2001 Volkswagen Cabrio Logo

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...